Question about Cars & Trucks

1 Answer

My 2.6 litre holden rodeo engine jerks and coughs and splatters as im driving through all the gears. ive replaced the sprak plugs and leads, the distributor cap and rotor button and also the fuel fillter. its as if the fuel ising geting to the engine under load. any idea what it could be and how to fix it

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 69 Answers

Check the fuel pump if it is maintaining fuel pressure.

Posted on Feb 13, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

stephanos18
  • 144 Answers

SOURCE: Replacement of Spark Plug leads, Distributor cap, rotor for T100

I reccommend putting WD40 or CRC on the connections to stop them corroding over time. You also want to make sure the Distributor Cap gasket seals well to keep out water. last make sure you don't get the leads mixed up, best to replace them one at a time. cheers

Posted on May 17, 2009

buffalonyman
  • 1865 Answers

SOURCE: im not getting spark to my spark plugs

Remove the distributor cap, so that the rotor is visible. Have an assistant turn the ignition to crank the engine over. If the rotor does not turn when the engine is cranking, then you need a timing belt or chain.

If the rotor does turn, then replace the coil.

Posted on Jun 15, 2009

  • 1608 Answers

SOURCE: engine miss,replaced fuel

Do a compression test and make sure it is not a mechanical problem.Could be burnt valve,bad cam,or broken valve spring.If you know which cylinder is missing pull the valve cover and check the valves and see if they are all moving up and down evenly when you turn the motor over.Just disable the vehicle from starting or you can do it with it running.Hope this helps.Good luck.

Posted on Feb 18, 2010

  • 90 Answers

SOURCE: my 94 geo prizm sputters and jerks during

for that cost you could have taken it to a mechanic and had the compretion tested, that is what needs to be done. at least 90psi and all cyliders sould be within 15% to that.

Posted on Mar 16, 2010

csmock132
  • 4669 Answers

SOURCE: 1992 Siera k1500 4x4 Replaced rotor, distributor

Have you checked fuel pressure? 12 psi?

Posted on Jun 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My Chery tiggo 1.6tx 2010 model is jerking while I driving


It depends on how violent the jerking is? Could be as simple as a plug &/or lead breaking down or as complicated as a fuel delivery problem. Sorry not much help, but I don't have much to go on..

Dec 16, 2016 | Cars & Trucks

1 Answer

2005 holden rodeo RA DX 2.4L ute recent power loss when driving, over revs when changing gears would i need a new clutch installed or cable tightened?


is this a stick shifted car?
the clutch slip is easy to detect, (m/t) the rpm rises, and speed not. (ive burned up many a clutch racing, so know them, and fixed them all self)
yes, adjust the clutch free play , if cable system it gets way off
as you drive, tighter and can cause slip as free play passes ZERO.

Jan 09, 2015 | Holden Cars & Trucks

1 Answer

Is it possible to fit a manual gear box to an automatic 1996 2.6 petrol holden rodeo?


You should be good as long as you replace the flywheel on the automatic engine with the one from the manual. You may also have to replace some sensors once you get it up and running because a manual will drive different that the auto and your pollution control will likely act up by turning on codes.

Sep 01, 2014 | Cars & Trucks

1 Answer

How many litres of fluid will fill a 1991 holden rodeo transmission?


General advice:Relative
Manual transmission back dif 1,5-2l,front (gear box)3-3,5
Automatic:Over 4l.
Yet,u need to confirm with the dipstick (the one availabile or a rigid wire used as deepstick)
U may take note of what comes out before replacing.
Some transmission need to start the engine and run the trans then ceck level again.
I know is a general advice,but u must treat the cars as a innumerous marks/models and deal fine without factory specs.If not,u need owner manual,dealers visit,shop info,etc.
Cheers let others know if u done it.

Oct 27, 2013 | Cars & Trucks

1 Answer

I have a 1999 mazda b2600 it keeps coughing and splattering . I have changed the leads plugs dizzy cap o2 sensor and i bought a second hand air flow meter can anybody please help me out ? Thanks and its a...


egr position sensor aka the dpfe is often the culprit, its mounted on the firewall and has an electric connector and vaccum lines going to it.

Dec 05, 2012 | Cars & Trucks

1 Answer

Holden rodeo 3lt turbo diesel Fault code P0087 fuel rail pressure to low was the best way to correct the problem


2004 holden rodeo 3L ITD. dt P1120. Saying tps fault. Used scan tool to inspect data list an ECU is recieving signal perfect. Goes from 16% to 100%. Double checked TPS output from TPS plug and goes from 0.6v to 4v nice an smoothly. Im suspect on ECU because when i erased code and started engine it revved up to red line by itself but only did once. Any help would be great....

Jan 23, 2012 | 2005 Holden Rodeo

1 Answer

The engine has a cough an surges when u are driving 99 holden jackraoo tdiesel 3.0ltd


The rail oil pressure control valve needs checking on tech 2 to see if its in spec .

Oct 12, 2009 | 1999 Isuzu Rodeo

2 Answers

I have a 1990 holden(isuzu)rodeo 2.8 pertol.Ihave just put some fuel in the thing and about 1 minute down the road experinced some missfiring.this went on for about another 30 seconds and the engine just...


I have a 1996 holden rodeo 2.6 petrol, it misses badly on accelleration, I have replaced plugs, leads, distributor cap, and run injector cleaner through... it idles ok,,,,

Sep 06, 2008 | 1994 Isuzu Rodeo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...