Question about 2009 Buick Lucerne

Open Question

Buick lucerne fuel pump relay - 2009 Buick Lucerne

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 99 Answers

SOURCE: 95 Buick Fuel Pump Fuse or/and Relay Locaton

fuel pump relay located in relay center under hood at center of firewall

Posted on Nov 30, 2008

Ad
  • 48 Answers

SOURCE: relay location on a 98 Buick LeSabre?

look on the firewall in the middle area been a while since i worked on one of those vehicles , relay rail shoud be behind the engine

Posted on Dec 17, 2008

bluelightnin
  • 35 Answers

SOURCE: Fuel relay placement 1991 Buick LeSabre. Replaced pump & filter still won't start

Your vehicle's fuel pump relay is located on the relay center, behind the glove box, 2nd column of relays, 2nd one from the top.

Posted on May 23, 2009

  • 7 Answers

SOURCE: how do you access the windshield washer pump on

The washer pump is located on the bottom of the wash fluid bootle. you can access it by removing the front passanger fender liner..

Posted on Jan 12, 2010

  • 27 Answers

SOURCE: 2003 Buick Lesabre Custom Need to

You can release the fuel pressure at the fuel service port on top of the engine. Be sure the engine is cold and you hold a good rag under it. No need to remove relay if key is off.

Posted on Sep 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2009 buick lucerne washer pump not working changed pump and fuses are good


Before changing the pump did you test for B+ voltage at the pump and check the ground circuit . Jump B+ voltage to see if it runs ? Does it have the heated washer system ? How about the washer relay , did you check it ?
With the ignition in the ON position, accessory voltage is supplied through the 25A WPR fuse to the WIPER relay, the WIPER HI relay and the WSH relay that are all located in the under hood fuse block.

Dec 19, 2016 | 2009 Buick Lucerne

1 Answer

How do I remove the fuel pump relay switch?


You may have to remove others to get to it. Just wiggle them back and forth as you pull them up .

May 25, 2015 | 2008 Buick Lucerne

1 Answer

11 buick lucerne is blowing fuses going to the fuel pump, it must be something to do with the starting of the car that does this. Any ideas?


Could be either a bad pump drawing to many amps, or a bad relay, or any push connector which has corroded, even a ground wire.

Jan 08, 2015 | Buick Cars & Trucks

1 Answer

Blower works sometimes in 2007 buick lucerne is it a relay and if so where is it located


I don't believe their is a relay necessarily. sounds to me like the resistor bank in the air ducting close to the heater motor in the dash

Oct 13, 2014 | 2007 Buick Lucerne

1 Answer

Fuel pump relay located at on a 06 buick lucerne cxl 3800


Black fuse box under the hood should be on the battery side.most relays are interchangable depending on the car.that's where id look hope this helps

May 29, 2014 | Cars & Trucks

1 Answer

How do i bleed the fuel line on a 2011 buick lucerne. FYI I just replaced the fuel pump


To bleed a John Deere 2240, find the bleeder port on the injector port. Crack open the bleeder port while you're pumping the handle on the fuel pump or cranking the engine. Keep pumping until you get a steady stream with no air. Be sure to keep pumping while you're closing the bleeder port screw. If you can't get it to run right after bleeding the pump, you may have to bleed the injectors. Just crack the nut loose on the injector and start pumping. Keep on bleeding until all the air is out.


----------------------------------------------------------------------------------------------
FGTech Galletto 2-Master EOBD2

Dec 19, 2012 | 2011 Buick Lucerne

1 Answer

How to replace water pump on 2006 buick lucerne with 4.7l northstar engine


Remove air box & air tube loosen throttle body 2 clamps disconnect Hoses on pump area remove rear cover 4 10mm bolts from rear of pump disconnect two bolts on housing bottom then 4 bolts on center housing two more are on lower rear between eng & tranny the other two are front lower 8 total remove nut fuel line clamp disconnect Wiring move housing out pump area 2-3 inch disconnect tensioner & remove water pump 5 x 10 mm bolts install new pump & reassemble good look 2-3 hours

Apr 23, 2012 | 2006 Buick Lucerne

1 Answer

Hi, where is the fuel filter in my 2009 Buick Lucerne with a 3.9?


Hi There.
you may have to check in the trunk for an inspection panel or remove the gas tank to get to the fuel pump.

May 01, 2011 | 2009 Buick Lucerne

Not finding what you are looking for?
2009 Buick Lucerne Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...