Question about Nissan Cars & Trucks

Open Question

Nissan primera p12 2.2dticar starts sometimes and runs but without warning will cut out and may not start again for afew minutes nats?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: primera 1990 P10 makes loud noise from belt when starting

i recently experienced the same issue. it can be your tensioner pulley or your water pump see the belts are connected to the pulleys and sometimes get worn out and need to be replaced. especially on a older car see a mecanic

Posted on Jan 31, 2009

Ad
jingB
  • 19 Answers

SOURCE: Engine cuts out and wont restart for maybe 20/30 minutes

honestly, I've not seen an alfa romeo here in the philippines but i think you problem is partly electrical and the electronic side of the car. something on your car is heating up so much that it cuts the power to the ignition once it has. it is a possibility that a damaged ignition coil or a faulty computer box(if your car has one) or the control system that regulates the spark distribution system or the injectors(if your car is fuel injected type).

Posted on Apr 14, 2009

  • 20 Answers

SOURCE: VW Polo 1998 Model runs fine for about 5 km

check all vacume hoses for splits.this sounds also like air being drawn from the fuel tank sender unit which could be corroded.is there a strong smell of fuel inside the car?this could also be a secondary jet being blocked in the carb if it has one.good luck

Posted on May 18, 2009

  • 15 Answers

SOURCE: i have a 98 nissan primera sri with the factory

your nissan primera nats alarm is connected to the factory fitted stereo. check your stereo fuse as these are the symtoms i have done this before

Posted on Nov 08, 2009

Wolfman304
  • 720 Answers

SOURCE: Nissan primera, engine management light

Hi Kev,

Your Nissan Primera has an on-board diagnostic computer which can detect malfunctions in either engine or transmission.

When the Engine Management light remains lit, this means some faults are present and need investigating.

From what you've described, one of the issues is indeed related to the transmission, but you will need to have the trouble codes (DTC's) extracted from your vehicle's computer, in order to determine what requires repair.

Whenever power is disconnected (i.e. the battery) and re-connected, this resets your vehicle's computer momentarily, until such time as it detects the fault again.

Recommend you either have your local dealer extract the codes (for a small 15min labor fee), or learn to extract the codes yourself, using a suitable jumper wire.


"If this has helped you in any way, please rate this solution"

Regards,

Posted on May 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replaced sterring colum now it wont start


S (Nissan Vehicle Immobilizer System-NATS) has the following immobilizer functions:  Since only NVIS (NATS) ignition keys, whose ID nos. have been registered into the ECM and IMMU of NVIS (NATS), allow the engine to run, operation of a stolen vehicle without a NVIS (NATS) registered key is prevented by NVIS (NATS). That is to say, NVIS (NATS) will immobilize the engine if someone tries to start it without the registered key of NVIS (NATS).  All of the originally supplied ignition key IDs have been NVIS (NATS) registered. If requested by the vehicle owner, a maximum of five key IDs can be registered into the NVIS (NATS) components.  The security indicator lamp blinks when the ignition switch is in "OFF" or "ACC" position. Therefore, NVIS (NATS) warns outsiders that the vehicle is equipped with the system.  When NVIS (NATS) detects trouble, the security indicator lamp lights up while ignition key is in the "ON" position.  NVIS (NATS) trouble diagnoses, system initialization and additional registration for other NVIS (NATS) ignition key IDs must be carried out using CONSULT-II hardware and CONSULT-II NVIS (NATS) software. Regarding the procedures for NVIS (NATS) initialization and NVIS (NATS) ignition key ID registration, refer to CONSULT-II OPERATION MANUAL IVIS/NVIS.  When servicing a malfunction of the NVIS (indicated by lighting up of Security Indicator Lamp) or registering another NVIS ignition key ID no., it is necessary to re-register original key identification. Therefore, be sure to receive ALL KEYS from vehicle owner. System Composition NIEL0174 The immobilizer function of the NVIS (NATS) consists of the following:  NVIS (NATS) ignition key  NVIS (NATS) immobilizer control unit (IMMU) located in the ignition key cylinder  ECM  Security indicator lamp.

ANTI-THEFT SYSTEM ! Did you change KEY'S

Feb 07, 2017 | 2001 Nissan Sentra

1 Answer

Chugging felt when starting up


There could be a laundry list of things wrong. Do you have good throttle response? Does it Idle without dieing? Check your fuel pressure with specs. If not up to par. Then yes you are right. Otherwise Could be fuel filter, broken or cracked vacuum line, MAP sensor, TPS sensor, IAC motor just to name a few things. need to hook up to scanner and check parimaters.

Feb 28, 2014 | Nissan Cars & Trucks

1 Answer

91 primera sr18 Di,have fixed vacume leak's in inletmainfold,replaced the airflow meter,have got it running excellently but after it has been running for awhile,it randomly dies and wont start again f


I had a similar problem. Nissan sr18di engine. car would run fine and randomly engine would cut off and only start after 20 minutes. Changed distributer
fine since

Nov 09, 2011 | Cars & Trucks

1 Answer

I have a 98 nissan primera sri with the factory fitted nats alarm/immobiliser.the mil light is flashing on the instrument panel and the alarm indication light is on when i turn on the ignition.the engine...


your nissan primera nats alarm is connected to the factory fitted stereo. check your stereo fuse as these are the symtoms i have done this before

Sep 17, 2009 | 1998 Nissan 200SX

1 Answer

How would I install an upper suspension arm to


nissan primera in the US is called an Infiniti G20. the grinding or knocking if its coming from the front, is gonna be the tension rod bushings are warn out. get new tension rods for real cheap. thats all i can help with, suspension is my thing, motor is not.

Jul 16, 2009 | 1995 Nissan 200SX

1 Answer

Primera 1990 P10 makes loud noise from belt when starting


i recently experienced the same issue. it can be your tensioner pulley or your water pump see the belts are connected to the pulleys and sometimes get worn out and need to be replaced. especially on a older car see a mecanic

Jan 31, 2009 | Nissan Pulsar Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...