Question about Cars & Trucks

Open Question

Lesco GT 642 Will not start - Cars & Trucks

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the glow plug relay fitted on a mercedes cls 320 diesel


If its the v6 642 diesel its located on the front left hand of the engine
its a black box a bit bigger than a cigarette packet with a large 12v connector lead going into it and a multiplug with 6 wires

Oct 15, 2014 | Mercedes-Benz CLS Cars & Trucks

1 Answer

Dodge 1500 wont start codes p422 - p522


cranks ok but wont start and battery is charged to 12.6v dc rested?>
and wont jumper cable start>>>>>>??????????????????????
which engine>?
start with gas cap off?
2 problems, if wont start cap off.
tank vent system issues,
522 is the one.
P0522 Dodge - Engine Oil Pressure Sensor/Switch Circuit Low Voltage

the PCM sees no oil pressure and refused to start.
sounds like a winner there. huh.?

ok, so check oil pressure.
if good , then the switch is bad, or wires to it bad, fell off.
Sig: I must ask questions first, I'm blind, and my tools can't reach, dig?

Jun 22, 2014 | 1999 Dodge Ram

1 Answer

2007 380i bmw


check battery terminals sande clean and earth cable to engine clean and good contact >>>>>>>>>>alternatively jump start battery with jumper cables ,if still no response ,can only be starter motor solenoid fault/starter brushes

Jan 13, 2014 | BMW Cars & Trucks

1 Answer

2001 c200 kompressor no start fron intition


flat batttery >>>>>>>>>>>remove battery and get charged up and tested

Jan 13, 2014 | Mercedes-Benz Cars & Trucks

2 Answers

Car did not start


-Can't you crank it...? If so crank and check the rotor. It spin or not?
-If not spin>>> Timing Belt broke.
-If it spins>>>> Now check volatge at coil (Primary line ONLY)
(Two wire that connecto to the coil Only.)
-Any voltage there...?
Yes. >>> Bad coil. Replace it.
No.>> Check engine relay and other fuse .

Mai

Mar 12, 2013 | 1990 Toyota Camry

1 Answer

Car does not want to start. Lights still come on, horn works, radio works. We installed a code master that still beeps when we use it but the car still doesn't want to start. Please help!


Check your owners manual or a repair manual and locate the Ignition Fuses Under the hood and in the passenger compartment), and others that might cause a starting issue. Coils packs, fuel injector, loose vacuum hose, etc. Could be anything.
Remember
F >> FUEL
A >> AIR
S >> SPARK
T >> TIMING
Keep it simple. Make sure your getting fuel, Spark What code were you getting? Have you had an alarm incident recently? Could be the alarm has locked you out even.
Hope this helps

Nov 04, 2010 | 2000 Saturn SL

2 Answers

Car wont run or start motor okay starter okay gauges okay battery okay fuses okay maybe key switch maybe something else


F >> Fuel
A >> Air
S >> Spark
T >> Timing
Have you checked to see if you're getting fuel? Bad injector
Bad Coil Pack(s)?
Are you getting a spark from your spark plugs?
Checked vacuum hoses?
Hope this helps

Oct 21, 2010 | 2001 Buick Century

1 Answer

Radio code for bp 7 642 375 316 bp237534074668


Only a dealer as far as I know and have had experience with, can give you that code as it is a vehicle specific code. Contact your nearesty dealer and give the m the V I N Number for the vehicle and they should be able to give you the code.

Jul 16, 2009 | 2001 Chrysler Voyager

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...