Question about 2007 Jeep Grand Cherokee Overland

Open Question

When u try to start our 2007 jeep grand cherokee overland it just clicks. Sometimes you can take it out of park and put it in neutral and it will start but now we can't get it to start only click

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76649 Answers

SOURCE: Where is Neutral safty sensor switch located on Grand Cherokee

OK then the switch is part of the gear selector switch on the side of the trans where the shift linkage hooks up. here is a picture and part number.
ACDELCO Part # C2241 $233.89

673ffc9.jpg

Posted on Feb 17, 2009

Ad
  • 6982 Answers

SOURCE: 2004 Jeep Grandcherokee - Transmission Maintenance

I'm going to guess since you didn't mention which fluid...Transmission?
First find out which unit you have (usually an id tag on it somewhere ) Then look up what kind and how much fluid in your owners manual (usually around four quarts...unit holds more but you can't remove it from the pan) Remove all pan bolts and lower pan. (some units have a drain plug, use it first if you have one ) you will see the filter attached to the valve body. remove it and install the new one, Make sure all gasket material is removed from pan and trans. Clean any metal etc from pan and internal magnet (there is always some in there but should not be a ton of it) Then put pan and gasket back. Make sure you can turn each fastener easily to make sure they are not cross threaded and only tighten them after they are all in there. Bolts do not have to be tightened down like they never should be removed again (snug then a little bit more)tighten in an X pattern not a circle.Replace about half of the fluid with car off, then put in remainder while running. Put your foot on the brake and shift to reverse then drive a few times then check fluid level.Low is bad, a tiny bit (less than half inch) over is OK.
Drive for a short ride, check again for leaks and re-tighten if any are found.
If trans was exceptionally dirty and yours has a drain plug, I recommend that you use a generic oil on the first change, then in a week, drain oil again and re-fill with good brand name stuff. and perhaps a bottle of lucas conditioner.
Good luck!

Posted on May 14, 2009

worriedtouch
  • 16 Answers

SOURCE: 2001 jeep grand cherokee wont reverse in

This could be an issue with the shift solenoid , but can also be caused by low fluid due to a leak, check your fluid. Is there a check engine light on, if there is it could be a solenoid issue.

Posted on Aug 26, 2009

  • 6982 Answers

SOURCE: My 2002 Jeep Grand Cherokee Laredo won't start.

Check that your battery has 12v, check and clean terminal contacts. If battery has less than 12v have it charged and load tested. 9 of 10 times this will get you going...if not, I'll give you the rest of testing later if you need it.

Posted on Sep 08, 2009

  • 3600 Answers

SOURCE: Jeep Cherokee starting issue

On an intermittent start problem like this you may be having a starter solenoid issue or your wire on the starter from the key switch may be loose. Or you may have a corroded battery cable or the safety neutral switch may be going bad. Is it a automatic? If it were it would be the clutch safety switch going out. So do the simple things first. Clean cables like the first guy said if that does not fix it locate the starter and if you have jumper cables the next time it does it put the positive lead of the jumper cable on the Positive battery terminal and the other touch to the starter wire with the key in the run position where the big wire on the starter is, if you here it spin it means the starter motor is ok if it don't it is bad or the connection on the starter is loose. Also a bad battery cable could cause this from the battery to the starter next put a small wire into the end of the positive jumper cable and touch the S terminal on the starter if you here a solid clung it means the solenoid is good. So check the connections on the starter and tighten the starter bolts as they may have worked loose and don't have a good ground. So if you want more as stance just post on my question and I will hell p more and if this is more informative please rate

Posted on Sep 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ok my 2001 Grand Cherokee Laredo wont stay in park


Transmission sticks in reverse- won't go into park. - JeepsUnlimited

www.jeepsunlimited.com/forums/showthread.php?...won-t-go-into-park
Jun 14, 2013 - 12 posts - ‎5 authors 2003 6 cyl 4x4 Grand Cherokee Laredo automatic- Occaionally, when shifting from REVERSE TO PARK, my Jeep will stay in reverse. Typically its ... '2001 WJ'4,0L'42RE'NV 242'380000 km'ECE Compliant' ??????????? ??? ...

2001 jeep grand Cherokee laredo - CarGurus

www.cargurus.com > Questions > Jeep > Grand Cherokee
CarGurusJan 27, 2014 - 2001 jeep grand Cherokee laredo - Just purchased a 2001 Jeep GrandCherokee Laredo and ... It starts in PARK sometimes and sometimes it won't and I have to start it in Neutral. ... Hatch shuts flush, but won't stay shut. help!

Oct 22, 2015 | Cars & Trucks

1 Answer

Intermittent Electrical Probem 2007 Grand Cherokee


can you remember back to the other times it quit .
was it raining or very hot.
see if there is anything in common .
these kind of problems can realy make you pull your hair out. unless you can make it act up.
oh yes humidity can also make a difference.
good luck
paul

Sep 28, 2008 | 2007 Jeep Grand Cherokee Overland

1 Answer

I need wireing diagram for a caravan plug for a 2007 jeep grand cherokee


Check on your motor you have some where a place how you have your number of your celynder

Jul 16, 2014 | 2007 Jeep Grand Cherokee Overland

1 Answer

Need diagram internal 2007 jeep grand cherokee?


there are 3000 parts. (7000 page FSM too)
we cant guess what you are doing,?
https://www.techauthority.com/en-US/Pages/Home.aspx

post a job,
post symptoms.
we cant guess that.
put us on the same page, (context)
please !

Jul 09, 2014 | 2007 Jeep Grand Cherokee Overland

1 Answer

Will not start no spark at coil. I replaced coil


Try putting it in neutral and starting it. These Jeeps have a neutral safety switch to prevent starting if the vehicle is in drive. Some times when they fail, it won't start in park but it will start in neutral. Here is a good link to a site for learning about Jeep ignition problems. Click on the other links on the site too.
http://www.ehow.com/about_5610956_jeep-cherokee-ignition-problems.html

Dec 29, 2010 | 1996 Jeep Grand Cherokee

1 Answer

My engine light blinks 10 times on my 2007 jeep grand cherokee and will not start. HELP!!!


advance auto parts offers rental error code readers that you can plug up to your jeep and see what the reason is for your light flashing

Dec 18, 2009 | 2007 Jeep Grand Cherokee Overland

1 Answer

My park assist warning come on while driving for no reason


You can take it to your Jeep dealer and have the service department try to flash the computer. This may fix it. If not you will need to purchase a shift control module. They are about $ 590.00. This is a very common problem on the Jeep Cherokees and Grand Cherokees. Hopefully you are under warranty still. If you ignore this problem this is what will eventually happen: You will be driving down the road and your vehicle will not want to go over 15 mph and it will shift erratically. Do not wait to correct this problem or you will regret it. Yes it is a very expensive part, but a computer in itself that the vehicle needs to function correctly.

Dec 05, 2009 | 2007 Jeep Grand Cherokee Overland

1 Answer

How do you change a back tire with the standard jack on a 2007 jeep cherokee


with tires blocked, transmission in park emergency brake on, vehicle off the road, you first break loose the lug nuts slightly then raise the jeep and remove the lug nuts, reversing the procedure after replacing the tire.

Oct 22, 2009 | 2007 Jeep Grand Cherokee Overland

1 Answer

I want to finde the code of my radio


Call local jeep dealership. Give them your VIN number and they can supply you with the radio code. Did you check the glove compartment? Most of the time its located inside on a sticker.

Jun 03, 2009 | 2007 Jeep Grand Cherokee Overland

Not finding what you are looking for?
2007 Jeep Grand Cherokee Overland Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...