Question about 2004 Citroen Berlingo 1.9

Open Question

Battery light on & blower not working

Battery lightstaying on and fan heater not working.

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1977 Buick blower / fan comes on however NO heat blower / fan also blows very low.


Buick LeSabre Heater - RepairPal

repairpal.com > Problems > Buick > LeSabre
Buick LeSabre Heater blows only cool air...even w/ defroster on. This is a ... Heater fandoesn't come on . ... The blower works but there is no heat coming out.

Blower Motor Problems ' Auto Repair Help - YouTube

? 4:22
https://www.youtube.com/watch?v=2vmfxYg8LoY
Sep 27, 2009 - Uploaded by mgittelman
The blower motor is a common heater/AC repair within the skill level of ... However if the power wire is a single light purple wire and the ... for blower motor and fuel and relay good but no powercoming on both any ideas? ... my o5 seira, when i start the engine with the air switch on it blows my blower fan ...

Car Air Not Blowing, Heat & Air "How to" Test Testing ...

? 6:22
https://www.youtube.com/watch?v=hgar6Q1lV6A
Apr 5, 2013 - Uploaded by Fixbook
Here I show how to determine the problem if your air, or blowermotor is not ... Click here to check out the the "Car Runs on 2 cylinders" series: ... How to Fix Over-Heating engine & No Heat in car - Buick (2000 yr) Park Ave . ... Car fan / AC only works on high - Replacing the Blower Resistor - Duration: 4:24.

Buick Park Avenue Questions - NO HEAT!!! - CarGurus




Jan 30, 2016 | 1977 Buick Electra

1 Answer

I have a 1988 735i and smoke came out the inside vents recently.....fan barely works. Any suggestions??


If it smells sweet -it is coolant

If it just was brief & white is was refrigerant

If the blower works it is not a fuse

The blower motor may be old & worn out & need
replacing & you may have a leaking heater core

Good Luck under the dash

Look at some You Tube Video on R&R of
a heater core

Nov 06, 2014 | Cars & Trucks

2 Answers

Blower fan, is there a fuse for this?


Yes there is but you can use a test light at blower motor. Simple power and ground test. If test is good replace motor. If no ground replace your resistor

Nov 20, 2013 | 2006 Chevrolet HHR

1 Answer

Heater fan not working and a/c light will flash. will blow for a second or two then go off and a/c light will flash


Then chances are these is an obstruction in the blower motor or the motor is worn out. The blinking lights indicate a fault in the system. Let me know which car you have and I can walk you though the replacement/rehab process.
I have had good luck after removing the blower motor hooking it up to a battery charger and putting it on 20 amps and lubing the daylights out of it. Has saved me hundreds!

Sep 16, 2011 | Volvo 960 Cars & Trucks

1 Answer

Headlights are dimmer & heater fan runs slower when its idling. When driving down the road, once in awhile the battery light & brake light come on.


Replace the alternator,it is not charging like it is supposed to.It should read at the battery with the engine running ,and head lights on,and ac on high blower motor setting,13.65 volts,to 14.25 volts,no less.also slow charge the battery to get a deep full charge,cause it will be low .

Jan 13, 2011 | 1997 Mitsubishi Diamante

2 Answers

Fan motor on heater has stopped when I switch between the settings ( defrost to upper & lower heat) I hear the gates moving but the fan won't come on ( no heat ) it's very cold please any sugestions...


first check the heater fuse...then you want to unplug the fan motor lead and run it straight to the battery...if it works then you will need to check the resistor assembly..it is located on the heater housing right near the fan..it controls the different speeds for the fan and usually has 4-6 wires coming off it. If these don't fix the problem...try looking in the fuse/relay box both in the cab and under hood to see if you have a relay for the heater fan...as it may be defective

Jan 08, 2011 | 2001 Jeep Cherokee

1 Answer

How to remove the heater blower fan on 92 chevy 1500


Heater Core - REMOVAL & INSTALLATION
1991-92 R/V and 1991-98 C/K Series
  1. Disconnect the negative battery cable.
  2. Drain the cooling system.
  3. Remove the instrument panel glove compartment.
  4. Tag and unplug all electrical leads as necessary.
  5. Remove the center air distribution duct from the floor.
  6. If necessary, remove the ECM and mounting tray.
  7. Remove the hinge pillar trim panels.
  8. Remove the blower motor cover and then remove the motor.
  9. Remove the steering wheel and tilt back the instrument panel slightly.
  10. Remove the coolant overflow tank. Disengage the heater hoses at the core connections.
  11. Unfasten the attaching screws and nut and then remove the heater case.
  12. Remove the seven screws and lift off the heater case cover.
  13. Remove the fasteners and brackets that hold the heater core to the case and lift the core from the case.
To install:
  1. Install the heater core in the case.
  2. Install the heater case bottom plate. Make sure there is a good seal.
  3. Install the heater case into the truck. Tighten the 4 lower screws to 17 inch lbs. (2 Nm); the upper screw to 97 inch lbs. (11 Nm); and the nuts to 25 inch lbs. (2.8 Nm).
  4. Connect the heater hoses at the core tubes.
  5. Install the coolant overflow tank.
  6. Install the instrument panel and the steering wheel.
  7. Install the blower motor and cover.
  8. Install the trim panels and if removed, the ECM. Install the air distribution duct and reconnect all electrical leads.
  9. Install the glove compartment. Fill the cooling system and connect the battery cable.


Blower Motor - REMOVAL & INSTALLATION
1992-98 Models
(see Figure 4)
  1. Disconnect the negative battery cable.
  2. Remove the right rear quarter panel trim.
  3. Disconnect the electrical lead at the fan.
  4. Remove the screws and if equipped, the cooling tube.
  5. If necessary, remove the fan retaining nut and lift out the blower fan.
  6. Remove the blower motor.
To install:
  1. Install the blower motor and then position the fan.
  2. Install the retaining nut and then tighten the mounting screws to 12 inch lbs. (2 Nm).
  3. If removed, install the cooling tube.
  4. Connect the electrical lead. Install the quarter panel trim cover.
  5. Connect the battery cable.
zjlimited_45.jpg

Fig. 4: Auxiliary heating and A/C system





Hope this helps (remember to rate this answer).

Nov 09, 2010 | 1992 Chevrolet C1500

3 Answers

2003 Suburban heater fan will not working.


three things left to check,
using test light see if you have power at motor with key and switch on,if you do replace motor,if not locate blower motor resistor it will be close to motor,check for power going in,last is the heater control assembly

Dec 10, 2009 | 2003 Chevrolet Suburban 1500

1 Answer

Fuel gage turn signals and heater (fan) won't work.


Reversing polarity at the battery is a very bad thing and can cause a host of unpredictable problems. You are lucky that you didn't fry the alternator diodes (the battery is charging, I hope). Each of the problems you describe will have to be treated separately. 1. try replacing the turn signal fuse and flasher unit. 2. fuel gauge has a delicate resistor... probably the easiest fix is to replace the instrument cluster. 3. Heater blower fan has a resistor pack for different fan speeds, this may be replaceable, otherwise a new blower assembly may be the best way to fix it. Hope this helps

Mar 19, 2009 | 1991 Nissan Pickup

Not finding what you are looking for?
2004 Citroen Berlingo 1.9 Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Citroen Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14363 Answers

Are you a Citroen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...