Question about 2004 Chevrolet Malibu Maxx

Open Question

Check rsc light on dash - 2004 Chevrolet Malibu Maxx

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On my 2007 explorer the brake engage when you put the car in drive and the rcs light comes on


Do you mean the RSC light ?
  • Roll stability control (RSC)/interactive vehicle dynamics (IVD)
  • Roll Stability Control (RSC)
    The roll stability control (RSC) system monitors the roll-rate sensor and existing stability assist sensors and calculates if the vehicle may be approaching a situation where rollover is probable. If such a situation exists, the RSC system applies preemptive action. When activated, the RSC system adjusts the brake torque at specific wheels in response to direct measurement of the vehicle roll motion. By adjusting brake torque, the system can reduce the cornering forces and, therefore, the total roll moment acting on the vehicle. Systems with RSC have an additional roll-rate sensor located within the sensor cluster and additional programming within the ABS module to help control the vehicle during sudden maneuvers.
    Information from the roll-rate sensor is fed into the ABS module. The computer uses information from the ABS wheel speed sensors, the throttle position sensor, the steering wheel angle, the steering wheel rate of change and a yaw rate sensor that measures the change in vehicle direction. If the computer determines from all these inputs that conditions exist for a potential roll over, the system applies one or more brakes and reduces engine torque to make the vehicle more stable.
    If the event is severe and the driver's foot is not on the brake, the brake pedal moves to apply higher brake forces. A whooshing sound can also be heard from under the instrument panel in an event this severe .
    I strongly suggest you have this vehicle towed to a ASE certified repair shop that knows this system !

    Sep 19, 2015 | Cars & Trucks

    1 Answer

    Rsc light,abs light,transmission malfunction reduced power light comes on every other day is this normal it seems t


    No--- it is a system fault that has to be diagnosed

    When you turn on the key, all the dash lights should be
    observed & lite ( use your owners manual to get familiar
    with them)

    After the engine starts-- ALL dash lights-- go off, or you have
    a problem with the OBD 2 System, on any vehicle from 1996 on

    ANY TRANS related codes or lights you STOP USING IT

    IMMEDIATELY

    Transmissions are VERY VERY Expensive Repairs & happen
    to way too many people, because they won't give up driving the vehicles & ruin then in a heart beat,ten miles is all it takes

    Mar 30, 2014 | 2008 Lincoln MKX

    1 Answer

    TPS light and advancetrac warning light are on


    ONE U REPLACE THE TIRE BACK TO THE REGULAR TIRE U HAVE TO CHE THE SENORS ON THE BREAK AREA AND THE UES THE SCANNER TO RESET TO COMPUTER

    Nov 29, 2013 | 2005 Ford Explorer

    1 Answer

    The skidding tire symbol came on along with a bussing sound and a message" SERVICE RSC NOW' WHAT do I need to service this.


    RSC stands for "roll stability control". It means there is something wrong with your ABS braking system and other than not having ABS brakes it's safe to drive . Get it checked at your convenience.

    Oct 24, 2013 | Cars & Trucks

    1 Answer

    RSC ABS Light on


    I would try unplugging the connector to the ABS Module
    You will have dash lights on, but can use the truck,the brakes
    will work,you just won't have ABS
    Then plug it back in
    If you still have a MIL lamp
    You go to a shop,different one & not a dealer,& ask them to scan for codes in Enhanced Mode & just look at the ABS System Codes/Faults
    Then Google the issue, or look at the shops data base, for
    the proper way to diagnose.
    To say entire system-- is just you not knowing what is going
    on, or what your told,need to be more involved & ask
    more questions & get people to show you & prove to you,
    how they come to any conclusion or fix.
    I found the B1342 code is used for different systems,
    which is odd, & different vehicles,so be careful your looking
    at the correct vehicle,application etc on the internet
    At a shop with the scan tool your looking into the vehicles
    system & can't get that wrong
    Just know that codes do not mean a part failed
    Component testing for failure is required
    At very least do voltage drops on power & ground
    side of any module, using a wiring diagram, before
    throwing electronic parts at something & get it wrong

    Jul 20, 2013 | 2008 Ford Explorer

    1 Answer

    I took my middle console apart to fix my new stereo but when I put it back together I forgot which connector was for the rear defrost button. I have a 1999 Mercury Cougar. They all look the same


    I appreciate any ideas that will help me diagnose what is tripping the warning light for the ABS/RSC system. I have a 2008 Explorer, 4x4 drive, with the V6 engine. It has just over 124,000 KM on it.
    The ABS RSC warning light and beeping occurs on occasion as well. If I go really easy on the brakes, all is well.
    I have Inspected all brake pads. They looks ok, . I have also inflated the tires so that they are perfectly equal.
    Both the ABS and the RSC warning lights turn on.When i check with one work shop, they scanned and they found B1342 error code, and they said i need to replace entire ABS system.
    Can anyone help?

    Jul 20, 2013 | Cars & Trucks

    1 Answer

    RSC service now


    I appreciate any ideas that will help me diagnose what is tripping the warning light for the ABS/RSC system. I have a 2008 Explorer, 4x4 drive, with the V6 engine. It has just over 124,000 KM on it.
    The ABS RSC warning light and beeping occurs on occasion as well. If I go really easy on the brakes, all is well.
    I have Inspected all brake pads. They looks ok, . I have also inflated the tires so that they are perfectly equal.
    Both the ABS and the RSC warning lights turn on.When i check with one work shop, they scanned and they found B1342 error code, and they said i need to replace entire ABS system.
    Can anyone help?

    Mar 10, 2013 | 2008 Mercury Mountaineer

    2 Answers

    Alarm sound every 5 min for rsc problem. Probably a censor but I want to pull fuse to temp stop alarm until I can get van to the shop for permanent repair


    Sorry there is not a fuse for this, not even the noise maker. It is controlled by a computer.. There are fuses for them. most likely if you pull the fuse it will kill the engine.( No start).

    Jul 03, 2011 | Ford E-350 Cars & Trucks

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    16 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chevrolet Experts

    yadayada
    yadayada

    Level 3 Expert

    75066 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22095 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    7754 Answers

    Are you a Chevrolet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...