Question about Cars & Trucks
Were to locate the engine number on a 1994 ford courier utility ute for registration purposes
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
If I understand you right, the problem is at certain times the engine will not crank, that is turn over when you turn they ignition key to START. And at times it will start and run normally.
Might it be that the issue is with the starter system. The starter system is initiated at the ignition switch when the key is turned to start. At this point, the ignition switch then provides +12VDC to a starter relay. The relay is but a remote switch with slightly higher amperage capacity. The starter relay then engages and supplies +12VDC to the staring solenoid. The starting solenoid then performs two (2) functions. It provides the switching action (hundreds amps) from the battery heavy cable to the actual starter motor. The solenoid likewise pushes a small pinion gear along the shaft of the starter motor to engage the ring gear. The ring gear is of course on the edge of the flywheel which in turn is attached to the crankshaft.
Starter system problems could be corrected by:
1. check battery, battery cables and connections;
2. charge the battery if required;
3. clean brushes and guides of brush holders of the starter motor;
4. clean the commutator and commutator segments;
5. check/replace the armature or field coils if determined to be defective;
6. in some extreme cases it could be the drive pinion or the flywheel gear ring is defective.
7. often it is the big switch that the solenoid activates that looses contacts causing no +12V internally to the motor.
8. Most likely would be a defective starter relay or the IGN switch itself. Relative to this, you might try and check the connectors/terminals and electrical joints.
In the picture below, the upper portion is the starter solenoid while the one below it is the actual starter.
Given the amount of work to overhaul a starter, you might consider just replacing it.
This of course assuming that all other vital components of the car are working.
Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.
Good luck and kind regards.
Thank you for using FixYa.
Posted on Jun 09, 2008
fuel pump in the fuel tank note that all ford are equipt with cut of suitch (interuptor) located under dach board in case of colision ,towing, ect.....this electrical devise wil stop the flow of the fuel to prevent car fire
Posted on Dec 21, 2008
SOURCE: ticking noise coming from the
its a problem that now one on the internet can help u with we would have to be there to hear the noise cause it could be anything and it might be something very simple
Posted on May 16, 2011
Tips for a great answer:
Apr 30, 2017 | Ford Cars & Trucks
Jan 08, 2017 | Ford Cars & Trucks
Sep 11, 2016 | Ford Cars & Trucks
Jan 13, 2014 | Cars & Trucks
May 16, 2011 | Ford Aerostar Cars & Trucks
15 people viewed this question
Usually answered in minutes!