Question about Nissan 200SX

Open Question

1997 Nissan 200sx. When I am driving it the right front wheel will **** and vibrate. It only happens periodically but when it does the car vibrates and it feels like the wheel is going to seize or come off. I've checked the tie rods, sway bar, cvg joint etc. but all seems to be ok and tight. I'll be driving along and suddenly it jerks and vibrates for a short time then starts again.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 132 Answers

SOURCE: how do i go about

The is no adjustment to make them titer, just change the legnth of them for the alignment, find the loose one and replace it

Posted on Jul 30, 2008

  • 15 Answers

SOURCE: Front End noise and vibration

Check the U-joints and axle baerings. But its most likely because the truck is in four wheel drive.

Posted on Oct 22, 2008

  • 1118 Answers

SOURCE: 2004 camry, vibration right front

If the wheel is in balance and there is no other signs of what is causing the vibration than yes that cv joint should be chk. Is the strut ok? might want to chk. that too.

Posted on May 31, 2009

redbeard00
  • 957 Answers

SOURCE: Car jerks to left w/no warning

My opinion, not a good car. But that is a different story. It would be easiest to bring the car in for an alignment. The technician will tell you what the car needs to do the alignment. But if you want to do it yourself then you will need to inspect all the steering componants (tie-rods,struts, lower ball joint, wheel bearings, brakes, wheels, tire wear,tread pattern, and tire pressure, and lug nuts (loose or overtightened). Good luck.

Posted on Jun 01, 2009

  • 11 Answers

SOURCE: steering wheel vibration

Did they "turn" your rotors? They may have "improperly" turned your front rotors. This is common and they should correct this where you had the work done.

Posted on Oct 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replaced both front wheel brg/hub assy's on a 09 Nissan Murano but I still have a rotational growl sound coming from the front end. vibration felt thru front floors on drvr&psngr sides? Any ideas?


possible problem cv joints or drive shafts
check with a drive line specialist shop as some manufacturers fit a balance to the shafts to stop vibration
have them check the cv joints while you are there

Mar 22, 2017 | 2009 Nissan Murano

1 Answer

1997 Nissan 200sx. Wheel vibration


jack the car up and give the see if the wheel has any movement left to right or top to bottom. If there is no movememnt then your cv joint is ok and tie rod is good. is the a noise when you make a tight turn left or right , it maybe a wheel bearing. Also you have checked the nuts on the wheel itself are all tight?

Jul 19, 2017 | Nissan 200SX Cars & Trucks

1 Answer

1988 Nissan 200sx: The speedometer, techometer, and odometer do not work at all. What are the possible problems and how much would it cost to repair them personally?


This is a common problem. All of these work from a printed circuit board. With vibration and age they will eventually get a short in the board. No one repairs them just replace the instrument cluster. Requires removing the front of the dash to remove it.

Jul 04, 2009 | 1988 Nissan 200SX

1 Answer

Nasty vibration on the floor under the gas pedal


check the drive shaft between the intermediate transmission and the front transmission for miss alignement and defectivness of the telescopics system of this shaft. we had about the same problem on our 1996 same model...

Feb 25, 2009 | 1995 Nissan Pathfinder

1 Answer

Loud intermittent vibration in 1997 Toyota Land Cruiser


100 series landcruiser auto 98 model 226000 km
whine from front end after 25 kmh no noise when backing off

Nov 23, 2008 | 1997 Toyota Land Cruiser

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...