Question about 1996 Chevrolet S-10 Pickup
I'm trying to find where the Heater Blower Relay is located...I have the one that is round and has 4 prongs....Where can I find it ??
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
For location and replacement of the BMR. Remove the shroud below the glove box, 2 screws and a snap-pop fitting. Be careful of the courtesy light. Remove the blower moter and disconnect the power harness - - you'll need this extra room to work with. 2 more screws, same size, 7/32, 6.5, 7or 8mm on some, that holds the blower motor resistor in place. This replacement part is less than 40 bones at most parts store. Unplug, replace, re-install, test and you're on your way with about 2 hours of slow paced effort in your own driveway. Typical cost at a garage/dealer - up to $400.
Posted on Mar 19, 2009
It is on the passenger side, you have to remove the black plastic kick plate, below the glove box, to expose it (held in place with 2 latches and 1 push pin). The resistor is in front of the blower motor ( sandwiched between the motor housing and the firewall) it is tricky to get to, i think when i changed mine i didnt replace all the screws as they were difficult to remove and even harder to replace. Good Luck, Mike
Posted on Apr 20, 2009
If your door locks are not working and your cigarette lighter is also not working the fuse is burned out. On my 2001 astro van it is #13 in the fuse box under the steering wheel. I have replaced mine and so far no problems. Good Luck.
Posted on May 29, 2009
The blower motor resistor card is located under the glove box. You have to take the bottom panel from underneath the glove box out(be careful not to break the wire clip that holds the wires in place on that panel). Once you take the panel loose look in the back. You will see the blower motor. Behind the blower motor is the card. You will need a 9/32 for the panel and a 7/32 for the card. It is only 4 screws total to remove and 2 wire harness clips. It is about a 15 minute job. Good luck and hope this helps. Auto Zone has the part for around $15.00 and will have the step by step instrutions for you also if you need it free of charge. I think the dealer charges $109.00 for this repair.
Posted on Jun 17, 2009
if it works only on high speed you need a blower motor resistor you will find it close to the blower motor has three wire to it and looks like a small 1 inch by 3 inch piece of computer board material with two screws holding it.once you get it off you will find that one of the springs has lost contact.
Posted on Jan 27, 2010
Testimonial: "great thanks"
Tips for a great answer:
Dec 03, 2016 | 2003 Mitsubishi Diamante
Jan 01, 2015 | Mitsubishi Cars & Trucks
Jan 27, 2011 | 2002 Mitsubishi Diamante
Jan 12, 2011 | 2001 Mitsubishi Diamante
Nov 10, 2010 | 2002 Mitsubishi Diamante
Oct 21, 2010 | 1992 Mitsubishi Diamante
Jul 21, 2010 | 2002 Mitsubishi Diamante
Mar 03, 2010 | 2002 Ford E350
Jan 07, 2010 | 1997 Mitsubishi Diamante
59 people viewed this question
Usually answered in minutes!