Question about 1998 Jeep Cherokee

1 Answer

Cherokee first gear noise

Automatic

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 20,706 Answers

Wow , you told tranny ! like the first time ever here.
my 99 was a M/T 5sp

ever do the 60k mile full flush , id bet its too late
or even check levels using the glove box guide (do not guess procedure or type ATF to use)

here is the FSM
and it has A/T tests.

http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

Posted on Feb 13, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

97 jeep Cherokee makes grinding noise when putting gear and will not move and no gears what could be this problem that


Assuming this is an automatic, the linkage could be caught between gears. This happens when a motor mount is broken and the engine has been punched to high rpms. As the engine rocks over, the linkage comes out of alignment.

Place in Park, Turn the engine off. Open the hood and manually pull the throttle cable wide open as far as it will go. Repeat a few times. While you are there check all three cables as they attach to the throttle bracket. If all is well the next start up should be fine.

Feb 27, 2015 | 1997 Jeep Cherokee

1 Answer

1998 jeep cherokee clattering noise when starting in first gear


Very Hard to say where a Clatter is coming from.
Do you have an Automatic or Manual Transmission?
Does it make a noise when you are turning and it stays in 4WD?

Feb 13, 2014 | 1998 Jeep Cherokee

1 Answer

Was driving my 98 jeep cherokee and the check engine light came on then battery guage went to zero. killed the jeep the it wouldnt start bu heard clicking noise.waited a while and jeep started but when I...


check the fuses make sure none of them blew and if its not that then its proble a bad alternator, witch caused the ripple effect when one thing goes on a newer car no matter how small it will trigger a bunch of random events such as transmission not going into gear, i assume its a automatic i highly dought that the tps went with the low voltage, and if your hearing a clicking noise its either not enough juice going to the starter, or a coil wire popped off

Mar 25, 2013 | 2002 Jeep Grand Cherokee

1 Answer

I have a 4.0 grand cherokee 2000, when shifting reverse gear , it makea a loud sound (TUK). But there is no problem in driving and gear shifting is normal.


Some vehicles with automatic transmissions have enough slop to create this noise normally. If the problem just started or has become increasingly worse, it could be due to worn universal joints. The universal joints couple the drive shaft to the drive axle and the transmission on 2-WD and to the transfer case on 4-WD. Another noise that comes from worn universal joints is a squeeking sound at lower speeds. A vibration could also be noticed with worn universal joints.

Jun 05, 2011 | 2000 Jeep Grand Cherokee

1 Answer

2001 Jeep Grand Cherokee makes a lot of noise when selecting Reverse. Forward gear okay. Now, reverse doesn't work and it sounds like the transmission is coming apart.


Your automatic transmission has an internal low and indirect clutch. The indirect clutch is what's used when your vehicle is in reverse. You might have a heavy jerking when you put it into gear that feels like vehicle got hit by another or loud rattling or chattering in gears. It very well may be coming apart as you think and soon, so I'd recommend taking it to your local transmission shop to inspect and test it and they can give you a more detailed idea of what it would take to fix it. good luck

Jan 07, 2011 | 2001 Jeep Grand Cherokee

1 Answer

2000 Jeep Cherokee Gear Grinding & 4WD Whine sound


Give a try by change your transmission/filters and Transfer case oil.

Oct 27, 2009 | 2000 Jeep Cherokee

1 Answer

1992 Buick Lesabre, V6, Automatic with Air. When


Fit a manual gearbox ,could be cheaper in the long run

Oct 23, 2009 | 2002 Jeep Grand Cherokee

1 Answer

94 jeep grand cherokee laredo V8 5.2l automatic. Drives fine but after 10-15 mins of driving After its parked it makes loud popping noise from the rear. Cant locate where the sound is exactly coming from....


You can check fluid level by removing the rubber plug in the cover. Fluid is full when on level ground, it is just at the edge of the hole (or very close) if you are already getting noises out of there, you can remove the cover and inspect gears for wear or breakage. If you find a large amount of metal debris in the lube it tells you something bad is going on back there. Although rebuildable, it's not a home job...requires exact settings in order to operate properly. You can find good units far cheaper than even a gearset costs in any scrapyard. to match ratio, count the teeth on the ring gear and the pinion gear. the replacement MUST have the exact same number. Before swapping diffs, check all back there to make sure noise is not from somewhere else.

Jun 20, 2009 | 1994 Jeep Grand Cherokee

1 Answer

Cracking noise while turning-is it supposed to be in 4h during normal highway driving


You can use fifth anytime you are going better than 45. Don't use it on steep hills or when you feel the engine laboring. If automatic, generally fourth gear shift is at about 2000 rpm and will stay engaged at 45. Cracking noise generally is dry ball joints (no fittings either) Lube the remainder of the front end components and if it continues that's likely where to look.

May 27, 2009 | 1997 Jeep Cherokee Country

1 Answer

No reverse


the trans needs to come out and be rebuilt

Jan 17, 2009 | 1998 Jeep Cherokee

Not finding what you are looking for?
1998 Jeep Cherokee Logo

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...