Question about 1989 Chevrolet Astro Cargo
Blower motor will not work< the motor have been replaced and it does get power, and the springs in the resistor are all still good.
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
there is no relay for the heater fan it's a 15 amp fuse and is on the accessories circuit. the reostat is responsible for all 3 speeds .with the key off there should be no voltage to the blower motor whether the fans speed fan switch is on or off. the fuse will be located in the fuse paneleither on the drivers left side in the dash or underneath the dash in the fuse block. you have a short in the harness that is under the dash and most likely it's a bad plug on the harness. your going to have to do some searching but that's where the problem short is... please rate
Posted on Oct 04, 2008
No the motor is not bad or going bad, the heater blower motor resister is bad, thats regulates the blower speeds, its located under dash by heater motor 2 screws hold in heater box with a electrical plug to it.
Posted on Feb 17, 2009
Yes, in high it bypasses the resistor and uses a high blower relay. But I think on 1998 Astro the High relay and the resistor are built together. It should be mounted in the blower box real close to the blower motor.
Posted on Mar 09, 2009
For location and replacement of the BMR. Remove the shroud below the glove box, 2 screws and a snap-pop fitting. Be careful of the courtesy light. Remove the blower moter and disconnect the power harness - - you'll need this extra room to work with. 2 more screws, same size, 7/32, 6.5, 7or 8mm on some, that holds the blower motor resistor in place. This replacement part is less than 40 bones at most parts store. Unplug, replace, re-install, test and you're on your way with about 2 hours of slow paced effort in your own driveway. Typical cost at a garage/dealer - up to $400.
Posted on Mar 19, 2009
Tips for a great answer:
Nov 13, 2015 | Ford Cars & Trucks
Jul 23, 2010 | 1989 Mercedes-Benz 300-Class
May 11, 2010 | 2000 Chevrolet Astro
Mar 25, 2010 | 1989 Chevrolet Astro Cargo
Feb 20, 2010 | 2000 Chevrolet Astro
Sep 11, 2009 | 2000 Chevrolet Astro
Mar 23, 2009 | 1997 Chevrolet Astro
Mar 09, 2009 | 1998 Chevrolet Astro
Feb 27, 2009 | 1998 Chevrolet Astro
Dec 11, 2008 | 1998 Chevrolet Astro
65 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: