Question about Cars & Trucks

Open Question

Sanderson teleporter 6-22 wont drive forward but it only drives backwards does anyone know whats up with it ??

My teleporter was working fine then it wouldnt go into drive but would reverse could anyone let me know if they had the same problem and has a solution for it thanks

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1118 Answers

SOURCE: 2001 Isuzu Rodeo Sport will not go forward in drive

whats the fluid smell like? when was the last time it was serviced? where is fluid on stick when hot? low on fluid could do what you discribed, but chances are trans needs rebuilt. if fluid smells burnt, rebuild or replacement.

Posted on Jan 18, 2009

Ad
  • 24 Answers

SOURCE: transmission shifting problems

If Drive Selector switch is properly aligned then a shift silonoid might be the problem.

Posted on Feb 21, 2009

  • 4 Answers

SOURCE: 92 camry wont move forward

no, you need a transmission, A used one cost about 3 to 4 hundred dollars at the junk yards

Posted on Apr 06, 2009

hardinfarms
  • 144 Answers

SOURCE: car does not drive forward but works in reverse

Sad to say but your automatic transmission has bit the dust.

Posted on Jul 24, 2009

  • 14 Answers

SOURCE: 2002 Camry won't accelerate

check throttle position sensor wire chewed up, broken wire or unplugged? check with volt meter mesure the voltage @ throttle positon sensor see if there's voltage goes up/down when u apply/release gas.

Posted on Aug 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My car goes into reverse but won't go forward. What's the problem?


10 Most Common Transmission Problems

www.transmissionrepaircostguide.com/10-common-transmission-proble...
A similar type of thinking goes into diagnosing car trouble. ... response issue, but after shifting into gear the engine's RPMs will surge, but the car won't move ..... Can anyone please explain why my car cant go in reverse but can drive forward

My car will not go in reverse but will drive forward. What could ...

https://answers.yahoo.com/question/index?qid...
Dec 26, 2007 - My car will not go in reverse but will drive forward. ... I tried putting it in neutral and pushing it backwards, but something catches and it won't budge. ... Either way, it's likely that the transaxle is going to require removal and ... the hood and movethe linkage by hand, then it would shift into gear ok for awhile. Why won't my truck go forward, it only goes in reverse? ' Yahoo ...
Feb 23, 2014
My car won't go into reverse, still okay to drive a 2 hour drive ...
Jan 12, 2011
My car won't go in reverse but it will go forward with no problem ...
Feb 6, 2010
My car will drive forward, but not in reverse... Could this be a ...
Sep 11, 2007
More results from answers.yahoo.com

Dec 16, 2015 | Cars & Trucks

1 Answer

My mitsubishi galant loses power while driving and the neutral light indicator starts to blink then suddenly picks up speed with a jolt. I flushed the transmission fluid to clean the bottom pan and...


You will have to repost and reword this problem... you say it wont move, but that it loses power while driving. how is it losing power while driving if it wont move?

Feb 11, 2014 | Mitsubishi Cars & Trucks

1 Answer

My reverse went out of my truck and I put it in neutral to push it backwards and its like I'm in drive andcan drive forward what can I do to fix it


If reverse is done and you can only go forward is it shifting out of first. If its not then you need the transmission rebuilt. That's what happened on my truck.

Apr 03, 2013 | 1996 Dodge Ram

1 Answer

I have Citroen C4 2007 manual gear.Car starts fine and I can change to all the gear but wont move forward or backwards in all the gear?


the gearbox will need to be removed and the clutch inspected it sounds like the drive plate is unservicable

Jan 22, 2013 | 2006 Citroen C3 1.4i

1 Answer

2000 Sebring JXI wont start & when in reverse you can push the car forward or backward


https://s18.postimg.org/4m8krqjk9/sebring_starter.jpg

Click on the link for starter wiring. Not sure what's going on with your tranny? You can see in the diagram, the tranny module gets voltage from the crank position, ignition switch. You can also see the fuse, not only check the fuse, use a testlight and check voltage on fuse circuit.
Any testing, make sure functional parking brake is set and block the wheels. be safe. Safety is your responsibility.
Battery has a full charge and battery connections all good?

Jul 05, 2017 | 2000 Chrysler Sebring

1 Answer

My alero with a 2.4 cylinder wont go forward but go in reverse


You have a failed transmission, have it taken to a transmission shop for repair.

Jun 15, 2012 | Oldsmobile Alero Cars & Trucks

1 Answer

Rear wheel moves freely backwards and forwards on my 1995 ford taurus se. I am not able to drive it for fear of the wheel coming off.


you are going to have to pull the wheel off yourself before anyone is going to be able to help with this one. i have to know what is going on behind the wheel before i can begin to help.

Feb 20, 2010 | 1995 Ford Taurus

2 Answers

SANDERSON TELEPORTER, HOW DO I BLEED THE LUCAS FUEL PUMP ON A PERKINS ENGINE


Perkins is a hard engine to prime. Fill the fuel filter with clean diesel, there should be a hand pump on the left side(looking at the front of the vehicle) . There should be a bleed screw on top of the filter housing. Loosen the bleed srew and pump the hand pump untill you get a steady stream of fuel from it. Tighten the bleed screw. Loosen the injector bonnet nuts approximately 1 1/2 turns on all of the injectors. Turn the engine over until you see a steady stream of fuel from the the injector bonnets. Tighten the bonnet nuts, pump the handpump approx 10 times and start the engine. Give it half throttle until it stops stumbling and all of the air is worked out of the system.

Jan 08, 2010 | 1985 Mitsubishi Pickup

1 Answer

2001 Isuzu Rodeo Sport will not go forward in drive


whats the fluid smell like? when was the last time it was serviced? where is fluid on stick when hot? low on fluid could do what you discribed, but chances are trans needs rebuilt. if fluid smells burnt, rebuild or replacement.

Jan 18, 2009 | 2004 Isuzu Rodeo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...