Question about Volkswagen Jetta

Open Question

2006 VW Jetta fault code P0671 - Jetta Volkswagen Cars & Trucks

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: checking the fault codes

Yes.  Next to the ash tray there is a black slide off plate that reveals the OBD I plug.  {1996 and newer can be read with an OBD II reader (read for free at Advance auto or Auto Zone)}  Once you reveal this plug on the 1995, you can plug in a single jumper wire (or even a paper clip) in the #4 and #15 pin hole.  There are two rows of pin holes, count from the upper right to the #4, then on to #15 (which will be the second to last pin hole).  Turn the ignition switch on (motor not running), insert the jumper wire for about 3 to 5 seconds, then remove the wire.  The ENGINE LIGHT will flash a hold, then the code, which will go something like this, flash, flash, PAUSE, flash, flash, PAUSE, flash, PAUSE, flash, flash, flash, flash.  Then it will repeat the codes if you just sit there and observe it.  The code in my example would be a 2214 code.
Below are some code I found on a website.  I hope this helps.  Now I ask that you take the time to answer someone elses question.  Lets all share.  Good luck, "Peace through power and knowledge"

CODE FAULT
0000 End of fault sequence
1111 Bad ground to Electronic Control Unit (ECU) or ECU failure-check grounds or replace
ECU
1119 Transmission Range - Defective wiring. Check for break or short.
1213 Vehicle Speed Sensor (VSS) - Check transmission speed sender wiring and the wiring of
the instrument cluster
1231 Vehicle Speed Sensor (VSS) (G54) - Check transmission speed sender wiring and the
wiring of the instrument cluster
1232 Throttle Position Actuator - Check defective actuator or wiring for break or short.
2111 Engine speed sender. (RPM)
2112 Ignition reference sender
2113 Hall sender - No speed signal from distributor; check Hall sensor and circuits or the
Air-flow sensor plate is not moving freely; adjust potentiometer or lever.
2114 Hall sender not on reference point or distributor out of position.
2121 Idle switch - check switch & circuit.
2122 Hall sender - Check wiring for break or short.
2123 Full throttle switch; check switch & circuit.
2132 Electronic Control Module (ECM) - No ignition to injection signal.
2141 Knock sensor 1 control at maximum ****** - test compression, change octane, adjust
timing, check knock-sensor wires.
2142 Knock sensor 1 signal - Test sensor, check wiring for break or short.
2143 Knock sensor 2 control at maximum ****** - test compression, change octane, adjust
timing, check knock-sensor wires.
2144 Knock sensor 2 signal; test sensor.
2212 Throttle Potentiometer - Value out of range.
2214 RPM Signal - Idle speed to high or engine over-revved
2221 Vacuum Control - No vacuum to control unit. Check for leaks.
2222 Manifold Vacuum - Check vacuum line and wastegate for leaks.
Pressure sensor - Sensor defective
2223 Altitude Sensor - Check sensor, check wiring for break or short.
2224 Turbo/Manifold pressure - Check turbo control wiring, check for over boost, air leak,
defective wastegate valve, vacuum leak or defective pressure sensor.
2231 Idle-speed stabilizer adjustment limits exceeded; too-fast idle. Adjust throttle for full
closing, check for vacuum leak, check ignition timing.
Or
Air Mass Sensor - Check sensor and wiring.
2232 Air mass/flow sensor - No signal. Check wiring for break or short.
2233 Air mass/flow sensor reference voltage open or short circuit
2234 ECM Supply voltage low.
2242 CO-potentiometer voltage low
2312 Coolant temperature sensor - Check wiring, check resistance.
2314 Transmission to Engine control module circuit. - Check wires for breaks or shorts.
2322 Intake Air Temperature Sensor - Check sensor and wiring.
2323 Mass Airflow Sensor - Check sensor and wiring for breaks.
2324 Mass Airflow Sensor - Check sensor and wiring for breaks or shorts to B+ or ground or
check for air leak.
2331 Oxygen Sensor Control - Out of range. - Check ignition, air intake for leaks and injectors.
2332 Oxygen Sensor - Bank 2 - Check wiring for breaks or shorts.
2341 Oxygen sensor (O2) at control limit; check CO, lambda-sensor wire, lambda-sensor
control, start valve, evaporative system and check for vacuum leaks.
2342 Oxygen Sensor Control - no signal - Check wiring, sensor.
2343 Rich limit; the pressure regulator has exceeded +10 mA for more than 5 minutes,
closed-loop; check for vacuum leaks.
2344 Lean limit; the pressure actuator has exceeded -5mA for more than 5 minutes, closed
loop; check idle.
2411 EGR System Malfunction
2412 Intake Air Temperature Sensor - Check sensor and wiring for breaks or shorts
2413 Mixture Control - Running rich
Fuel pressure too low
3424 Malfunction Indicator Lamp (MIL) failure - Check lamp and wiring.
4311 Secondary Air Injection Pump Relay - Check relay and wiring.
4312 EGR Frequency Valve
4313 Secondary Air Injection Solenoid Valve - Check valve and wiring.
4331 EVAP Carbon Canister Solenoid Purge Valve 2
4332 Ignition Circuit Final Stage - Check for break or short to ground or B+ or bad ECM.
4343 EVAP Carbon Canister Solenoid Purge Valve 1
4411 Fuel Injector Cylinder 1 or 1 & 5
4412 Fuel Injector Cylinder 2 or 2 & 7
4413 Fuel Injector Cylinder 3 or 3 & 6
4414 Fuel Injector Cylinder 4 or 4 & 8
4421 Fuel Injector Cylinder 5
4422 Fuel Injector Cylinder 6
4423 Fuel Injector Cylinder 7
4424 Fuel Injector Cylinder 8
4431 Idle Air Control Valve / Idle Stabilizer - Check valve and wiring.
4433 Fuel Pump Relay
4442 Wastegate - Defective frequency valve or wiring.
Boost pressure circuit - Check for short.
4443 EVAP Canister purge valve.
4444 No fault in system.

Posted on Oct 19, 2008

Ad
  • 11 Answers

SOURCE: 2006 vw jetta tdi service engine light reset

With the key in the ignition (but not turned), press and hold the Odometer Reset Button on the right hand side of the panel. While still holding that button, turn the key (although not far enough to start the engine) and then press and hold the Minute button on the left side of the instrument pane(if pressing doesnt work try turning the knob clockwise until service light has gone off and skip the pressing)l. Release both buttons at the same time.

Posted on May 30, 2009

  • 750 Answers

SOURCE: 2003 vw jetta gl 2.0 have codes p0351,p0352 and p0353

p0351- ignition coil A primary or secondary fault
p0352- ,, ,,,,,, ,,,,, B ,,,,, ,,,,,,, ,,,,,,,,,,,,, ,,,,,
p0353 - ,,,,,,,,,,,,, C,,,,,,,,,,,,,, ,,,, .,,,,,,,,,,,,,,,,
you may have a problem with yuor ingnition system

Posted on Sep 30, 2009

  • 972 Answers

SOURCE: Have a 2006 VW Jetta 2.5. Engine emission warning

you need to pull the codes and go from there

Posted on Mar 20, 2010

  • 1 Answer

SOURCE: 2006 vw jetta No power on drivers door.

I have the same Problem. I Simply cut into the middle of the boot between the door and body The broken wire was right there, I pulled each end out and held the wire there with a pair needle nose pliers, stripped the end with a knife and attach a mulyi-strand jumper between both ends with electrial wire twists. Leave 2" approx. then slip the boot back over them. Use # 14 Wire. A Quick reasonable fix. If brakes again repeat again. The new Haness will have the same Problem down the road.
John

Posted on Apr 07, 2010

Testimonial: "I had the problem fixed at the dealer. It was the harness They made the harness longer & it was free.. "

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 VW Jetta 2.5L transmission flares in 3rd and 5th only when hot..Possible causes?


Hi. valve body fault or more likely a worn band or clutch. Will need and overhaul. If DSG then could be the clutch pack or mechatronics.

Sep 25, 2014 | 2006 Volkswagen Jetta

1 Answer

Vw fault codes


Hello. What are codes P3132 and P3430?

Apr 02, 2014 | 2006 Volkswagen Jetta

1 Answer

2006 VW Jetta 2.5L Cold Start Idle speed Unstable


run fault codes and check for ambient temp sensor and/ or MAP/MAF sensor problems.

Mar 16, 2014 | Cars & Trucks

1 Answer

My 2006 vw jetta tdi lost power and died wont restart am told need code to restart but dont have right code


You will have to have the fault codes read by a code reading machine . That will tell you why the engine stopped. I am suggesting that you check to see if the cam shaft is turning when you try to start it as the timing belt may be broken. Repair/replace items listed by the codes -reset the CPU with the code reader

Jan 08, 2014 | 1998 Volkswagen Jetta

2 Answers

My 2006 vw jetta needs transmission fluid. The manual says I have to take it into a vw dealership however, the closest one is two hours away. Can I add the fluid myself and how?


1. Check and add transmission fluid on a 2006 VW Jetta with manual gearbox:

tdisline_575.jpg
tdisline_579.jpg

2. Check and add transmission fluid on a 2006 VW Jetta with automatic gearbox:

tdisline_580.jpg
tdisline_581.jpg

May 26, 2011 | 2006 Volkswagen Jetta

1 Answer

2006 vw jetta TDI- No power on drivers door. 2006 vw jetta TDI- No power on drivers door. Nothing works power windows, door locks, gas door release, alarm nothing tsvanloenen@bell.net


I might have the solution for your problem. I paid $1,700 to learn it.
I might start a class action against VW
Please call me at 450-346-2617

Dec 18, 2010 | 2006 Volkswagen Jetta

2 Answers

Code p0299 on 06 jetta


check with vw theres a technical service bulletin issued in dec o7 number 0107-70 its for code P0299 on 2006--- 2.0L turbo vw engines

Jan 21, 2010 | 2006 Volkswagen Jetta

1 Answer

2003 vw jetta gl 2.0 have codes p0351,p0352 and p0353


p0351- ignition coil A primary or secondary fault
p0352- ,, ,,,,,, ,,,,, B ,,,,, ,,,,,,, ,,,,,,,,,,,,, ,,,,,
p0353 - ,,,,,,,,,,,,, C,,,,,,,,,,,,,, ,,,, .,,,,,,,,,,,,,,,,
you may have a problem with yuor ingnition system

Sep 30, 2009 | 2003 Volkswagen Jetta TDI

2 Answers

My 2005 vw jetta 2.5 air bag warning light comes on


this year of jetta has a know issue with the air bag connections under both front seats. fault codes for side air bags. check for warranty if those codes are there.

Sep 04, 2009 | 2006 Volkswagen Jetta

2 Answers

The trunklid opens itself after being locked and


known vw fault visit your local vw dealer for repair

Jul 14, 2009 | 2006 Volkswagen Jetta

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76132 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...