Question about 2004 Toyota Solara

1 Answer

How to replace the front turn signal bulb on a 2004 toyota solara

How do you get to the front turn signal bulb to replace it?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

  • Contributor
  • 41 Answers

Behind it by head light under hood gotta reach hand in there may have to remove few things to get to it. Need help firrcrkr24@yahoo.com let me know:)

Posted on Oct 21, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: front grill on toyota solara

That is correct - it worked for me - now the questions is - How do I remove the old logo ?

Posted on Apr 25, 2009

  • 1 Answer

SOURCE: Remove and Replace Turn Indicator Bulb

Resolved! I finally just put the bulb in the palm of my hand and put my fingers on the plastic socket (which I had given the quarter turn to release from the housing) and gave it some good firm pressure and it snapped/locked into place.

Posted on May 24, 2009

  • 186 Answers

SOURCE: 2001 Toyota Avalon - Rear signals

Check the front lights. Usually if i flashes fast it indicate a bulb is out on that side.

Posted on Aug 02, 2009

  • 563 Answers

SOURCE: How to replace a starter on a toyota solara v6

You take out the battery, and the air-filter housing to give extra working space.
Then push in the starter motor to its place, and hand-tighten all its bolts.
Wrench tighten the starter bolts to the engine 38.ft-lb
Connect the solenoid wire, and tighten to 10.ft-lb
Connect the battery positive cable, and tighten to13.ft-lb.
Replace the air-filter housing.
Replace the battery, and terminals.
Crank-up the car.

Posted on Nov 30, 2009

  • 6 Answers

SOURCE: replacing front turn signal light bulb on 2006

You have to crawl under the car to get this done. Identify the location of the bulb then crawl underneath and locate the appropriate connector. Grab the connector with your hand and twist the connector right-to-left. The connector will then disengage from the plastic housing and you can withdraw the connector and the bulb from the housing. Once disconnected, grab the bulb with one hand and the connector with the other, and pull out the bulb straight out (no twisting). Replace is the reverse. Easy. Should take less than 1 minute.

Posted on Jun 27, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Front turn signal replacement


the blinker moduel
or the combo switch assembly.

or the lamps. you said front and car has 4 corners.
why not post symptoms.?
and if combo?
read the FSM.
ill list the 1st step so it dont kill you. (think shot gun shell there)
1: disable the air bags. FIRST. using FSM method !!!!

Feb 13, 2014 | 2004 Toyota Camry Solara

1 Answer

2007 toyota solara high beam doesn't work, fuses, bulbs and low beam are fine. Could it be a defective switch or sensor?


Hi, the likely problem is the combination switch/wand. The part costs $83 at autozone, but you may want to shop around. Instructions are pasted below the diagram. Please let me know if you have questions, and thanks for using FixYa.

jturcotte_627.gif


Removal & Installation

  1. Remove 3 screws and steering column cover
  2. Disconnect the connector.
  3. Release the claw and pull out the turn signal switch assembly.

    jturcotte_628.gif

Fig. Removal and installation of the turn signal switch



To install:

  1. Install the switch assembly.
  2. Connect the electrical connection.
  3. Replace the three screws in the steering column cover.

Dec 27, 2010 | 2001 Toyota Camry Solara

2 Answers

When putting on the left or right turn signal or flashers the two front lights do not flash. Also noticed that as the rear flash, it is faster than normal.


sounds like a bad bulb or flasher...
If the light outside light up , but do not flash.... then plink the flasher ( round silver bulb in the fuse box) with a finger and see if they start working...

Sep 24, 2010 | 2004 Toyota 4Runner

1 Answer

How do you change a front signal bulb on a 2004 accord


Front turn signal bulb replacement

1. Remove the inner fender
2. Disconnect the 3p connector from the front turn signal/side marker light.
3. Turn the bub socket ( 45 degree ), counterclockwise to remove the bulb.
4. Install a new bulb in the reverse order of removal.

Apr 12, 2010 | 2004 Honda Accord

1 Answer

Problem with my 2002 toyota Solara


check to see if a fuse is blown under the hood as well as under the dash

Apr 04, 2010 | 2002 Toyota Camry Solara

1 Answer

How do I remove the front headlight bulb in my 1999 Toyota Solara?


I am no expert, that being said, I went to the auto part store with my manual and got the bulb needed for low beam lighting. Seeing what it looked like helped greatly. HOWEVER, when I went to replace it, it didn't require a new bulb, it just came loose and needed jiggling. My 2003 Solara, the holder/bracket piece that holds the bulb is red, the light pops in that socket. I would have never known this if not for the auto part guy showing me under the hood. Good luck.

Jan 06, 2010 | 2004 Toyota Solara

1 Answer

How to change 4 runner front blinker light. there's a phillips screw under the hood I have removed but there is another fastener in the lower portion of the blinker housing I cannot locate.


Remove or disconnect the following:
  • Connector
  • Screw
  • Claw fitting
  • Front turn signal lamp assembly
  • Front turn signal lamp plug assembly
  • Front turn signal lamp bulb as shown
6191f4c.gif
c741133.gif
To Install:
  1. Install or connect the following:
    • Front turn signal lamp bulb
    • Front turn signal lamp plug assembly
    • Front turn signal lamp assembly with screw
    • Connector

Oct 01, 2009 | 2004 Toyota 4Runner

Not finding what you are looking for?
2004 Toyota Solara Logo

94 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8743 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...