Question about Cars & Trucks

Open Question

My kia Carnival 2004 engages reverse gear but does not engage drive and other forward gears

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Benimur
  • 6966 Answers

SOURCE: cannot engage reverse gear

Hi,

To my understanding this is a common problem with Saab 900s. The cure was to replace the existing linkages with an upgraded one. There was even a recall or service bulletin to this effect.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

Posted on Jun 19, 2008

Ad
Qball_lax
  • 13 Answers

SOURCE: AUDI A4 AUTOMATIC SLOW TO

Not overly familiar with Audis but it sounds like either a.) you have an electronic tranny that has a serious bug or b.) there's a problem in the computer of the car itself. What is sounds like is the car is taking a long time to "understand" that you're telling it to move forward. How new is the car? When you push on the gas before the three minutes, what happens?

Posted on Oct 21, 2008

dr_greg
  • 192 Answers

SOURCE: cannot shift into reverse although forward gears all functional

have ur shift linkage bushings replaced....most likely thse are torn or completely broken .. this is common on these models..also on some vw's of the same years

Posted on Apr 10, 2009

ghost4548
  • 776 Answers

SOURCE: hyundai excel 1996 automatic will engage reverse

It appears you have a Forward Clutch FAILURE. Replace the trans after you get it diagnosed and verified by a professional technician. By the way, do you have a Check Engine light? If so, what is the diagnostic code? The dealership can scan the system and find any codes which may have been stored in the TCM (Transmission Control Module). If there were any 'Incorrect Gear Ratio" codes, it's most probably the trans itself.

Posted on May 28, 2009

hardinfarms
  • 144 Answers

SOURCE: car does not drive forward but works in reverse

Sad to say but your automatic transmission has bit the dust.

Posted on Jul 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

50 horse 4 stwont go into reverse gear due to shaft problems


the drive shaft just drives a pinion gear in the prop box that drives to gears that spin in opposite directions all the time
by selecting forward with the selector rod , a dog gear is moved forward to mesh with one gear that is turning or moves the other way to engage the other gear that is turning
that is the forward or reverse action for the prop
if you have forward but no reverse the it is not a drive shaft problem but a selector rod adjustment that is not moving the dog far enough to engage the running gear

Jul 08, 2017 | Cars & Trucks

2 Answers

Car will start but put it in gear engine will die


engine starts with no problem; but, when I put in gear and ...

www.cargurus.com > Questions > Hyundai > Sonata

CarGurusNov 15, 2012 - The engine just fall dead when you step on the gas; it seems to jerk before ... My car does the same thing but i put it in neutral n it starts up. ... I have a 2004 kia optima it jerks when I go into reverse it was driving ... start and run fine butwhen I put it in drive or any other gear it dies! ... 2002 Hyundai Elantra GT.

Engine stalls when tranny put in Drive or Reverse - Kia Forum

www.kia-forums.com/kia-carnival...2002.../43407-engine-stalls-when-tr...

Feb 28, 2008 - 10 posts - ‎3 authors
Give it a little gas before putting in D or R and it will go. .... When I start the van cold and shift the tranny into drive or reverse.....the whole front ... won't run in forward gears - Kia Forum
10 posts
May 25, 2012
Intriguing problem - engine rough idle & hesitation ...
10 posts
Aug 31, 2011
2006 Kia Spectra engine stalls and bad idle, cleaning the ...
10 posts
Aug 30, 2010
2002 Kia Spectra Won't Go Out of Park - Kia Forum
3 posts
Oct 28, 2008
More results from www.kia-forums.com

Dec 17, 2015 | 2002 Kia Rio

1 Answer

96 ROVER DISC. Has strong reverse - won't engage any forward gears. Fluid seems full even when warm.


Make sure the 4wd shifter is in correct position and hasn't slipped out of correct spot to get you moving forward.

Mar 27, 2013 | 1995 Land Rover Discovery

1 Answer

I have 2005 Chevy Suburban; when you engage the gear in drive the truck would move but won't get out of the first gear. I've checked my transmission fluid and its ok. It also responds to reverse when you...


Common problem probably a 4L60E transmission The low and reverse clutches are the same ones The forward clutches are another set and then there are the 3-4 clutches in another pack. So you probably burn out the forward clutches or could be a stuck valve in the valve body. Time for a transmission specialist.

Feb 02, 2011 | Chevrolet Suburban Cars & Trucks

1 Answer

Car won't engage any gear but reverse.


lincage rod inside the gear box will have bent it happens when to much preasure is applied commen for jamming up thow.

Apr 11, 2010 | 1992 Honda Accord

2 Answers

When engaging in first gear car jerks forward.When


first check gearbox support if they are ok its the cluck plate

Oct 14, 2009 | 2003 Hyundai Tiburon

1 Answer

Car does not drive forward but works in reverse


Sad to say but your automatic transmission has bit the dust.

Jul 24, 2009 | 2004 Chevrolet Cavalier

1 Answer

My 2004 ford ranger xlt 4x4 won't go into any forward gears, only reverse. When it does go in reverse the engagement is hard?


Sounds like the forward clutches and/or low-reverse one-way clutch. Either way it sounds like it's time for an overhaul

Jul 08, 2009 | 2004 Ford Ranger

1 Answer

Reverse gear


it could be that reverse gear has been partially stripped. when we talk gears we are literally talking of mechanical gears. sometimes teeth break off from normal wear and tear, after so many break off the gear has trouble engaging. you will either have to have the transmission rebuilt or have new one installed, hope its under warranty this kind of work can be costly. Most likely this is the problem. If your car is standard transmission it could be your clutch is having trouble engaging, but this would also affect forward gears so it is most likely your reverse gear is missing teeth

Aug 03, 2008 | 2004 Kia Sedona

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...