Question about 1989 Mazda B-Series

Open Question

Mazda B1600 will not start but it cranks and its a carboretor car

Posted by Anonymous on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Gearbox oil capacity for a 1983 mazda B series pick up, b1600

my lube chart says 1.5 ltrs grade 80w/90 for manual 4/5 speed diff 1.2ltrs 90w

May 12, 2017 | Mazda Cars & Trucks

1 Answer

Gearbox oil capacity 1983 mazda B1600 pick up

There's a plug on the side of the trans you need to take out that is the proper level. That's where you put the oil in and when it won't take any more and runs out same hole, put the plug back in and done.

May 12, 2017 | Mazda Cars & Trucks

1 Answer

What is the adjustment of tapits in mazda b1600 gas

1586 cc engine is:

Valve side .012 inches (.30mm) on intake and exh
Cam side .009 inches (.22mm) on intake and exh

1272 cc engine is:

Valve side .010 inch (.25mm) intake ..012 (.30mm) exhaust
Cam side .007 inch (.18mm ) intake .009 (.22mm) exhaust

Jul 27, 2016 | Mazda Cars & Trucks

1 Answer

What are the probable causes of DTCs B1600, P0113, and P0179?

At some time since last clear the ignition was switched on without any key code being read.

Intake Air Temperature Sensor 1 Circuit High Bank 1
Fuel Composition Sensor Circuit High
In the back of the trunk of these cars are a box on the left hand side looking in the truck under the cosmetics of the floor, lift all that up and you will see a small box that you can reset, that goes out and you can not start the car, that goes to your fuel pump. Try, hope that is all that it is, because the codes do not reflect the starting problems you are having. Good Luck!

Nov 29, 2015 | 2000 Ford Focus

2 Answers

2004 jaguar x type car was running fine stop for an errand but when i came back c ar would not start not even crank got a message that security failed run it thru obd computer came up with codes B1600 ,...

nevr evr go to a dealer-most cant fix a bicycle--u need a data stream run w factory gear that shows values of components to pin point--ask a private shop if they do this-code readers are just general---try disconnectin computer by pulling the plug-then reconnect and see if car reboots-a shop trick for older cars

Apr 19, 2014 | 2002 Jaguar X-Type

1 Answer

My toyota corolla does not start normally unless i spray fuel inside the caburator please help to solve this problem.

is it a carboretor or is it fuel injection if a carboretor probably a sticking flote easy to do just remove it and clean if its fuel injection get the fuel pump checked or injectors

Sep 26, 2012 | 1990 Toyota Corolla

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts


Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides