Question about 2006 Honda Accord
Posted by Anonymous on
Check your trunk lock mechanism. it might not be locking properly and not seating right due to rear damage and trunk lights are on and that can drain the battery overnight. have it adjusted.
Posted on Apr 17, 2017
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
If you brought your car to Honda for service, they probably forgot to reset the maintenance reminder. If you took it to another shop, they probably did not know how to reset it. Anyway, the reset procedure is:
Put your key in the ignition
Turn the key to the II position for a couple of seconds
Then turn the key to the off position
Now push and hold in the odometer reset button
While still holding the odometer reset button, turn the key back to the II position
Hold for I think 10 seconds or so and your maintenance reminder light should reset it self.
Posted on Jun 20, 2008
either your alternator has gone or your fan belt is not there which helps the alternator to charge the battery get a volt meter on your alternator to see if it is kicking out what it should be
Posted on Dec 06, 2008
Maintenance is needed depending on the mileage, anything from an oil change to a major service. then the light can be reset.
Posted on Apr 18, 2009
Hi, a few questions 1st. Did your mechanic check for engine codes? Is your Honda a v-6 or 4 cylinder?
The flashing D4 light indicates a possible transmission malfunction. You should avoid rapid acceleration until the cause of the light blinking is determined.
If you have the V-6, there is a diagnostic port to connect a scan tool to read any stored engine codes that have turned on the check engine light. This port is located behind the ashtray in the center console (most cars did not have this til 96).
If you have the 4 cyl engine, there is a service connector located under the dash on the pass. side. Inside the connector is what looks like a 2 wire plug should be attached. Take a paper clip, unbend it, and insert the 2 ends of the clip into the connector to 'jump' it. Turn the ignition switch to the on position (don't start the vehicle), and the check engine light will flash. Count the flashes, short flashes are for code #'s 1 to 9 (single digit code), a 2 digit code will be a long flash for the 1st digit, followed by a short flash for the 2nd digit. If there is more than one code, they will be separated by a pause. They will repeat so you can count them and write them down. Let me know what the code #'s are so I can help further. Curt
Posted on Jul 22, 2009
Tips for a great answer:
May 22, 2015 | 1994 Lexus GS 300
Sep 15, 2014 | Honda Odyssey Cars & Trucks
Apr 01, 2014 | 2013 Hyundai Santa Fe
May 21, 2017 | Hyundai Tiburon Cars & Trucks
Sep 21, 2011 | 2007 Scion tC Coupe
Aug 24, 2010 | Honda Accord Cars & Trucks
Mar 11, 2010 | 2005 Honda Accord
Dec 30, 2009 | 2008 Honda Pilot
Sep 28, 2009 | 2002 Volvo S60
May 11, 2009 | 2007 Buick Terraza CXL Wagon
22 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: