Question about Cars & Trucks

Open Question

Toyota wish oil filter located - Cars & Trucks

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Hello! Where is the oil filter located in 2009 Toyota Matrix

9_8_2012_4_09_58_pm.jpg The oil filter is on the right rear of the engine. The attached photo, viewed from the center rear of the engine shows the oil filter cover, which black, circular, and about 3 inches in diameter. There is a special oil filter socket wrench (64 mm, 14 flats) that mates to the 14 flat spots around the circumference of the filter cover. You can also see on the lower left, a spring loaded tab, ostensibly to prevent the filter cover from unscrewing and falling off.

Note that this is a "cartridge" filter, so what you are seeing in the photo is the filter cover, not the filter itself. After unscrewing the cover, the actual filter will be inside the cover when you remove it. The new cartridge filter should come with a new O-ring, which you will place on an indentation on the filter cover. Be sure to liberally lubricate the new O-ring with clean oil. Then insert the new filter into the cover, and screw the cover back into the engine. Be very careful that the O-ring stays in place in the cover indentation, and does not slip out to the cover flange. This happened to me once, and even though the cover was properly torqued, when I started the engine, the O-ring popped out and oil sprayed everywhere. The oil filter cover flange should mate right up against the engine, without the O-ring (or anything else) in between. I don't particularly like this design because it makes oil changing a little more tricky than the old fashioned spin-on filters.

I raised the front wheels about 5 inches using ramps. Without raising the vehicle, I think it would be extremely difficult to get under there to access the filter.

Posted on Sep 08, 2012

  • 1861 Answers

SOURCE: fuel filter location

The oil filter is in an aluminum cylinder on the engine. It is not a "spin on" filter, it is now a cartridge-type filter. When you get one, make sure that you use the new o-rings provided in the filter box. The fuel filter is in the tank. Hope this helps, the graciousness of a FixYa rating would be appreciated. Thanks.

Posted on Dec 09, 2008

  • 4793 Answers

SOURCE: I want to change oil

the oil filter is between the firewall and the engne,you get to it from under the car,stick a screwdriver through it and turn to remove,smear the new seal with oil and replace hand tight.after filling with oil start engine and check for leaks.

Posted on Oct 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is oil filter located on 2011 Toyota tundra 5'7l


Mark, Complete instructions on how to oil and filter change link below.
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
DIY Oil Change pics 5 7L

how to change the oil on 2009 toyota tundra

Oil Filter Change Toyota Tundra 2007 2013 2007 Toyota Tundra 4 0L V6

Feb 29, 2016 | Toyota Cars & Trucks

1 Answer

Rattle noise at idle. Gets less as eng r p m increases-97 toyota camry


how is the engine oil ? when was it last changed as old oil is less effective , try an oil and filter change , but a hard rattle as you describe it may be something ,not more serious , but maybe a loose drive belt or some thing that when engine revs increase's it becomes noticable though is still there ,if oil change makes no difference have a good listen around engine also underneath to try to narrow down location , hope this helps keep me posted if you wish

May 20, 2014 | 1997 Toyota Camry

1 Answer

I want to change oil in Toyota collora ae110, i cant locate the oil filter. Where is the oil filter located. What are the precausion to take during the oil change.


the oil filter is between the firewall and the engne,you get to it from under the car,stick a screwdriver through it and turn to remove,smear the new seal with oil and replace hand tight.after filling with oil start engine and check for leaks.

Oct 01, 2010 | Toyota Corolla Cars & Trucks

1 Answer

Where is the oil plug for my 2007 highlander? and the oil filter


give these websites a try www.alldatadiy.com and www.autozone.com if all fails stop by your local Toyota dealership in the parts department and they be able to print you off pictures and diagrams showing you where it is located wish you the best of luck Michigan Man.

Mar 02, 2010 | 2007 Toyota Highlander Hybrid

3 Answers

Where is oil filter on the 200 diesel toyota


The engine has the filter on the left hand side halfway up the
block,actually sitting face down.

Oct 30, 2009 | 2009 Toyota Land Cruiser

1 Answer

Where is the oil filter located on my 2010 V6 Camry


Not to be mean... But if you can't locate the oil filter cartrige housing, which is located beside the engine, toward the top side of the engine bay, with the round cap that has a oil can stamped on it... Maybe you should have a certified Toyota mechanic service your car. Not all cars have a visible "Spin on" traditional oil filter. Newer Toyotas (and many other new cars) have oil filtering cartriges. They are in filter housings and can be accessed via a spin on cap. (this is not the oil fill cap typically found on the valve cover. Do not fill the engine oil through the oil filter housing.) Removing these can make a large mess, requires the replacement of at LEAST one critical o-ring, and should be done AFTER the oil has been drained. Good luck

Oct 10, 2009 | 2009 Toyota Camry

4 Answers

Location of oil filter on 2007 toyota avalon


the 2007 avalon has a cannister oil filter loof under the passenger front of the car youl see the oil pan and drain plug its just in front of the oil pan towards the front of the car its metal casing with a small square in the center thats where youl need a 3/8 exstension and ratchet to loosin the cap to change the gasket for the cap when you get your oil filter it comes with a small plastic piece so you can drain the oil out of the oil filter case, to change the oil filter itself you need a toyota specific oil filter tool to loosin(can get at any toyota dealer run about 20 bucks) take the filter out change the gasket around the case and thats it hope this helps

May 03, 2009 | 2007 Toyota Avalon

1 Answer

2009 toyota corolla,location of oil filter


If this is the V6 engine, your oil filter should be a canister type filter, it should be located on the passenger side, underneath at the front of the engine. You should see what looks like a black cap (about the size of an oil filter) your oil filter is located inside this canister. Hope this helps.

Mar 09, 2009 | 2004 Kia Rio

1 Answer

Fuel filter location


The oil filter is in an aluminum cylinder on the engine. It is not a "spin on" filter, it is now a cartridge-type filter. When you get one, make sure that you use the new o-rings provided in the filter box. The fuel filter is in the tank. Hope this helps, the graciousness of a FixYa rating would be appreciated. Thanks.

Dec 09, 2008 | 2008 Toyota Avalon

1 Answer

2006 Toyota Tacoma V6 engine oil sensor location


There is not enough flow at the sensor for a second oil filter. The sensor is at a dead end in the oil gallery. I recommend that you persue other options here. If you are concerned about oil contamination, don't be. There is nothing better than the factory filter...Look into adding more oil capacity; Look into an engine oil cooler; there is really no need for a second filter.

Sep 07, 2008 | 2006 Toyota Tacoma

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...