Question about 2005 Chrysler Town & Country

1 Answer

How do I Check fuel injector gasket for town and country van

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Greenhorn:

    A rookie expert who has answered 20 questions on their first day.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Chrysler Expert
  • 189 Answers

Spray carb cleaner around fuel rail where the injectors seat in to the intake whial engin running see if engin speed increases
if a fuel leak is what your looking for visualy look at teh top of teh injecto where it go in oto the rail for wetness and fuel smell

Posted on Feb 28, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 1996 CHRYSLER TOWN & COUNTRY TRANS AXLE PROBLEM.

i had same toublre on 96 plymouth output speed senor my wont shift out of second

Posted on Jan 17, 2009

  • 41 Answers

SOURCE: replace fuel pump on 2005 chrysler town & country.

i cant be avoided sometimes you just have to bit the bullet and remove the tank.

Posted on Mar 23, 2009

  • 124 Answers

SOURCE: On Chrysler Town and Country van keys were locked in the car and

does this van have factory theft device? if so you may have to reset to get the ramp working

Posted on Apr 06, 2009

  • 96 Answers

SOURCE: Town and country mini van won't atart

Can you hear the fuel pump run when you cycle the key?

Posted on Sep 18, 2009

  • 1 Answer

SOURCE: CHRYSLER town and country mini van turn signal/flasher

I have a 2005 Chrysler T&C. The turn signal would not work at all or activate incorrect side. The switch is easy to remove as described by dukecityman.

Once the switch is of, it has four screws holding it together.I took this apart to find that there was a circuit-board which was contaminated with dirt. wiped it of, put it back together, working fine.

If you take it apart use caution. there are parts on the "top" which will fall out. ( they go right back in) The circuit-board is on the "bottom" half. You really only need to take this part off. (less moving parts)

Your going to replace it anyway, whats the harm?

Posted on Jan 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My 2005 town and country does not have an egr valve - but idles very rough when stopped


I had the same problem and your right no egr on 2005 town and country I have the same vehicle and the place for the egr is covered by a metal plate I also had the same exact problem with my van misfire bad idle at stop lights and after replacing every sensor there is and testing every part and injector with Ohm meter I read an article about the intake manifold plenum gasket leak can cause misfire so I bought new intake manifold plenum gasket set for only $7.99 and installed them and like magic the van ran perfect no more misfire no sluggish start from light Van is fixed finally!!!

Sep 30, 2012 | 2005 Chrysler Town & Country

2 Answers

Misfire in spark plug 2


swap the injector with another cylinder and see if the misfire follows the injector or start with a compression test

Sep 26, 2012 | 2001 Chrysler Town & Country

1 Answer

I have a 1996 Chrysler 3.8. town and country mini van


The oil pressure light probably came on when the engine stopped.
You would have lost your power accessories then too.
Someone will need to figure out if you have lost fuel to the injectors and/or spark to the plugs to know where to look for the problem.

Jul 23, 2012 | 1996 Chrysler Town & Country

2 Answers

Van will not start . It will not turn over when I try to start it. It is like it is not getting any gas.


1997 town and country alarm is shuting van down how do i disconnect it???????????

May 08, 2010 | 1997 Chrysler Town & Country

1 Answer

2003 town & country mini van - won't start, even when you hold the gas to the floor, makes popping sound


you have a bad injector or a plug fuel filter or a bad fuel pump check the fuel pump relay first also give these websites a try www.autozone.com and www.alldatadiy.com if all fails stop by your local library and get your hands on a Haynes auto repair manual for your van wish you the best of luck Michigan Man.

Jan 04, 2010 | 2003 Chrysler Town & Country

3 Answers

2001 Chrysler Town & Country mini-van stalling at all speeds


2001 Chrysler Town and Country- Won't start. Turn over. It acts like the fuel is not getting to the engine. After many attempts , it starts and runs like there are no problems. The car has 120,000 and has never had a problem. Is the fule pump bad?

Jun 21, 2008 | 2001 Chrysler Town & Country

Not finding what you are looking for?
2005 Chrysler Town & Country Logo

Related Topics:

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...