Question about 1999 Toyota Land Cruiser

Open Question

Repair rear window vent latch 1999 landcruiser

Air leak at rear side vent windows

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1861 Answers

SOURCE: there is a water leak

Your A/C drain hose may be plugged. If so, the condensate from the A/C box will leak onto the floor, and eventually soak the rear carpet as well. This is a common issue. It is under the glove box, close to the passenger floor. Remove it and make sure that it is open. Alos, always run the A/C in the RECIRC mode.

Water in the trunk can be from a bad trunk seal or poorly sealed taillamp seams

Posted on Sep 08, 2008

Ad
  • 7 Answers

SOURCE: Power Window problem, 1998 Toyota Avalong xls

the window motor basically the set up dat make it go up and down behind the door

Posted on Dec 29, 2008

  • 1861 Answers

SOURCE: 1999 toyota vienta drivers side rear electric window not working

You need to replace the window regulator assembly.
The cables that run the glass up and down have broken inside the regulator.

Hope this helps. A FixYa rating would be greatly apprecited.

Posted on Jan 21, 2009

  • 298 Answers

SOURCE: i cannot get the rear/side window latch to close. any suggestions

Sienna is like Previa... If the rubber seal around the Rt or Left read window is hardened, closing it will feel like this and 'may' break.
Use ArmorAll and hit it a couple 3-4x to soften the rubber seal all the way around (both sides too, front and back) and make the seals supple and pliable again. Should close OK now ;-)

Posted on Mar 26, 2009

Ironfist109
  • 3018 Answers

SOURCE: rear diff leaking on my toyota landcruiser 75 series trayback

  • Get a drain pan and a new cover plate gasket for the rear differential.
  1. Then just remove the bolts from the cover plate and get a gentle tug to get it off.
  2. Clean the old gasket off both the cover plate and the pumpkin itself.
  3. I like to spray a little brake clean to get real clean.
  4. Put the new gasket on and snug all the bolts on in a crisscross pattern.
  5. Fill the the pumpkin with 75W - 90 synthetic gear lube until the fluid just barely seeps out the fill hole.
  6. Plug and check for leaks and your done.

Hope this helps.

Posted on Nov 01, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to install quarter window that flips out on 2003 dodge Dakota. 2 door.right side


REMOVAL

(1) Remove quarter trim panel.

(2) Remove the bolts attaching the latch to the cab


side panel.



(3) Remove the nuts attaching the frame/hinge to

the B-pillar.

(4) Remove the glass from the cab.
(5) If necessary, remove the latch from the glass.

INSTALLATION

(1) If removed, install the latch to the glass.

(2) Center the window glass at the opening, insert

the hinge studs in the B-pillar holes, and install the

nuts.

(3) Attach the latch to the rear side panel with the

bolts. Tighten the bolts with the latch in the lock

position and pushing rearward on the latch.

(4) Test the vent window for water leaks.
(5) Install quarter trim panel.

INSTALLATION

(1) If removed, install the latch to the glass.

(2) Center the window glass at the opening, insert

the hinge studs in the B-pillar holes, and install the

nuts.

(3) Attach the latch to the rear side panel with the

bolts. Tighten the bolts with the latch in the lock

position and pushing rearward on the latch.

(4) Test the vent window for water leaks.
(5) Install quarter trim panel.

Oct 02, 2016 | 2003 Dodge Dakota

1 Answer

Windshield washer fluid is leaking in back on driver's side on 1999 Chevy Blazer


They run Inside , you need to replace the Rubber Line.. It is for the Rear Window Sprayer

Apr 10, 2013 | 1999 Chevrolet Blazer

1 Answer

My electric window on the drivers side and the rear vent window do not operate. Can this be a defective master module on the drivers side door.


It is USUSALLY just the rocker switch in the door there. Water drips on it when window is open during wet weather. This causes the contacts under that switch to corrode. Those are simple an easy to replace. Pop off the inside door panel (screw under the inside door latch handle, 2 or 3 screws under the arm rest - then plastci pop screws all around the sides and bottom. these can just pull out. Then it lifts off the top ledge. turn it and you'll see the switch still attached to the panel. try cleaning - will probably need replacement.

Aug 17, 2010 | 1999 Plymouth Voyager

1 Answer

Passenger window and rear vent window stopped working


YOU PROBABALY MAVE A BROKEN WIRE IN THE HARNESS THAT GOES FROM THE DRIVERS DOOR TO THE INSIDE OF THE VEHICLE

Jul 24, 2009 | 1999 Chrysler Town & Country

1 Answer

2001 Odyssey EX: Left vent won't open


the right side power windows aren't working the left rear isn't either, what could be the problem in a 1999 Honda Odyssey

May 05, 2009 | 1999 Honda Odyssey

1 Answer

Rear side windows


This may be just a case of inadvertently hitting the window lock out n th driver door window switch by mistake. Check that first. Here's some background on window operation

Principles of Operation
The driver power window regulator motor is controlled directly by the master window/door lock/unlock switch (and its integrated "auto down" module). Power is supplied to the power window relay and the master window/door lock/unlock switch, and the passenger power window switch when the SEC/timer module grounds the coil side of the power window relay. The SEC/timer module will ground this relay when the ignition is in the ON position and will remain energized for approximately 15 minutes or until the driver or passenger door is opened.
The driver power window regulator motor is a reversible motor that is operated by applying power and ground to the motor leads to lower the window, and then reversing polarity on those leads to raise the window.
The passenger power window regulator motor is controlled directly by the passenger power window switch and can also be controlled by the master window/door lock/unlock switch. Power is supplied to the power window relay and the master window/door lock/unlock switch, and the passenger power window switch when the SEC/timer module grounds the coil side of the power window relay. The SEC/timer module will ground this relay when the ignition is in the ON position and will remain energized for approximately 15 minutes or until the driver or passenger door is opened.
The passenger power window regulator motor is a reversible motor, which is operated by applying power and ground to the motor leads to lower the window, and then reversing polarity on those leads to raise the window.
The power rear quarter glass is also directly controlled by the master window/door lock/unlock switch. The power rear quarter glass power latches also utilize reversible motors. The power rear quarter glass power latches are operated by applying power and ground to the motor leads to open the window, and then reversing polarity on those same leads to close the window.
Symptom Chart Condition Possible Sources Action
  • All windows are inoperative
  • BJB Fuse:
    • F20.
  • Circuit.
  • Power window relay.
  • Front door power window switch.
  • GO to Pinpoint Test A .
  • Single power window is inoperative
  • Front door power window switch.
  • Front door power window regulator.
  • Circuit.
  • Driver door power window switch.
  • GO to Pinpoint Test B .
  • Vent power window is inoperative — quarter window glass power latch
  • Circuit.
  • Quarter window glass switch.
  • Quarter window glass power latch.
  • GO to Pinpoint Test C .
  • The one touch down feature is inoperative
  • Master window regulator and door lock switch.
  • INSTALL a new master window/door lock/unlock switch. REFER to Switch—Master Window Door Lock/Unlock .
  • The back window will not defrost
  • CJB Fuses:
    • F30 (10A).
    • F32 (20A).
    • F34 (20A).
  • BJB Fuse:
    • F27 (45A)
  • Circuit.
  • Heated back window switch.
  • SEC/timer module.
  • Rear window defrost relay.
  • GO to Pinpoint Test D .
  • The back window defrost will not shut off automatically
  • SEC/timer module.
  • Circuit.
  • Rear window defrost relay.
  • GO to Pinpoint Test E .

Jan 28, 2009 | 1999 Mercury Villager

2 Answers

There is a water leak somewhere in my 98 toyota camry that leaks into my passenger side floor. There is no sun roof and no visible leaks from the windows or doors. Any thoughts? A/C leak maybe? water...


I am the original owner of camry xle 1998 with wet floors. In 2000 I had drivers side door seal leaking at welt. Removed old door seal and new weather strip on drivers side installed. The door panel was never wet, but wet at bottom of door where there are drain holes...slowly leaking under carpet.
In 2001 later water again. Coming from overflowing A/C evaporator-drain plugged/ tank full of debris. Removed evaporator, cleaned + drain cleaned.
In 2003, driver door seal against window rotted. Removed door panel and found leak at window belt molding at the mirror joint inside + out. Lots of mold under carpet needed to replace! Made a fuss at dealers for reacurring problem and they replaced the carpet for free.

Sep 07, 2008 | 1999 Toyota Camry

1 Answer

Jaguar xk8 rear quaterlight operation after top is raised manually


I have solved part of problem,, if you use the manual latch key and close the latch, you need to push the wrench all the way counter clockwise and the windows do go up. the latch mechanism has the activation switch in it..need to be fully closed

Jun 06, 2008 | 1999 Jaguar XK8

Not finding what you are looking for?
1999 Toyota Land Cruiser Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8547 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...