Question about 2001 Chevrolet S-10

1 Answer

Car loses rpms when started and clicking coming from back of vehicle

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 27 Answers

Fuel pump is going bad

Posted on Nov 21, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

While driving my car loses all rpms until I come to a complete stop turn the car off then turn the car back on it runs fine for a couple miles then does it again. No check engine light comes on


ur car could be falling into limp mode..wat year make an model is it? also make sure ur check eng lite even works when u first turn ignition on it normally does a bulb check an they should all light up on ur instrument panel..check for the yellow check eng light.. also scan ur vehicle sometimes codes are recorded but not hard enough to illuminate the light.but they will be stored .history codes should be checked too...hope this helps .keep me informed

Jun 28, 2015 | Cars & Trucks

1 Answer

'06 toyota corolla loses power while driving


The power steering works off the engine, so if engine not running, no power steering. It sounds like to me that a good place to start would be the fuel filter. If the fuel filter is plugged, it may allow enough fuel to go through to run the vehicle for a few minutes but not allow enough through to sustain continued operation. The fuel pump is also a consideration.

Mar 21, 2014 | 2006 Toyota Corolla

1 Answer

Toyota 4runner problems


run fault codes and fix sensor indicated to be faulty.

Jan 26, 2014 | Cars & Trucks

1 Answer

Clcking noise


I would need to listen to the "clicking" noise before I could even begin to help with that. As far as a high idle at start up, in many cases on a Ford if you have that problem you may have a vacuum leak. Your computer corrects the problem after start up so the vehicle runs correctly. Is your check engine light on ? Most cases, a vacuum leak will cause it to come on but would need the code to be sure. Now finally the A/C only working on high would mean that you most likely have a bad blower motor resistor. Very common symptom for a bad resistor. Could be the switch but doubt it. Hope this helps....

Jul 23, 2013 | Cars & Trucks

1 Answer

What is the meaning and function of O/D off-onn ( overdrive function )


this function allows you the option to turn overdrive off for towing purposes. when your vehicle shifts into overdrive the output shaft of the transmission spins faster than the input to keep engine rpms down and maintain fuel economy. by going into overdrive your vehicle loses torque which is why turning off overdrive for towing makes the pull easier by keeping rpms and torque higher

Aug 18, 2012 | 1992 Mitsubishi Pajero

1 Answer

I have a 1984 subaru GL (Manual Trans) that when driving the engine revs really high even when i go to shift either up or down. When i first start the car the rpms are between 750 - 1200. Also the ECS...


You might have this problem:
Recall 84V106000: Possible Accelerator Cable Wear POSITIONING OF THE ACCELERATOR CONTROL CABLE IN THE ENGINE COMPARTMENT COULD RESULT IN ABNORMAL WEAR TO THE CABLE. THE CABLE COULD BEGIN TO FRAY AND UNWIND.
UPON INSPECTION, THE ACCELERATOR CABLE WILL BE REPOSITIONED, IF NECESSARY, AND REPLACED IF DAMAGED.
VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH HITACHI CRUISE
CONTROL SYSTEMS; TURBO AND NON-TURBO CHARGED MODELS.
SYSTEM: EQUIPMENT; CRUISE CONTROL, ACCELERATOR CONTROL CABLE.
CONSEQUENCES OF DEFECT: FRAYING OF THE ACCELERATOR CABLE MAY CAUSE THE CARBURETOR THROTTLE TO STICK OPEN; THE CABLE COULD BREAK. DRIVER COULD LOSE CONTROL OF VEHICLE SPEED AND AN ACCIDENT COULD RESULT.

Jul 26, 2011 | 1984 Subaru Gl

1 Answer

Loss of power in 2003 honda accord 2.4 liter


Check for a clogged catalytic converter.

Feb 26, 2009 | 2003 Honda Accord

Not finding what you are looking for?
2001 Chevrolet S-10 Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...