Question about Hyundai Elantra

Open Question

How to replace the P2195 sensor in a 2005 Hyundai Elantra

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
michigan man
  • 3533 Answers

SOURCE: oil change procedure on a 2005 Hyundai elantra

it is very easy to change the oil put the car on ramps secure the back end look for the drain plug underneath the engine make sure you have the right size wrench and when you remove the plug also check the gasket on the plug to make sure it is not cracked you will also need an oil filter wrench and my other suggestion to you is to go to autozone to see if they have a Haynes repair manual for your car and if they don't see if they can order you one in the mean time they can also print you off a diagram of how to change the oil in you car safely

Posted on Jan 20, 2009

Ad
  • 94 Answers

SOURCE: How to replace 2004 Hyundai Elantra starter

First, disconnect the battery. Then the only part that needs to be removed to access the starter is the rubber air plenum boot between the throttle body and the air filter housing. This allows enough room to get an arm in there to access the 14mm bolts that attach the starter to the transmission. After removing the bolts, the starter can be removed from underneath the car. lower it down as much as possible, and unbolt the power cable. You may have to twist and turn it a bit to get around the support between the engine block and intake manifold, but it will come out.

Posted on Feb 07, 2010

  • 1024 Answers

SOURCE: replacing map sensor in 2001 hyundai elantra

it's mounted on the plenum to the left of idle air control valve

Posted on Mar 16, 2010

ZJLimited
  • 17970 Answers

SOURCE: need fil for error code P2626 Hyundai Elantra GLS

P2626 O2 Sensor Pumping Current Trim Circuit/Open (Bank 1 Sensor 1)

I'll sure this has to do with a faulty O2 sensor. This sensor is usually located around the header of your car, or down more on your exhaust.

Try disconnecting your battery for 30 mins, hook it back up, and start your car again. This will erase the error. See if it comes in again.

Hope this help (remember rated this post).

Posted on Mar 25, 2010

  • 171 Answers

SOURCE: how to replace 2002 hyundai elantra hub and bearing

With the car on ground, break loose the drive-axle nut, and the wheel nuts , than jack up the car, support it properly, remove the wheel ,remove the axle-nut.
Remove the brake caliper assembly-- support it properly.
Remove the two bolts that hold the hub bracket to the Macpherson strut assemble, remove the lower arm ball joint and remove the steering tie- rod ball-joint attached to the hub bracket. That's it.Slide off the hub /with the bracket off the drive-shaft.
Follow steps backwards to assemble back.

Posted on Apr 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have an 04 Hyundai Elantra GT that throws a OBD2 code p2195 and p1166. What do I do to fix these error codes? And is it as simple as changing the Upstream O2 sensor? Thank you


Probly not..sensors should only b replacd if heating element bad. Changing other items must b done w caution unless theyr cheap. A scan w a vehicle specific or factorytool will direct u whats occuring. Only honest private shops havthem. Partstore scanners dont suffice

Aug 19, 2016 | Hyundai Cars & Trucks

1 Answer

2005 hyundai elantra alarm is going off at random


Could be a bad sensor in the vehicle body that's on it's way out.

Jan 27, 2013 | 2005 Hyundai Elantra

1 Answer

How to change the p2251 o2 sensor on 2005 hyundai elentra


I've supplied a generic tutorial on how to replace an oxygen sensor. It should take you from 15-30 minutes even less if there is little or no rust.

May 30, 2012 | 2005 Hyundai Elantra

1 Answer

Have a 2005 elantra running a p2195 code bought the o2 sensor but cant find where it goes from the looks of it and what i have been told this car has 4 o2 sensors the code says it is bank 1 sensor 1 where...


Bank 1 is the same side as the number one cylinder, bank two is the other side of the motor. Sensor 1 is always before the catalytic converter, sensor 2 is always after the catalytic converter. So bank 1 sensor 1 would be on the same side of the motor as the number one cylinder and before the catalytic converter.

Sep 24, 2010 | Hyundai Elantra Cars & Trucks

1 Answer

2004 Hyundai Elantra - P2626 and P2195


Your transmission is slipping which can cause a huge amount of damage both to the car and your wallet. Take it in for service as soon as you can.

Jun 21, 2010 | 2004 Hyundai Elantra

1 Answer

Need fil for error code P2626 Hyundai Elantra GLS


P2626 O2 Sensor Pumping Current Trim Circuit/Open (Bank 1 Sensor 1)

I'll sure this has to do with a faulty O2 sensor. This sensor is usually located around the header of your car, or down more on your exhaust.

Try disconnecting your battery for 30 mins, hook it back up, and start your car again. This will erase the error. See if it comes in again.

Hope this help (remember rated this post).

Mar 25, 2010 | 2005 Hyundai Elantra

1 Answer

Problems rplacing car stero


Check all your fuse in dash & under hood for a blown one.

Mar 22, 2009 | 2005 Hyundai Elantra

1 Answer

My engine light came on. error codes show P2195 and P1166


The fuel pump is vapor locking, common problem in high temp/altitude states. Call the dealer and see if campaign t-13 applies to your car, if the car was originally sold in a low altitude state, it won't apply. I recommend the fuel pump be replaced with updated fuel pump sub assy.

Mar 21, 2009 | 2004 Hyundai Elantra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8582 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...