Question about 1999 Mercury Villager
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 99 mercury villager van
Yes, but you need lots of skill and body tools to permanantly repair that. This is caused by owners not knowing that there are tiny drain holes in the bottom of the doors, that get clogged up with dirt. If a person just checked and cleaned them out once a year, with a pipe cleaner.......this would never have happened
Posted on May 28, 2009
Usally its down by the crankshaft pulley, sometimes in the timing chain cover housing, or on a bracket attached to the housing.
Posted on Mar 06, 2010
Hello! The vehicle has a defective Manifold Absolute Pressure (MAP) sensor...It is bolted to the throttle body....It has a three wire connector with the following wire colors...Blue...Pink...And Brown...
It is easily replaced...disconnect connector...Remove line...Remove two bolts ...Cost is $190.Guru.....Saailer
Posted on Sep 26, 2010
SOURCE: I have a 99 mercury
Hi, code 340 is for the camshaft sensor. Below is a test you can run to check the sensor. The PCM is above the glovebox. Do not disconnect or remove the PCM. Just remove the glove box and probe the back of the connector to access the pins indicated in the cam sensor test. Please let me know if you have any questions, and thanks for using FixYa.
On 1999-00 vehicles, the camshaft position sensor must be checked with the engine running. If a no start condition is encountered, observe the MIL. With the ignition switch on and the engine off, the MIL should be illuminated. If the camshaft position sensor is functioning, the MIL should go out when cranking the engine.
REMOVAL & INSTALLATION
The camshaft position sensor is part of the distributor assembly, and must be replaced as a unit. Please refer to Engine Electrical, Distributor Ignition System, Distributor, Removal and Installation for the procedure.
Posted on Mar 12, 2011
Tips for a great answer:
Dec 17, 2015 | 2002 Mercury Villager
Sep 30, 2011 | 2000 Mercury Villager
Jul 31, 2011 | 2001 Mercury Villager
Jul 30, 2011 | 1999 Mercury Villager
Sep 21, 2010 | 1999 Mercury Villager
Jul 18, 2010 | 1999 Mercury Villager
Jun 02, 2009 | 1999 Mercury Villager
Jul 21, 2015 | 1999 Mercury Villager
55 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: