Question about 2000 Mazda 626
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: expansion valve location
raven 1g: Your car doesn't use an expansion valve. It uses a fixed orifice tube which is located in the smaller of the two A/C lines, just before they enter the cabin area of the car.
Just disconnect the line and pull the orifice tube out of the line. Be careful not to break off anything and leave it in the line.
Posted on May 10, 2009
1. Relieve the fuel pressure and disconnect the negative battery cable.
2. If not already removed, depress the clips on each end of the rear seat cushion and remove the cushion.
3. If not already done, detach the electrical connector from the fuel pump/sending unit.
4. Remove the attaching screws from the fuel pump/sending unit access cover and remove the cover.
5. Disconnect the fuel supply and return hoses from the fuel pump/sending unit.
6. Remove the attaching screws and the fuel pump/sending unit from the fuel tank.
7. Detach the sending unit electrical connector, remove the sending unit attaching nuts and remove the sending unit from the fuel pump assembly.
1. Attach the sending unit to the fuel pump assembly and install the nuts. attach the sending unit electrical connector.
2. Install the fuel pump/sending unit into the fuel tank with a new gasket and install the mounting screws.
3. Connect the fuel supply and return lines.
4. Install the access cover and the mounting screws.
5. Attach the sending unit electrical connector.
6. Position the rear seat cushion over the floor, making sure to align the retaining pins with the clips. Push down firmly until the two retaining pins are locked into the rear seat retaining clips.
7. Connect the negative battery cable, start the engine and check for proper system operation and for fuel leaks.
Posted on Jun 13, 2009
The transmission range sensor aka neutral safety switch is located underneath the air filter on top of the transaxle and very easy to access. Replace this part (around $50) and it will solve your problem.
What happens is this, when your tranny warms up, it disperses heat to the sensor switch and if its faulty or worn out, will send faulty relays to the transmissiom computer module (TCM) and makes the transmission shift irratically (OD to 3rd and back while driving at freeway speeds). You tranny is not overheating like most people believe, its the switch. Mechanics are telling alot of people that their tranny needs replaced. Watch Out For These People!! They only want your money!!
Posted on Feb 13, 2010
Tips for a great answer:
Jul 14, 2010 | 1999 Mazda 626
Jun 11, 2010 | 1997 Mazda 626
Jun 08, 2010 | 2000 Mazda 626
Apr 11, 2010 | 2000 Mazda 626
May 10, 2009 | 1999 Mazda 626
Feb 11, 2009 | 1993 Mazda 626
15 people viewed this question
Usually answered in minutes!