Question about 1999 Chevrolet Tracker

Open Question

2000 big bear 400 cuts out when i accelerate - 1999 Chevrolet Tracker

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I need the big end torque on the Rocam engine please


A cheap shop manual will have this and much more. If you are in this deep you probably need one.

Sep 05, 2016 | 2000 Ford Ka

1 Answer

Why does my 2000 camaro 3.8 have a random surge during acceleration when the Asr is turned on?


ASR is your traction control, the reason why you have a surge is that the ASR is calculating how much force to give to each tire based on sensor data, and this takes time. When you turn it off, the acceleration is treated like any other car with out traction control. The 2000-2003 Camaro had one big complaint, a laggy traction control. You could potentially fix this by replacing the computer unit with a faster aftermarket model and changing sensors out with more efficient models, also tuning the engine can help reduce lag time or acceleration delay.

Jan 28, 2015 | 2000 Chevrolet Camaro

1 Answer

Dursngo sounds like a valve or rod when acelerate and running bad


If it knocks heavy under acceleration it will be a big end first or a main second. Disconnect each plug wire until there is no knock under acceleration and that will point to the piston and big end that is faulty. Remove the sump and that big end bearing and if the crank is still good replace the bearing. As you cannot get a single bearing shell then it may be a good idea to replace all the big ends . On the back of the shell will be the size of the bearing in thousands of an inch so if it says .002" then you need shells that are that much over size. Take a shell into a spares department and just ask for bearings that match that shell.

Jan 22, 2014 | Cars & Trucks

1 Answer

Passat 1.9 tdi 116 ch 2000 engine ticking/knocking noise


Are the pieces aluminium? Piston. Steel? rings/oil pump etc or white metal? big ends.

Apr 11, 2017 | Volkswagen Passat Cars & Trucks

1 Answer

Whats the torque setting for big end bearing bolt and cylinder head bolt for toyota corolla 12 valve 2E,1990.


hi big end bearings are two stage, 25nm leave ten mins, then 49nm cylinder head bolts three stages 20nm leave ten mins, 40nm leave ten mins then 60nm check after 5,000miles hope this helps

Apr 07, 2010 | 2000 Renault 181

1 Answer

Remove the Center Support Drive Shaft Bearings


use a cutting wheel and cut through the bearing as far as you can without damaging the drive shaft.Then get a big hammer and a chisel drive the chisel into the cut and break the bearing.

Jun 25, 2009 | 1983 GMC S-15 Pickup

1 Answer

L Reg Vitara engine knock


if anything id say it was the bearing

Jul 06, 2008 | Suzuki Vitara Cars & Trucks

Not finding what you are looking for?
1999 Chevrolet Tracker Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...