Question about Ford Cars & Trucks

Open Question

Glow plug light quit comeing on an it will not start

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
Lloyd Six
  • 560 Answers

SOURCE: glow plug light wont come on on my fiat scudo but

Bulb or relay fault.

Posted on Nov 19, 2009

Ad
steve_e_uk
  • 1675 Answers

SOURCE: LIGHT ON DASH FOR GLOW PLUG NO LONGER COMING ON

this sounds like the glow plug relay is u/s or stuck, locate the relay in your fues box and give it a tap or remove it and replace it, it might have just come loose, if this does not work it will need replacing...hope that helps

Posted on Feb 12, 2010

Testimonial: "thanks for the advice looks like the root of the problem waiting on new part/relay cheers much appreciated"

  • 1 Answer

SOURCE: had problems with vw caddy van starting when warm,...

2004 vw 2000sdi caddy van wont start some mornings you need to wind it over before it fires, immediately after it fires you can switch off ignition and it will start first time and continue to start all day. vw dealer says no fault codes present. gloplugs renewed, new battery,fuel problem? Has anyone come accross similar problem I

Posted on Aug 05, 2010

little_shaws
  • 493 Answers

SOURCE: trouble shooting procedure glow plugs '93 VW Golf 1.9 diesel

What you need to do is make sure the key is off, remove glow plugs, hook a set of jumper leads to your battry, put the negative lead around the threaded part of the plug, hold the + jumper lead to the top of the plug where the power rail bolts on. DO NOT TOUCH glow plugs as they will heat up hot & fast. If the light comes on 6 - 8 sec thats how long you need to hold the power on. The tip of the plug should be nice & red hot in this time. Repeat for all plugs & see the diffrence If more than 2 are dead (no red heat) or noticably slower than the others It will be very difficult to start & the plugs should be replaced. AGAIN carefull not to get burned.

Posted on Jun 27, 2012

  • 86 Answers

SOURCE: no glow plug light coming on dashboard

Glow plug relay, or it's fuse?

Posted on Nov 09, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 w/5.9 Cummins. my glow plug light ABS light and brake light comes on and goes off when it wants to when my glow plug light comes on the truck loses power can you help me


Sounds like your ignition switch might be worn and need replaced. It is pretty common for the glow plugs to draw quite a few amps. they just aren't usually on when the truck is running.

Dec 23, 2015 | Dodge Cars & Trucks

1 Answer

Glow plug light comes on then off


The glow plug light comes on to show that the glow plugs are warming up. You should not start the vehicle until the light turns off, as it can damage your glow plugs. The light should turn off after a few seconds while the ignition switch is in the on position. In short the vehicle is working properly.

Nov 11, 2012 | 1992 Ford F250

1 Answer

1983 Chevy Silverado, Glow plug light will not come on, Truck will turn over but not start, fuse panel has no blown fuses, I suspect the Glow Plug Relat but I don't know how to verify it is bad.


With most relays, you have 4 wires. One is power to the component the relay controls, one is a ground to the relay magnet, one is power to the magnet, and the fourth goes to the component, in this case the glow plugs. The ground usually comes from the computer.
With the key on you should have power to two terminals and you would jumper the hot terminal to the glow plug terminal. Or use a test light or meter to check for power on the glow plug circuit.

Sep 19, 2012 | 1983 Chevrolet Silverado

1 Answer

Trouble shooting procedure glow plugs '93 VW Golf 1.9 diesel


What you need to do is make sure the key is off, remove glow plugs, hook a set of jumper leads to your battry, put the negative lead around the threaded part of the plug, hold the + jumper lead to the top of the plug where the power rail bolts on. DO NOT TOUCH glow plugs as they will heat up hot & fast. If the light comes on 6 - 8 sec thats how long you need to hold the power on. The tip of the plug should be nice & red hot in this time. Repeat for all plugs & see the diffrence If more than 2 are dead (no red heat) or noticably slower than the others It will be very difficult to start & the plugs should be replaced. AGAIN carefull not to get burned.

Jun 27, 2012 | 1993 Volkswagen Golf

1 Answer

Glow plug light wont go out


Your diesel vehicle is equipped with glow plugs, and also with a Glow Plug Light that will either come on and stay on, or flash or blink when a fault is detected by the ECU (engine management unit). When the Glow Plug Light comes on, the ECU stores information about the condition that has caused it to come on.4 Jan 2016

Is It Safe to Drive With the Glow Plug Light On? ' YourMechanic Advice

https://www.yourmechanic.com/article/is-it-safe-to-drive-with-the-glow-plug-light-on Glow plug light wont go out Google Search

Oct 25, 2017 | Ford F-250 Cars & Trucks

2 Answers

If i let my 7.3 ford diesil set 4 or 5 hour it hard to start again


A diesel uses glow plugs to fire the fuel when it is first started. If one glow plug quits working the glow plug controler shortens the time that the rest are on. If two its even shorter. If the wait to start light goes off sooner than it used to check the glow plugs.
Glow plugs can be checked easy with a test light.
Unplug a glow plug. (located on the head by the injector).
Just hook up a test light to battery positive (+) and touch the other end to the glow plug connector. If the light lights that one is o.k. Check all 8. Replace any that dont work.
If the glow plug system is working then check for fuel leaks. If fuel can leak out than air can get sucked in the fuel system and cause a hard start.
There is also a transfer pump on the frame rail under the drivers seat. This can be a issue if it fails.
When the key is first turned on this pump will come on and prime the system. You can hear it if you get close to it.
I hope this helps you. Re-post if you need more info.

Feb 14, 2011 | 1988 Ford F 250

1 Answer

The wait to start light want go out and when the motor starts the engine light comes on. But sometimes the wait light gose out and then the engine light will stay out..I got a code.from a down load...


The code P0674 tells you that something in the glow plug circuit is faulty causing the glow plug on cylinder #4 to fail to heat up. The entire circuit must be checked to locate the fault.

Symptoms With just one glow plug failure other than the check engine light coming on, the symptoms will be minimal since the engine will normally start with one bad plug, under freezing conditions you would be more likely to experience hard starting.

Potential Causes The causes for this DTC may include: Faulty cylinder #4 glow plug Open or shorted glow plug circuit Damaged wiring connector Faulty glow plug control module Diagnostic Steps & Possible Solutions You will need a digital volt ohm meter (DVOM) for the complete test.
Continue through the tests until the problem is confirmed. You will also need a basic OBD code scanner to reset the computer and erase the code. Check the cylinder #4 glow plug by disconnecting the wire connector on the plug. Place the DVOM on ohms and place the red lead on the glow plug terminal and the black lead on a good ground. The range is .5 to 2.0 ohms, if it is out of range replace the glow plug.

Feb 26, 2018 | 2007 Chevrolet Silverado 2500HD

1 Answer

By boeinga1 on Nov 17, 2010 2001 VW Diesel Golf TDI. Car started no problem. Drove to gas station. Stopped for gas. glow plug light wouldn't come on, engine wouldn't start, engine turning but not starting....


i think glow plug replacement needed. ever used starting fluid in cold to start?try this, next time no start, cycle your key and let the light come on, wait till it goes off, turn key again until light goes off, if you have to do this more than 3 times, and it runs fine, replace the glow plugs only then. thank you for choosing fixya.com!

Nov 19, 2010 | 2001 Volkswagen Golf

1 Answer

Car won't start because the glow plugs aren't glowing


Does the glow light come on? Check for power with a test light on the glow plugs.

Apr 08, 2009 | Mercedes-Benz 300-Class Cars & Trucks

2 Answers

Wait to start light not coming on and now will not warm by plug


change the relay /timer unit ,after checking the big fuses,cant tell you where unit is as never seen ford 250 ,not common here in spain .

Nov 17, 2008 | 1991 Ford F250

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

fordexpert

Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...