Question about 2005 Jeep Grand Cherokee

1 Answer

Cruise wont come on unless i flip on passenger side turn signal

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 20,706 Answers

Get the fsm and troubleshoot this combo switch area.
04 might work here.
good luck,
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

Posted on Feb 11, 2014

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

saberwolf67
  • 21 Answers

SOURCE: no passenger side turn signal

you have a broken wire at the bottom of Ur rear end or bad connection

Posted on Nov 23, 2008

witmoz
  • 389 Answers

SOURCE: turn signal bulb was working, now it isnt

its is not uncommon for the contacts in the sockets to become corroded or just expand to the point of where they do not contact the bulb,try to test the socket with a multimeter for voltage,if it has voltage then its most likely the contacts,which sometimes can be rebent,but replaceing the sockets is a better solution,and can be picked up at most stores or 4x4 shops and junk yards.

Posted on Dec 16, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Passenger side front turn signal/DRL do not work.


Dear Alex,
The problem is in the bulb, or the socket, or the wiring to these.
Whenever a turn signal flashes fast, know that one of the bulbs is not working.
You have already identified the problem as being the front one. Problem could be the hot wire, or the ground wire, or the ground connection to this bulb.
Start by taking a tester to the hot wire, and see if it is receiving electrical impulses when the turn signal is on.
( It probably is, unless the car has been in a wreck and has been improperly repaired.)
Then check the socket or the wires to is and see if the bulb is grounded.
I suspect the ground is defective, and either a new socket or a repair to the ground wire should fix you rights up.
God bless your efforts.

Aug 02, 2016 | 2002 Pontiac Montana

1 Answer

Cruise control wont engage unless i flick on turn signal


check fuses. (test them) use a meter.
check the switches for proper operation. a meter.
replace the switch is bad.

Feb 11, 2014 | 1994 Jeep Grand Cherokee

1 Answer

Passenger windown wont roll up or down, motor good


If the passenger side switch is bad it wont complete the circuit to operate the window. Recommend trying a known good passenger switch.

Nov 10, 2013 | 2007 Chevrolet TrailBlazer SS

1 Answer

Cruise control wont work on 1994 suburban


You can check for broken wires on your turn signal lever where it goes into the steering wheel column or the cruise control module on the firewall on the drivers side under the hood has gone bad.It is an easy replacement and you can pick up a used one fairly cheap.Also the turn signal lever is fairly cheap at Autozone.

Apr 19, 2013 | Chevrolet Suburban 1500 Cars & Trucks

1 Answer

Turn signals not working in front


you have a shor in the steering colum typical in gm cars... replace the whole coulm

Jul 09, 2009 | 2002 Pontiac Bonneville

1 Answer

Brights stuck on along with turn signal


Short in the turn signal switch. Should cost around $75 to replace and about 20 minutes.

Jun 17, 2009 | 2002 Mitsubishi Galant

1 Answer

Brake lights wont come on unless my bright headlights are on


By the discription just about the only thing it could be is the multifunction switch, this is the turnsignal, wiper, blinker, bright light, and cruise if it has it switch. And it is not verry simple to replace. The steering colum needs to be taken apart to replace.

Jan 01, 2009 | 1990 Chevrolet Corsica

Not finding what you are looking for?
2005 Jeep Grand Cherokee Logo

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...