Question about Cars & Trucks

Open Question

Wh ls1 statesman v8 auto 2000 the battery light stays on while driving an notice when I got home the was smoke coming threw the air clearn also loose all power to dash an gages

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 2039 Answers

SOURCE: dash battery light

get the charging system check before you stall with it normally the alternator is not charging hope it help fixya our post thanks pierre

Posted on Jul 12, 2008

Ad
  • 147 Answers

SOURCE: Dash Gages

bad altenater or short in wiring

Posted on Nov 15, 2008

  • 14036 Answers

SOURCE: Steering hard /loosing pwer at 40-55mph

check power steering hoses. for leak it sound like fluid getting on belt causing slipping.causing alternator problems.alternator cant charge if belt slipping.fluid getting on exhaust manifold making it smoke it also can catch fire.so look at power steering pressure hose sound like it rupture causing lost fluid and hard steering.

Posted on May 20, 2009

  • 6 Answers

SOURCE: 2000 gmc sierra 1500 5.3 v8. a/c heater control problem

your heat/cool and vent selection options are controlled by engine vacuum through small clear tubes attached to the rear of your climate control interface. Other vehicles have small steel pull wires that operate the desired changes. You might try removing the trim and any fasteners affiliated with the interface/console. GENTLY pull outward and look to see if any of these tubes are pulled off or cut/damaged. Did anyone recently install a new stereo in the vehicle? If so, the vacuum tubing and or pull wires that change your outlets could have been damaged when the stereo unit was pushed into place. Hope this helps

Posted on Sep 09, 2009

Testimonial: "Very good information. THANKS!"

  • 1 Answer

SOURCE: 99 Cavalier warning lights come on in drive.

Hey, I'm having a very similar problem. Did you figure it out?

Posted on Jan 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My WH Statesman ride leveller is coming on intermittently for no reason


Must be a reason. Like, most likely, a air leak in a line or fitting in the system. Take my word for it friend, it isn't for no reason.

Nov 28, 2017 | Cars & Trucks

1 Answer

I have a LS1 gen3 in a wh holden statesman, the cluster works but the speedo doesntwhen tested on tech 2 i had speedo to the cluster but not to speedo on cluster.please help


More than likely the tiny electric motor that moves the speedo needle has failed, very common issue on GM cars and trucks.

Jul 06, 2016 | Holden Cars & Trucks

1 Answer

Every time I put it in drive most of the time it makes a clunk noise then when your slowly moving forward or backwards somewhere in the rear diff makes a bad clunking noise but once you take off and...


sounds like your u-joints on your drive shaft .
to test it jack up the rear end off the ground place jack stands on the frame for safety.
in park with car or truck off..
twist the drive shaft by hand and look for play if none than push and pull up and down and look for play.
there should be no play at all even a very little is a bad u joint..,


now if you have a lot of lash when you twist the shaft (over a half a turn ) now you have bigger problems

Nov 08, 2014 | Cars & Trucks

1 Answer

Is it easy to change my fuel filter on my wh statesman


Yes you need a special tool to release the fuel line.

Jun 28, 2012 | Cars & Trucks

1 Answer

Does the A/C belt drive any other devices. Can I remove/cut the belt without affecting the vehicle performance other than no air conditioning operating. Problem is Air conditioning pump bearings very...


  • I'm over here across the pond and trying to locate a diagram of your engine. Here is how it works either way. If your AC is hooked up with the rest of the drive line items and everything is on ONE belt then you cannot.
  • However, if your compressor is hooked on its OWN belt to the crankshaft pulley then that belt only runs the compressor, smile and cut/remove the belt, it will be fine.

  • Hope this helps and thank you for using FixYa.

Regards, Tony

Jul 23, 2011 | Cadillac DeVille Cars & Trucks

1 Answer

2000 saturn ls1 dash lights up, head lights and radio work, but won't turn over. Doesn't make a sound. If I get it jumped it stays running until I shut it off.


check for a loose or corroded connection on the battery, clean the clamps and pattery posts.
make sure the clamps are securely tightened on the posts and that the wires are not loose or corroded at the clamp. alos check for loose or damaged ground wires coming from the battery or the teminal / clamp
hope this helps

May 24, 2011 | Saturn L-Series Cars & Trucks

1 Answer

Overheating when on highway or using air conditioner


The condenser for the ac is not getting enough air,look for the reason,look in front of the car at the radiator,see if there is something restricting air flow threw the radiator and condenser.

Jul 11, 2010 | 1996 Mercury Sable

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15148 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...