Question about Toyota Tacoma

Open Question

Camshaft sensor on a 2010 Jeep Patriot 2.4 liter engine

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
chryslertech
  • 115 Answers

SOURCE: remove the camshaft position sensor from my 1999 jeepcherokee

The Camshaft Position Sensor (CMP) on the 4.7L V - 8 engine is bolted to the front side of the right cylinder head. Disconnect the sensors connector. Take out the bolt that holds the sensor in place. Lightly pry out the sensor being careful not to break it. Clean out the hole and install the new sensor( put a little oil on the new sensors o-ring to help installation).

Posted on Feb 27, 2009

Ad
GM Elec
  • 1000 Answers

SOURCE: 2000 grand jeep cherokee dies while slowing down

Its not unusual for the crankshaft sensor to intermittanly fail. The crank sensors are not real expensive and are not extremely hard to change.
The Crankshaft Position Sensor (CKP) is mounted into the engine block above the starter motor. Engine speed and crankshaft position are provided through the crankshaft position sensor. The sensor generates pulses that are the input sent to the powertrain control module (PCM). The PCM interprets the sensor input to determine the crankshaft position. The PCM then uses this position, along with other inputs, to determine injector sequence and ignition timing. The sensor is a Hall effect device combined with an internal magnet. It is also sensitive to steel within a certain distance from it.
Below is a pic of the sensor location.
Good luck.
Regards,

4732b83.gif

Posted on Jul 23, 2009

mikestoys32
  • 37 Answers

SOURCE: Jeep is giving a code of p0340 which is telling me

go to autozones website they have free diagrams

Posted on Dec 02, 2009

  • 1 Answer

SOURCE: 2002 Jeep Grand Cherokee 4.0L 6 cyl camshaft position sensor

TRANSMISSION SENSOR FOR A GRAND CHEORKEE 2002

Posted on Jan 17, 2010

  • 6982 Answers

SOURCE: Where is the camshaft sensor located on my 99 Jeep Grand Cherokee

If you still have a cap rotor and ignition wires, it's inside the distributor. If not, it is the part where the distributor used to be (center rear of the engine behind the intake manifold)

Posted on Feb 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Quand changer timing belt sur jeep patriot 2008?


OMG , my translator says this is
Frechlish,
french
Quand changer = "when to chaNGE' ok
that was fun to decode.
are you in France?
We here in usa have like 3 engines
and there, 5 and diesels, one can say EU is
diesel city,no?
all our jeeps usa (but 2.4L)are chains or gears.
all of our belts are 60km miles or 100kmetes.
if we use GATEs belts or real JEEP
fleabay belts, china junk? "funny names" way less.

so take the tests:
1; where are you, country not IP address
2: gas or diesel
3; size engine, in liters,

or use real name for engine, jeep'

my guess, NO BELT ON THE CAMS
there in Europe, gas (petrol engine)
if diesel, nows that time to say.

34ee2783-f49e-4df1-89c7-9e6b54ec9c73.jpg

Feb 20, 2017 | 2008 Jeep Patriot

1 Answer

2010 jeep patriot rear wheelbearing replacement how to change


Id go here first. on such a car. log in and READ. its there.

http://www.eautorepair.net/Marketing/Default.asp
are you doing all this work?
do you have the manual?
do you have all the tools stated in the factory manual to do this>?
or are you just the messenger?
the book is here.
MK Patriot. (its GS Mitsubishi platform and 1/2 jeep)
USA book. (not a fake/clone book) read factory book on CD

https://www.techauthority.com/en-us/products/?year=2010&model=599&type=4


Dec 18, 2016 | 2010 Jeep Patriot

2 Answers

My 2010 jeep patriot with a 2.4 is surging when u accelerate from a stop.


Could be any one of a number of sensors for engine control . Mass air flow sensor , TPS - throttle position sensor, or APP- accerator pedal position sensor etc... Without testing an looking at scan tool data ,who could say for sure . How does the vehicle idle ? how does the vehicle run at cruise speeds ? Does the vehicle have electronic throttle control ? 2010 - i'm sure it probably does . Is the check engine light lit ? Your best bet would be to take it to a qualified repair shop.

May 31, 2016 | 2010 Jeep Patriot 2.4

1 Answer

How do i locate the electronic throttle on the 2010 jeep patriot sport


it's a system, not a single part,
it has the form of this , throttle by wire, (google that and read)

2 throttle pedal, TPS like POT.s (throttle angle)
2 TPS sensors in throttle body (redundant for safety)
1 TV throttle valve motor in the TB.
and the PCM brains. (and software to match)
https://www.youtube.com/watch?v=fXe1p4DAw8A

that was 1st hit, in google.
why not post symptoms first. then ask so we can be on same page.
no? or just curious, why not google it or youtube it?

Mar 26, 2015 | 2010 Jeep Patriot Sport

1 Answer

How do i find a electronic throttle control light for a 2010 patriot


why not say why and not send skilled help on goose chases.

lost the operators guide already?
its there, every light and its meaning.
each lamp , usually says, get it serviced.
so what is there to tell?
if really curious, or DIY with super huge shop of tools
you can read the FSM. and learn the steps there for diagnosis
mine is 7000 pages long. shop manual.
https://www.techauthority.com/en-US/Pages/Home.aspx

or alldata.com (15 bucks)


here is your lost guide.
posted over 100 times this forum. alone.

http://justgivemethedamnmanual.com/jeep/2010-jeep-patriot-owners-manual


and here

http://www.jeep.com/en/owners/manuals/


Mar 26, 2015 | 2010 Jeep Patriot

1 Answer

Where is the starting motor located on a 2010 jeep patriot


on the engine
on one side of the other. did you even look?
it can only be 2 places, left side or right near fly wheel it engages.

what engine, ?
i can tell you never looked, see why?
its at the end of the battery PLUS cable.
ill toss coin, 3.7L
then i go to jeep.com (amazing huh, they sell parts?)

ID #1 off jeep page, seen at all dealers USA

http://www.factorychryslerparts.com/showAssembly.aspx?ukey_product=4307940&ukey_assembly=577326

easy peasy,
or next time, learn what engine you have, and then google for that name and see 1000s of photos of engine.

Mar 21, 2015 | 2010 Jeep Patriot

1 Answer

Where is fuse box for lighter in a 2010 Jeep Patriot?


In the engine compartment next to the air breather. Number 13 fuse.

Feb 10, 2015 | 2010 Jeep Patriot

1 Answer

What does c121c mean?


C121C- Torque request signal denied....Do you have any drivability symptoms or other codes? Camshaft sensor failures are common on this engine.

Aug 19, 2014 | 2008 Jeep Patriot

1 Answer

CODE P000B


what engine, I cant guess. or VIN.
you have VVT (var. valve timing, feature)
if yes, dont drive it.
it means the cam and crank are out of sync.
belt engines, need new belt.
chain engines, new chain and may be guides.
P000B-Bank 1 Camshaft 2 Position Slow Response fsm stated causalities:
Possible Causes INTERMITTENT DTC ENGINE OIL DIRTY OR CONTAMINATED INCORRECT ENGINE OIL VISCOSITY (K343) FUSED MAIN RELAY OUTPUT CIRCUIT HIGH RESISTANCE (K276) CMP 1/2 CONTROL CIRCUIT HIGH RESISTANCE CAMSHAFT 1/2 POSITION SOLENOID CAMSHAFT PHASER

Sep 28, 2013 | 2007 Jeep Patriot Sport

2 Answers

Need to change camshaft position sensor 2007 Jeep compass 2.4 eng


Jeep Patriot Crankshaft Position Sensor replacement ...

? 9:09
https://www.youtube.com/watch?v=omwDHaBGUEc
Jan 15, 2012 - Uploaded by JasonthePCMD
Here's how to replace the Crankshaft Position Sensor (CKP) on a 2008 and newer Jeep Patriot, Compass ...

Jeep Cherokee camshaft crankshaft sensor how to replace ...

? 2:59
https://www.youtube.com/watch?v=oOc1Lxod2x8
May 17, 2012 - Uploaded by unpescad0
How to locate and install a new camshaft and or a crankshaft position sensor. This vehicle is a 2001 Jeep ...

Crankshaft position sensor location - Jeep Patrio



Sep 14, 2009 | 1996 Dodge Caravan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...