Question about 2005 Chevrolet Colorado
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
the first place to start is the flashing engine lite. that means cylinders are not firing at all or improperly and driving it like that for even short period could cause heavier damage. particularly valves and cat converter(s) the computer really needs to be scanned for codes in order to proceed. did the oil lite come on before or after engine quit. after engine quit would be normal cause it stalled. its possible that it needs spark plugs and/or coils. or more
Posted on Nov 20, 2008
it will say in your owners manual but i believe you turn your ignition key to the run position not the start. and pump the gas pedal 3 times with in 5 seconds
Posted on Apr 14, 2009
This is an idication of a severe oil leak. Check the oil level in your engine to see if there is any in it. Add to the full mark and return to the oil change shop and ask them to see where the leak is. Do not operate without oil. Severe engine damage will occur. Hope this helps Moe
Posted on Apr 28, 2009
If it was a stock rebuild the original PCM settings should be fine check all the fuses and wiring possibly something was damaged or left loose this stuff happens to the best of us.next the SES light needs to be reset with a scan tool make sure to record all codes stored in the computer as this will aid in diagnosing any problems. the car must be ran thru a drive cycle usually normal driving conditions of say a mix of city and highway driving until the PCM relearns all parameters like o2 sensors emissions sensors ect... this can also be checked with the scan tool in the readiness moniters these monitors will be reset every time the SES light is reset. when pumping the gas pedal 3 time you are just resetting the maintenance light.
Posted on Aug 03, 2009
If the light is only turning on during acceleration or deceleration and then goes off, this is normal. If the light is constant, and you are sure you have oil that is up to the "full" or "max" level on the dipstick while hot, then it might point to a faulty oil pump or worn gaskets that will no longer prevent the oil from staying in place in the engine. Is this light accompanied by a check engine light. If so what is the code. You may also have a faulty oil sensor. Hope this helps
Posted on Apr 09, 2010
Tips for a great answer:
Jan 02, 2013 | 2004 Chevrolet TrailBlazer
Nov 27, 2011 | 2004 Chevrolet Tahoe
Aug 08, 2011 | 1997 Chevrolet Lumina
Jan 20, 2011 | 2005 Chevrolet Colorado
Nov 19, 2009 | 2004 Chevrolet Colorado
Apr 15, 2009 | Chevrolet Colorado Cars & Trucks
25 people viewed this question
Usually answered in minutes!