Question about 2000 Toyota Camry

1 Answer

One brake light works and the other one doesn't.

I replaced the bulb and the fuse, but the right light refuses to come on.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 20,706 Answers

The wiring and connections are bad there.
most LHD cars wire left side over to right.
and if car had tailer hacks, this is #1 way to mess up wiring.
i call it Uhauled.
all it takes to find this is, a simple voltmeter.
find where the volts dies. and bingo,
id inspect all connectors back there for corrosion, and damage or hacking, (illegal slices, using wrong methods and parts)

Posted on Feb 12, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 45 Answers

SOURCE: Right tail light not working when pressing brake w/ lights on.

There should be at least 2 bulbs in the light assembly. One light is the light that is on when you turn on your headlights with out the brake pressed, the other light only lights up while you press on the brake. Make sure you are replacing the correct bulb. You may have been replacing the bulb that stays on. Your lights may be set up to turn off the light that stays on when the headlights are on while pressing the brakes.

Posted on Nov 13, 2008

inf12
  • 13 Answers

SOURCE: lower brake lights on 92 camry wont work

YOU MAY NEED A LIGHT FAILURE SENSOR WHICH IS LOCATED IN THE TRUNK ON THE DRIVERS SIDE

Posted on Feb 11, 2009

  • 150 Answers

SOURCE: 2005 Toyota Sienna rear brake light problem.

have you checked the earthing continuity-if it's this other bulbs may also partly light when brakes used
otherwise-
Check continuity of live from center to lh & rh lights and/or is there a live at those lights

Posted on May 03, 2009

  • 1861 Answers

SOURCE: 2003 Toyota Camry - Both Brake lights not working

Lok in the trunk on the left side, behind the carpet for a small plastic box with a bunch of wires going to it. Look to see if there is brake light powe coming in with the pedal depressed. If so, and no power is coming out, you need to order and replace the "taillamp failure sensor".

Posted on Jul 16, 2009

  • 484 Answers

SOURCE: 1989 Toyota Camry. No brake lights.

It could be the relay, which is a yellow box located under the carpeting in the trunk on the left side. It is a problem common to your model. Also, check the brake switch's (behind the brake pedal) functionality (12V present with key at ACC or ON and continuity between wires when button engaged).

i hope this helps
-matthew

Posted on Oct 26, 2009

Testimonial: "Wow! I would have never found the problem without you guys. It was the relay located in the trunk. Thanks!"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1 brake light doesn't work... good bulb and fuse


Lights are usually on a dual circuit! Left and right have separate fuses, check all fuses or check the fuse diagram on fuse cover or manual to identify correct fuse!

Dec 28, 2014 | 2001 Dodge Intrepid

3 Answers

Why taillights do not come on, but the brakelights and signal lights work


check the fuses for a burnt fuse. the taillight circuit has its own fuse and wiring. its possible the headlight switch is bad but this doesn`t happen very often.

Aug 24, 2014 | 2004 Kia Sedona

1 Answer

2003 Malibu right turn signal doesn't work when using brakes


Its not a fuse and I doubt it is a switch.
The most common problem is a bad ground going to the bulb.
If the three circuits going to the bulb are ok, it might be in the turn signal switch.

Apr 14, 2013 | 2003 Chevrolet Malibu

1 Answer

Passanger and third break light don't work, new bulbs and fuses installed. what should i check next?


I would check the turn signal switch first. The brake lights may go thru the switch depending on the configuration.

Aug 16, 2012 | 1992 Honda Accord

1 Answer

My 99 Jeep grand Cherokee Laredo 4x4 has some brake light problems. The brake lights work fine during the day, but when I need to have my headlights on, my left brake light and tail light competley shut...


If you have any extra fuses, try replacing the ones for the head lights and tail lights. Make sure the fuses you replace are the same color as the ones you replace them with, that way the voltages are the same. Another issue is that a flasher could be going out.

May 01, 2012 | 1999 Jeep Grand Cherokee

2 Answers

Driver side brake light is not working. Replaced bulb, but didn't need to it is the same bulb that works the tail lights, which still worked. Ugh, 2006 jeep liberty. Someone said it was a brake...


THAT RIGHT IF BRAKE SWITCH BAD NO BRAKE LIGHT WILL WORK.SPRAY ELECTRICAL CLEANER IN BULB SOCKET BULB SOCKET COULD HAVE OXIDATION AND CORROSSION CAUSING POOR CONTACT.

Sep 12, 2011 | 2006 Jeep Liberty

1 Answer

1997 Acura 3.5 RL right brake light not working (all other rear lights - both left and right work). Changed bulb (two separate bulbs) and still not working. Checked all fuses under dash and hood. Is...


The problem is the socket. Remove the bulb and bend the tabs in the socket so they make contact with the bulb. If this doesn't work you will have to replace the socket. A wire is broke and they usually break at or in the plug.

Jul 19, 2011 | 1997 Acura RL

1 Answer

Which fuze works the right brake light


If the right brake light is the only one not working, the fuse is okay.
There are not seperate fuses for brake lights and work on a single brake circuit. Chances are the bulb is out. Check the bulb and replace as needed with the same type bulb. If it still is not working after the bulb is replaced, check the power and ground circuits with the correct testing equipment.

Apr 20, 2009 | 1999 Jeep Grand Cherokee

2 Answers

Right brake light out; tail light works fine


most rear tail lights and turn/stop lights are the same dual filiment bulb. it is possible for your tail light to work and your brake light not to and still have a bad bulb. I would check the bulb first, your brake light works on the left yes? this would mean that the fuse is fine

Mar 31, 2009 | 2006 Dodge Stratus

Not finding what you are looking for?
2000 Toyota Camry Logo

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...