Question about Cars & Trucks

Open Question

Engine wont turn over

Battery full.terminals good,test with meter earth to engine fine,checked terminals to starter all fine,no clicking noise.just nothing.any ideas lee.its a renault kangoo 1.9d

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: renault kangoo 1.9 d immobiliser probims.{2001} model.

hold the central locking button down on the centre consul inside the van for more than 5 seconds the doors should lock Then unlock,then press the key fob within ten seconds the doors will lock and unlock again this will re- program the key code

good luck jk

Posted on Feb 05, 2009

Ad
  • 3 Answers

SOURCE: Renault Kangoo starting

Had a look at the fuse (15Amp) that controls the door-locks and the imobiliser?
/H

Posted on Mar 03, 2009

  • 205 Answers

SOURCE: Turn key, nothing happens

It could be the park/neutral switch, next time it doesn't start try wiggling the shifter in park while turning the key, or shift to neutral and see if that will work. if that doesn't change the problem I would replace the ignition switch.

Posted on Mar 20, 2009

  • 199 Answers

SOURCE: 2004 FORD TAURUS WONT START. WHEN TRY TO TURN

just a wild shot in the dark are the battery cables on real tight also you should get @ 13 vdc on a good battery

Posted on Jun 27, 2009

ftw1952
  • 10319 Answers

SOURCE: 1993 buick lesabre won't crank. battery is good

most likelt the electrical ignition switch located on the transmission is shot
Just take a volt meter to see if power gets to the solenoid wire. If not replace that switch

Posted on Sep 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My car will not crank the battery is charged,the starter is new but it only makes a click noise when the ignition is turned


fully charged batteries can fail when the high load of a starter is applied to then
have a battery load test done to eliminate the battery, then check for dirty terminals ( posts and terminals have to be shiny clean and tight)
check for failed battery leads and dirty earth point or loose earth point.

Jul 26, 2015 | Cars & Trucks

2 Answers

My 98 crown vic wont start, we had the starter tested and was told its good, when i turn the key all u can hear is the relay click(the relay up by the battery), the starter doesn't make any noise, any...


Thanks for choosing FixYa and welcome to the sight. Did you check your starter solenoid? It may be that. You need to check your ignition fuse as well. Make sure the battery has a full charge and is holding a proper charge. If the starter isn't getting the full current, it may not work right. You need to make sure that you clean your terminals and post with a wire brush. Inspect all you wires from the battery to the starter. If you have to, test the wires for current with a voltage meter.

Apr 21, 2011 | 1998 Ford Crown Victoria

2 Answers

My mercedes benz C180 w203,cannot crank in the morning.The battery is perfect.And if it cranks,it does not have any starting problem through out the day.what is the problem ?


Hello! I suspect there is a resistive connection on the + battery cable and/or the - battery cable connections to the starter motor which are temperature sensitive...Using a digital volt meter (cost $25-30 if you do not have one)...Put the DC voltage scale on it's lowest setting...Place + probe on the center of the battery post...Place the - probe on the starter motor + connection...Must read no more than .03 volts...Perform the same test on the - battery post...With the - meter probe on the starter case...Must read less than .06 volts...If readings are incorrect the problem is as stated...And cables need to be replaced...

Guru..................Saailer

Aug 06, 2010 | 2001 Mercedes-Benz C-Class

2 Answers

On my 1990 Camaro RS the starter is clicking while turning engine


Check the ground cable from the battery to engine and from the battery to body/chassis. Let me know if you need any other help.

Jan 07, 2010 | 1990 Chevrolet Camaro

2 Answers

My car dont star, i check my ligths and averything is ok, i listen under de motor a little click click i hit in the starter whit a screw


If ur getting a clicking noise when u attempt to start it sounds like the starter drive ingaging into the flywheel but the starter isn't turning. Check ur battery to make sure it is fully charged and get a load test to make sure it is ok. Next check the connettions to the battery. Ur Problem wasn't complete--if crossing terminals at the starter the engine turns over it is the starter soloid, if it just clicks it is the battery or connections

Aug 03, 2009 | Nissan Pathfinder Cars & Trucks

1 Answer

The battery is good but there is no click or any noise when start


First, establish that there is 12v at the battery (with a volt meter) then remove terminal ends and clean contact surfaces. Check that there is 12v at the main starter terminal and 12v at the starter trigger wire with the key turned to the start positon. If not, check starter relay, neutral safety switch and ignition switch. Make sure battery ground wire on engine is also clean and secure.

Jun 19, 2009 | 1997 Plymouth Neon

2 Answers

93 ranger not starting, wont turn over.


Take a volt meter and put the red probe of the meter on the engine block and the black probe on the battery Negative terminal. Have somone try to crank the car. If you get a reading of over 1/2 volt, you have a bad ground from the battery to the Engine block. Check the terminals on both ends of this wire.

If the above is OK, Put the volt meter on the battery terminals. (Red to Positive) and try cranking the car. If the voltage falls well below 9.6V your battery is bad. If 9.6 V or more, you may have somthing binding in the engine. When did this car run last?

Good Luck

Feb 07, 2009 | 2003 Ford Ranger Regular Cab

2 Answers

95 ford escort gt 1.8L wont turn over at all


Do you have a good 12v source of power when cranking at the starter solenoid wire and is that wire intact and on the right terminal?

Nov 18, 2008 | 1995 Ford Escort

1 Answer

Engine won.t turn


hi can you turn engine over by hand [engine s not sezied ] and how did you test the battery and how did you test starter because if the engines not seized and you put a jump lead from your positive terminal off a good battery to a starters main terminal and it wont, turn over the starters faulty or there is no engine earth so connect the other jump lead from the negative battery teminal to the engine block and try again it will turn over if the starters good if the starter turns over with the jump leads check the small terminal on the starters wire is live when someone turns the ignition key if it is and the starter does not turn over then the soleniod on the starter is faulty if no live at small terminal then the ignition switch or starter relay are faulty best of luck yates2104546

Oct 14, 2008 | 1994 GMC Jimmy

2 Answers

Wont start


is the earth cable giving a good engine and body contact.does your starter have two terminals and if so are they the right way around?is the battery any good?Is the engine able to be turned over by hand Make sure you have agood 12v supply to the starter solenoid when cranking the engine An engine test probe/light would be of a lot of use for you to do that test

Oct 07, 2008 | 1993 Ford Escort 4 Door

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77514 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14398 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...