Question about 2008 Kia Opirus 3.5

Open Question

Airbag lamp blijft branden - 2008 Kia Opirus 3.5

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Airbag light recently came on? 2004 hyundai tiburon


It should come on when you first start the car, then go off after a few seconds (to show that the lamp is working). If it stays on, you have a problem somewhere in the system. It could be the sensor behind the front bumper, it could be a loose wire or bad connection to the airbag itself. You need to take this to your dealer (or other trusted repair shop) and have it repaired, this is not a do-it-yourself job. If the repairs are not done correctly, it could cause the airbag to deploy when it should not (causing much damage) or not deploy when it should (adding to your injuries in a crash.) The lamp indicates that the airbag will (most likely) not deploy in a collision.

Oct 21, 2010 | 2004 Hyundai Tiburon

1 Answer

Airbag lamp accent-98


Hello. The sensor for one of your airbags has most likely gone bad. The only safe fix is to replace it. Joe

Apr 13, 2010 | Hyundai Motor 1998 Accent

1 Answer

2007 Sienna airbag warning lamp flashing


Certainly check with your Toyota Dealer as the vehicle is hopefully is still under factory warranty at that milage. The Air bag light flashing is certainly cause for concern, and having an airbag set off without impact can be very dangerous and it is best to have a professional working on your airbag issues.

Dec 13, 2009 | 2000 Toyota Sienna

1 Answer

The airbag lamp started flashing after


you will have to take it to a mechanic that can reset the light when charging you may have caused a fault code to come up with low voltage.

Nov 12, 2009 | 1998 Nissan Maxima

1 Answer

Ford 2001 F150 pickup truck beeps approx 5-6 times every 5 minutes. Think i has to do with the airbag.


Yes you are correct, it is an airbag problem./

The Airbag indicator lamp is burnt out, and a flash code is waiting.
Radio shack ( or similar ) should still have the replacement bulb for it.

Once you put it back in, the airbag lamp will flash a code that is a number, t ( ie flash 3 times ) then another number ( ie flash 5 times ). You will need that code for the next step in the diagnoses. Don't be alarmed if you get 10 sets of 3 flashes, that is actually a LFC ( Light Flash Code ) 33


Oct 11, 2009 | 2001 Ford F150 Styleside SuperCrew

1 Answer

Airbag lamp stays on a 98 VW Jetta,


you need diagnostic equipment.
marko

Sep 21, 2009 | 1998 Volkswagen Jetta

2 Answers

Air bag light blinks then syays on


If you mean the passenger airbag light no longer lights up and airbag light on the dash blinks at start-up and then stays on; the read the below and check this site:

www.automotivehelper.com

I went to radio shack cost me $2.99 for 3 bulb packet. But the post below worked. It really didn't that long, pretty easy job. Took longer to find the tools. The first guys idea/fix, the second guy gave pretty good instructions. Just a little more detail: (3) the clips are one each side of the panel; (5) these two screws are on the inside lower part of module, (6) unclip the plastic tabs from the back (where the plug end is) first and it should lift up easily.

-------------
I had this happen on my 98 Ranger.(code 27) My light on the module that turns off the passenger side airbag was burnt out. I went to Radio Shack and bought a 12v light with wires attached and soldered them to the existing light.(didn't even take it out!) It fixed it!! Cost, about $1.50 and 20 minutes of fix time.

Note: If the light by the key switch to turn off the passenger side airbag does not work, it disables the entire airbag system! Hope yours is as easy to fix.

----------

gerg,

Thanks for your post. I have no way to read codes, but I heard the five tone alarm every time I started the vehicle and the passenger air bag off light did not light up. I was skeptical, but tried your advice and it worked.

Parts:
1) 12-volt colored lamp (Radio Shack part: 272-1099)

Tools:
1) socket set
2) philips head screw driver
3) soldering iron

Procedure:
1) remove ash tray from console panel
2) using a socket set, remove 4 hex head screws from console panel
3) pull console panel out of the two clips
4) remove connector from air bag key module in console panel and take console panel to a work bench
5) remove 2 philips head screws to remove the airbag key module
6) carefully unclip the plastic tabs that hold the airbag key module case together
7) remove connector circuit board from air bag key module
8) solder the yellow replacement lamp to the two solder pads for the original lamp on the back side of the circuit board (which wire to which pad does not matter)
9) tie the replacement lamp in place next to the original lamp
10) replace the circuit board in the airbag key module and snap the case back together
11) connect the airbag key module in the truck and start the engine to check that the lamp illuminates and that the alarm does not sound
12) screw the aribag key module back into the console panel
13) snap the console panel back into the truck
14) replace the 4 hex head screws
15) replace the ash tray

Sep 05, 2009 | 2004 Ford Ranger

2 Answers

What is airbag code 27 on 1999 f159


Passenger side airbag deactivation lamp inoperative. You probably have a bad pass. lamp switch located under a/c vent on dash.

Jul 26, 2009 | Ford F-150 Cars & Trucks

1 Answer

1995 chrysler lebaron


Here's what mine says- for a 95 Chysler LeBaron GTC Convertible. I didn't see anything about a fuel pump, but maybe it's connected to something else? I dunno. Good luck. Here's the info at least.
1 HTR-AC 30A, 2 POWER WINDOWS 30A C/B, 3 PWR SEAT, LKS, TOP 30 A C/B, 4-BLANK, 5 BACK-UP LAMPS 20A, 6 TURN SIGNAL 20A, 7 REAR WIPER 20A, 8 ILLUM LAMPS 5A, 9 INTERIOR LAMPS 10A, 11 CIGAR LIGHTER 20A, 12 RS AMO 20A, 13 INTERIOR LAMPS 10A. 14 BOD COMP MESS CTR 5A, 15 SPEED CONTROL 2A, 16 GAUGES AIRBAGS 5A, 17 STOP LAMPS 18 HEAD LAMP RT-LOW 10A, 19 HEATED MIRRORS 5A, 20 AIRBAGS 5A, 21 STOP LAMOS 20A, 22 HORN 20A, 23 RT-TAIL LAMP-EUR 5A, 24 LT-TAIL LAMP EUR 5A, 25 HEAD LAMP LT-HI 10A, 26 HEAD LAMP RT-HI 10A, 27 RADIO 104, 28 FRONT WIPER 20A

Mar 29, 2009 | 1995 Chrysler LeBaron

1 Answer

94 Ford Bronco - SRS Lamp blinking 12


Code 12 is loss of voltage to airbag firing circuit. Start with checking airbag fuse. It should be fuse number 15 for the cluster. It is also the airbag fuse. If the fuse is good then the airbag module might be bad.

Mar 24, 2009 | 1994 Ford Bronco

Not finding what you are looking for?
2008 Kia Opirus 3.5 Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76673 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...