Question about 2006 Audi A3

1 Answer

Where do i find my ignition coils on my audi a3 2.0T

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Audi Master
  • 21,873 Answers

Should have one on top of each spark plug.

Posted on Feb 11, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1996 Audi A4 2.6E - Not idling properly.

The ignition coils on your Audi A4 are what provide the spark to the spark plugs, which sit underneath each coil. Every cylinder in your A4's engine has a spark plug and an ignition coil assigned to it. Sometimes, the ignition coils can fail and require replacement. Typical symptoms of a failed ignition coil include a flashing "Check engine" light, a rough idle or hesitant acceleration. Replacing the ignition coils on your A4 is a quick procedure that takes just a few minutes.

    • 1

      Park your Audi A4 on a level surface and open the hood.

    • 2

      Remove the plastic rivets that secure the plastic engine cover to your engine with the flathead screwdriver. Depending on your engine, there may be either three or four plastic rivets, which are all very obviously placed. Set the engine cover aside.

      • 3

        Firmly pull the ignition coil you need to replace up from the engine. Since it does attach to the spark plug, you will need to apply a little force. Be sure to pull directly up so that you do not bend the metal rods at the bottom of the ignition coil.

      • 4

        Unplug the ignition coil from its wiring harness. Depending on your engine, you may need to use a flathead screwdriver to pry up the loosening latch on the wiring harness.

      • 5

        Insert the replacement ignition coil into the spark plug cylinder and push directly down until you hear a slight popping noise, which will indicate that it has been installed correctly.

      • 6

        Replace the plastic engine cover and secure it with the flathead screwdriver and the plastic rivets to complete the procedure.

    Sep 05, 2012 | 1996 Audi A4

    2 Answers

    I have bean informed that my audi dosnt have spark plug wires

    Half the vehicles made, the last ten years, don't have plug wires.

    Oct 01, 2010 | 2004 Audi A4

    1 Answer

    My audi 80 1992model 80e has no ignition ht spark from coil is there some swithch on the engine that will cut this circut out

    the ignition module has gone by the sound of it ,its under the coil and smallish black thing with plug into it and it should be marked up with bosch ,about 70 euros for a new one

    Mar 26, 2010 | 1992 Audi 80

    1 Answer

    How would you change the spark plug leads and distributer cap on an 1999 Audi A4

    There is no distributor - the ignition system uses coil packs. Just get a set of wires, pluck one at a time off the plugs and coil packs, and replace them.

    Jan 29, 2010 | 1999 Audi A4

    1 Answer

    Code P0118 on Audi A4 - Related to Ignition Coil Problem?

    Hi, the sensor on the engine (right at the rear end of the cylinder head) has two separate outputs. One drives the temperature gauge and the other provides data for the engine control unit. The output for the engine control unit is almost certainly faulty and the sensor will need to be replaced. It isn't an expensive item and's not time consuming to replace (1/2 hr) - so you could ask Audi to do it for you when they replace the ignition coils.
    Hope that helps Matt..

    Nov 15, 2009 | 2005 Audi A4

    1 Answer

    2004 Audi A4 3.0 6 cylinder - how to replace ignition coil?

    you need a small torx bit i think size T-20 or 15 a small bit driver unscrew the plastic wire holder then those red caps those are your coils

    Aug 23, 2009 | 2004 Audi A4

    1 Answer

    1988 audi 80 4cyl. no spark from coil,new coil fitted,coil lead

    hi i have a coupe 1994 have same prob told by audi to replace the distributor as was common failt on audi's i have replaced new leads ,coil ,dissy cap, and arm ,still the same awaiting on distributor to see if this works hope this helps

    Apr 27, 2009 | 1988 Audi 80

    1 Answer

    Engine has miss-fire

    First check spark plugs/wires/distributor cap (tune up). Also would be good idea to use fuel injector cleane and change fuel filter and O2 sensor.
    Hope that helps
    Good Luck

    Mar 22, 2009 | 2003 Audi TT

    1 Answer

    Ignition coils on 2005 Audi S4 cabriolet

    If you replaced the coils the spark plugs should also be change. The plugs are more than likely bad.

    Nov 12, 2008 | 2005 Audi S4

    Not finding what you are looking for?
    2006 Audi A3 Logo

    Related Topics:

    58 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Audi Experts

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22326 Answers


    Level 3 Expert

    80637 Answers

    Thomas Perkins
    Thomas Perkins

    Level 3 Expert

    14417 Answers

    Are you an Audi Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides