Question about Toyota RAV4

Open Question

How to replace a blower motor on a 2011 toyota rav4

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 337 Answers

SOURCE: 2001 Toyota RAV4

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528019c315

Posted on Dec 17, 2008

Ad
mx5turbo92
  • 545 Answers

SOURCE: How do you replace blower motor on 2000 toyota

REMOVAL

  1. REMOVE GLOVE COMPARTMENT DOOR
    1. REMOVE BLOWER MOTOR
      1. Disconnect the connector from the blower motor.
      2. Remove the 3 screws and the blower motor.

INSTALLATION
Installation is in the reverse order of removal.

Posted on Jun 04, 2009

  • 1 Answer

SOURCE: how to replace a fuel pump on a toyota rav4 1998

you need to remove the rear seat to get to it, just keep in mind the system is preasurized, which in english means you need to loosen the fuel filter in the front of the car first, "THIS IS CRITICAL" if not you will cause gas to get all over the interior. The 96-00 rav4 has a hatch under the carpet, under the seats in the rear. it is a pain to get to, once you remove the seats and carpet you will see it. I would recomend you bring it to a dealer if you dont know what you are doing. But if you are like me and figured what the hell, then you will want to take these steps first...
1. Let the car sit for a long period of time, about 3 hours or more.
2. Have a low amount of fuel, do not have a full tank
3. loosen the gas cap
4. Remove the intake, and the fuse box,
5. Loosen the top nut on the fuel filter under the hood to let out the remaining pressure, do not loose the O rings. This is a good time to replace that filter too, it is about 30 bucks from toyota.
6. open the hatch in the rear,
7. remove the electric feeds from the pump.
NOTE: YOU CAN REMOVE THE POWER FROM THE PUMP AND START THE CAR TO TAKE OUT THE PREASURE, BUT I FOUND IT BETTER TO DO IT MY WAY DUE TO WHAT IT TAKES TO START IT AFTER YOU DO THIS.
8. line the floor of the rav with Plastic, bags, or cardboard, or something.
9. remove old pump
10. install new pump
11. Re attach the fuel filter or install new filter
12. get car back together enough to start it, make sure you have all the lines connected, if not gas will get everywhere...
Good Luck, it was a FUN adventure to do this...

Posted on Aug 26, 2010

  • 878 Answers

SOURCE: where can i order the manuals for a 2011 toyota

chilton.com

Posted on Feb 23, 2011

  • 3640 Answers

SOURCE: I need to replace rear tail light assembly on 2011 Toyota RAV4 how is easiest way to do this?

take out the side plastic cover (between back seat & the tail light)
and take out the smaller black cover. hope this helps you !

Posted on Dec 03, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 Toyota Rav4 blower motor not working


Confirm that you have power reaching the motor windings. If positive, then the anomaly is centered around the motor.

Feb 21, 2016 | Toyota RAV4 Cars & Trucks

2 Answers

My a/c blower motor only works on 2 and 4 speeds. and i have to jiggle the speed knob for it to work. what may be the cause ?


Sounds like you need a switch for one part and possibly a blower motor resistor or controller. Same

Dec 11, 2014 | 2006 Toyota RAV4

1 Answer

How do you change a blower motor control switch `


you must replace head unit, as an assembly no way arround that I know.

Aug 07, 2012 | 2007 Toyota RAV4

1 Answer

Blower motor switch


The blower motor switch on your car lets you control the power to your blower motor. The blower motor is a small motor that blows out hot or cold air through your vents. If the switch goes out, you will not be able to control the blower motor. This can lead to miserable conditions in the vehicle in either extreme hot or cold weather. The switch is not hard to replace and will take about an hour to change.

Read more: Car OBD2 diagnostic

Aug 07, 2012 | 2007 Toyota RAV4

1 Answer

I need to replace rear tail light assembly on 2011 Toyota RAV4 how is easiest way to do this?


take out the side plastic cover (between back seat & the tail light)
and take out the smaller black cover. hope this helps you !

Dec 03, 2011 | 2011 Toyota RAV4

1 Answer

My car is RAV4 toyota blow fan not working on 1,2,3 but #4 working only I replace switch but same as before,Please would give what I do next. Thank you.


Sounds like you have a bad blower motor resistor (manual HVAC). The resistor is just that a set of resistors in serious that drop voltage to regulate fan speed. Speed one uses all the resistors to drop the voltage the most. Speed for doesn't use the resistors so full power can be used by the blower motor to make it work at full speed.

The resistor is typically located near the blower motor under the passenger side of the dash. and will have 4-5 wires going to it.

Apr 20, 2011 | 2007 Toyota RAV4

1 Answer

Heater blower only works on hi speed Rav4 (2004)


I don't know much about Toyota's but, usually when the fan only works on high it's because the blower motor resistor is bad. When you have the fan on high it puts full battery voltage to the motor. When you have the switch set in any other position, the battery voltage is routed through the resistor. When that happens the voltage to motor is redeuced through a series of resistors giving you the different speeds. The resistor is usually in the duct work fairly close to the blower motor. Good Luck!

Dec 20, 2009 | 2004 Toyota RAV4

1 Answer

How do you replace blower motor on 2000 toyota rav4?


REMOVAL

  1. REMOVE GLOVE COMPARTMENT DOOR
    1. REMOVE BLOWER MOTOR
      1. Disconnect the connector from the blower motor.
      2. Remove the 3 screws and the blower motor.

INSTALLATION
Installation is in the reverse order of removal.

Jun 04, 2009 | 2000 Toyota RAV4

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8572 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...