Question about Cars & Trucks

Open Question

Transonic twh s1blinking light fault - Cars & Trucks

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Malfunction indicator light not commicating


Vehicle fault lights is caused by fuel emissions system more commonly, you at the time of fault lights to start vehicles, car, start, out after three times in the launch vehicle would you see if the trouble light or light, or light up you need in a timely manner to the store check the fault code, is a problem of engine or the sensor fault, or light may be occasional failure can need not in time to the shop to check the sohu auto q&a platforms,auto diagnostic tool.

Mar 14, 2013 | Cars & Trucks

2 Answers

My 1995 subaru legacy lost reverse gear, what could the problem be?


When you loose reverse it is pretty much over for the trans

Only a complete disassembly & rebuild,usually resolve that

Jul 18, 2012 | 1995 Subaru Legacy

1 Answer

Abs fault light, engine management light, parkbrake fault (won't go off) DSC fault light, air suspension fault, 2003 Jaguar 3.5 SC V8, ah also discovered water ingress in boot, quite a lot!!, only fault...


try disconnecting the battery both leads and join them together for 5 mins and see what happens cannot find this fault code in teh jaguar OBD codes so consult with teh code reader manufacturers

Feb 08, 2011 | 2003 Jaguar XJ-Series

2 Answers

My 2004 ford taurus is 98 000 miles and the engine light is on the dashboard just now what i should do ?


You will need to put your car on a diagnostic fault code reader. The engine malfunction light will come on if there is a fault with the emissions if it runs ok and isn't misfiring it's probably a oxygen sensor fault or a catalyst fault. The light won't go out unless the fault is cleared

Oct 04, 2010 | 2004 Ford Taurus

2 Answers

2002 Kia spectra Engine Light


in short this means the EGR (Exhaust Gas Recirculation valve is blocked, most like the passages in the intake are carboned up, go to the link below for full diagnosis and testing for this fault code P1402

http://www.bba-reman.com/content.aspx?content=NEXT_DTC_P1402

Feb 02, 2010 | 2003 Kia Spectra

1 Answer

1998 chevy monte carlo check egine light wont go out evevn after computer download


if the light stays on, this means the computer has detected a "hard" fault. This means that the fault is present and is detected during the computers power up self test. You need to follow the diagnostic procedures pertinent to the faults given. the light will stay on as long as the fault remains. Simply downloading the fault codes will not put the light out.

Jan 05, 2010 | 1998 Chevrolet Monte Carlo

1 Answer

Electronic Ignition Fault Light On


It is probably due to a faulty sensor somewhere, but without proper diagnostic equipment it is virtually impossible to tell which one.

A modern fuel injected engine will have sensors to monitor throttle position, manifold pressure, coolant temperature, air temperature, crank speed, camshaft position, exhaust gas oxygen, pre-ignition, etc, etc, etc.

Diagnostic equipment will be able to read the fault code from the vehicles computer and tell you where the fault lies.

The light cannot be reset manually. It will go out once the fault has been rectified.

Hope this helps!

Jun 20, 2009 | 1998 Volvo S70

1 Answer

Flashing glow plug light


sounds like a glow pug fault.it will flash if one glow plug has a fault.

Jun 03, 2009 | 2003 Volkswagen Golf

1 Answer

Wont start mornings when warm starts good for a few times then wont again an also got i think engine management light come on in the dash when runing it comes on an off about half an hour apart


hi you need to get a reading off a fault code reader to find out what is causing the light to come on the engine manament light works off detecting not an individual fault it has to recieve this fault on 3-4 occassions before the light comes on if it doesn,t recieve a fault reading in a certain period of time it will presume the faults been fixed and the light goes out but 30 min period seems not enough time to for a reset the fault code reader should be able to store the fault code even ifs its not happening at the time but would be better if you can get the reading while the light is on yates210456

Oct 01, 2008 | Mitsubishi Passenger Cars & Trucks

1 Answer

Focus brake light fault


Is this the same light for the emergency brake?

Jul 03, 2008 | 2004 Ford Focus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14398 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...