Question about Cars & Trucks

Open Question

Steering angle sensor reset. How? on Can am Spyder

Steering position sensor is faulty and puts machine into Limp home mode. Can it be disconected while waiting for new unit to be fitted. How hard is it to properly install new unit when available.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: code c1277 (steering angle sensor)

this vehicle uses a steering control module and the antilock control module. Both modules get a signal from the steering angle sensor. We found that the steering module didnot show a steering sensor code but the ABS module did show the code.
after checking that the wiring was intact and with good continuity, it was determined that the fault lies in the ABS module.
A new ABS module and configuration confirmed the diagnosis. It's fixed!

Posted on Aug 07, 2008

Ad
  • 23 Answers

SOURCE: I have a 1993 Jaguar

clean the idle motor with carby cleaner

Posted on Apr 20, 2009

  • 186 Answers

SOURCE: play in the steering wheel column after position adjustment

When they did the alignment it's possible that they used a tool that locks the steering wheel straight while it's on the alignment rack.If they put too much pressure on the wheel when they used the steering wheel seat lock tool it may have stressed you tilt lock mech causing it not to lock where you want it.Hope this helps

Posted on May 16, 2009

  • 128 Answers

SOURCE: will steering angle sensor trigger vsa

the steering angle sensor is used as one of many inputs on honda's vehicle stability assist system. so in short yes. hope this helps

Posted on Jan 27, 2010

steve_e_uk
  • 1675 Answers

SOURCE: 2006 BMW 320i E90 steering angle sensor light

hi you can only reset these with a diagnostic tool you can purchase cheap ones on the net, look for OBD2 or OBD ll tools....ebay is a good place, but do not get the ones that connect to computer get a hand held one...hope this helps

Posted on Jun 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i rove the clock spring 2012 nissian par\th finder


remove clock spring in steering wheel.
step 1 , disconnect battery minus lug.
then defeat air bags as the FSM book directs,(or great danger waits)
BOOM
Battery disonn.folly 110. "under collateral damage"

quote
Whenever the negative battery cable is disconnected the following components will require resetting. The Idle Air Volume Learning, Steering Angle Sensor Neutral Position, Sunroof Memory Reset/Initialization, Automatic Drive Positioner System, Audio presets and Navigation. Use the CONSULT-III diagnostic tool, or equivalent to perform the required resets. As necessary, refer to Battery Reconnect/Relearn Procedures.
he automatic back door system, if equipped, must be initialized anytime the battery has been disconnected. Close the back door. Open the back door with the automatic open feature. Do not stop the process until the back door opens completely.
end .

begin:
  1. Disconnect the negative battery cable. (wait 30min)
  2. Disconnect the positive battery cable.
  3. Set the front wheels in the straight-ahead position.
  4. Remove the air bag module.

  1. Remove the steering wheel.
  2. Remove the column cover upper and lower.
  3. Disconnect wiper and washer switch connector. Then while pressing tabs, pull wiper and washer switch away from spiral cable to remove.
Disconnect lighting and turn signal switch connector. Then while pressing tabs, pull lighting and turn signal switch toward driver door to remove.
  1. Remove the screws. Then while pressing the tab, pull the spiral cable away from steering column assembly. CAUTION Do not disassemble spiral cable. Do not apply lubricant to the spiral cable.
  2. Disconnect the spiral cable connectors.
With the steering linkage disconnected, the spiral cable may snap by turning the steering wheel beyond the limited number of turns. The spiral cable can be turned counterclockwise about 2.5 turns from the neutral position.
end remove.
to install, read the FSM book
or login to alldata.com


the cars steering angle is lost in the process.
so.....?????
steering angle sensor calibration after installing spiral cable.

Jun 25, 2014 | 2002 Nissan Pathfinder

2 Answers

How do i get my 2005 isuzu forward truck out of limp mode


OBD connection under dash near Steering column.. go to a auto zone or orillies and let them read the codes for you.

Jun 03, 2014 | 2001 Toyota Avalon

2 Answers

How to reset sensor


The steering angle sensor is faulty and should be replaced. Once replaced it will need to be coded with a special tool. There is not a way to reset the sensor without the special tool.

Mar 19, 2014 | 2008 BMW Z4 2.0i

1 Answer

How to reset sensor


Steering angle sensor can only be reset with a special diagnostic tool. Sorry.

Mar 19, 2014 | 2008 BMW Z4 2.0i

1 Answer

2001 passat 1.8 car starts fine but has no power and when you push on accelerator pedal and hold it steady the rpms will rise another 1000 rpms or so.fuel pump and regulator check out fine.


APP sensor went to limp home mode. The APP or throttle control uses to angle sensor when one sensor does not report it goes to limp home mode.The ECM cross checks the throttle angle so one is off. The late module assembly that is used is mounted to the floorand was more damage from spilled drinks. some where water damage the majority where coffe damage.go to the floor pedal position gain acces to the connector the inside connector may be contaminated,if you decide to clean it youll need a electrical cleaner clean the inside connectors, with the engine off.

Apr 27, 2011 | 2001 Volkswagen Passat

1 Answer

Recode steering angle sensor


For recode the steering angle sensor you must connect a diagnosis scantool to the data link connector of the car in order to access the ESP ECU (Electronic Control Unit), in other words programm again the steering angle sensor in the ESP ECU. Select the steering angle sensor programming (learning) menu, and follow the steps: put steering wheel in straight direction, then turn steering wheel to the left direction less 15 degrees, then to the right direction less 15 degrees, put steering wheel in straight direction again until the programming was done. Then the ESP light will turns OFF.

Aug 20, 2010 | Audi A6 Cars & Trucks

1 Answer

My steering wheel is adjusting itself while in drive and static


Read the owners manual on resetting your door control seat preference this will include steering column and pedal adjustment if installed on your 7.

Jul 02, 2009 | 2000 BMW 7 Series

1 Answer

My 2001 kia magentis v6 (same as hyundai sonata) sometimes get stuck at 3000 rpms and wont shift unless i put it in manual shift mode. i can get it to shift then but it still wont rev past 3000rpms. i...


dear friend-when your vehicle wont rev it means that it went into limp mode and by disconnecting the battery you reset the ecu and will appear ok till the faulty sensor comes up again,have a dianostic test carried out to sole,previble when in limp mode.

Jun 29, 2009 | 2001 Hyundai Sonata

2 Answers

Service steering system 98 deville


please have the car put on diagnosis machine so that it can be seen exactly what the problem is! could be the steering angle sensor calibration!

Jun 18, 2009 | 1997 Cadillac Eldorado

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...