Question about 2000 Ford F350 Super Duty Super Cab

Open Question

7.3 ford f350 wont start when wet

Wont start after washing at a high pressure car wash

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
dgjtex
  • 405 Answers

SOURCE: 1989 ford f350 diesel wont start

Bad glow plugs most probably or the glow plug controller. to check your glow plugs remove wire and check with ohm meter to ground. if they are working you should get a low ohm reading if one has a high ohm reading it is bad. if all injectors check good make sure your fuses are ok, also check and see if you hear the controller click when you turn the key to on. Does the wait to start light come on?

Posted on Dec 27, 2008

Ad
  • 2 Answers

SOURCE: 1989 ford f350 460 gas

89 Has EFI not carb. I vote to give you a ZERO!! The problem is more likely the IDLE AIR CONTROL VALVE (no sh!@#) "IDLE"????

Posted on Feb 04, 2009

  • 14 Answers

SOURCE: 2002 ford wind star o/d light started flashing after car wash

Two things that it could be.
1 - Look under the hood, there is a wire coming out of the master cylinder, there was a problem with some of the windstars that leak brake fluid, run down the wires and drip on the neutral safety switch, which would cause the light to come on.
2 - This one solved my problem. It could be the transmission valve body that needs to be updated or changed out. There are many issues with these valve bodies. Slipping from 1-2, OD light blinking, shift 1-2-3-2, late down shift from 3-2. I had all of these.
If you do some work on cars, then you should be able to change out the valve body yourself, with a torque wrench. I picked one up on ebay for $180 with shipping both ways, and took my about 2 hours. My Windstar never drove so good.
-fyi, The OD solenoid is inside the transmission.

Posted on Jul 09, 2009

  • 89 Answers

SOURCE: wipers not working on 1999 ford f350, I checked

lokk abd see if all plugs are pluged in. berrydalewolf

Posted on Oct 29, 2009

  • 832 Answers

SOURCE: 2008 F350 horn activates all by itself whenever

From your comment, it is apparent that the wirings to
the horn is grounded. And the only way to check it, is
by tracing the electrical wirings going to the horn. It must be checked and corrected. The hint is, it can be probably be found under the hood, where it can get
easily wet. Hope this will help you.

Posted on Nov 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1993 f350 460 cid wont start unless you press gas pedal to the floor


my truck starts right up if I hold the petal to the floor but wont start if I don't hold petal to floor

Feb 12, 2013 | 1993 Ford F350

1 Answer

2004 f350 wont start


fuel pressure if to low wont start or hard start . get gauge and ck fuel pressure

Jul 15, 2012 | 2003 Ford F350 Super Duty DRW SuperCab

1 Answer

2006 f350 super duty diesel start good in the mornings but after is warm it wont start.


these trucks use a oil fired fuel injector, if your high pressure oil pump has eccessive wear or if your oil to broken down from being run to long between oil change, it will not build enough oil pressure to fire the injector once the oil is thinned out from being hot. An oil leak in your high pressure oil system can cause same problem.

Jan 11, 2011 | 2006 Ford F 350 Super Duty

1 Answer

I pressure washed my f-250 today including the engine to remove salt and dirt from plowing and shortly after it went into limp mode and subsequently stalled and will not start, I have a heater running...


you have a wet coil pack possibly. use hair dryer to dry the engine coil pack. if you're not familiar with coil packs, they replaced the old type distributors. water has built up in coil pack or you've blown off a spark plug wire from coil pack while pressure washing engine.

Dec 30, 2010 | 2008 Ford F 250 Super Duty 4WD

1 Answer

I have a 2005 Ford F350 6.0 Diesel and It wont start after the motor gets warm. It also starts rough when cold. When it is running it runs great. Any help would be appreciated.


I had this same issue and luckily my F350 2006 was still under warranty. Basically there is a high pressure oil system that has a tendency to leak internally. You won't see any oil leak. When cold the oil has enough viscosity to keep the pressure sensor from not allowing the engine to start. When the engine is warm the system doesn't reach required pressure to allow the engine to start. In short it's a Ford dealer repair. Good luck.

May 31, 2010 | 2004 Ford F350

1 Answer

2008 F350 horn activates all by itself whenever truck gets wet. This can be during washing or even driving in the rain.


From your comment, it is apparent that the wirings to
the horn is grounded. And the only way to check it, is
by tracing the electrical wirings going to the horn. It must be checked and corrected. The hint is, it can be probably be found under the hood, where it can get
easily wet. Hope this will help you.

Nov 29, 2009 | 2000 Ford F350 Super Duty Super Cab

2 Answers

2001 F350 7.3L Diesel won't start


I take it you have a crank no start issue, the fuel is injected by high pressure oil, no oil pressure no start, there are 2 oil pumps, low lube pressure and high injection control pressure (ICP) the injection system is hydraulic controls electric actuated fuel injection, if when you crank the engine over and the oil pressure guage goes up base pressure is ok, then its high pressure or the best thing I can say is pull codes and that can give me a good direction to send you in, there are many things that can cause that problem, if the fuel heater shorts out, the pcm and it are on the same 30amp circuit causin the same problem and still you would have proper fuel pressure readings.

Jul 13, 2009 | 2001 Ford F350 Super Duty SuperCab

3 Answers

Shut 05 Ford f350 diesel off wont start


dies the truck restart once it cools off? it is very common for th 6.0 to have high pressure oil issues on a hot soak. they will run till the cows come home but once shut off they can not build up enough pressure by cranking speed alone to start truck until it cools down and the seals become rigid enough to bridge the gaps they are sealing in the first please. if this is the case. it may be the STC fitting ojn the back of the high pressure oil pump (intake and turbos must be removed to check) or possibly the branch tube o rings have worn. the branch tubes are located under the valve covers and supply the fuel injectors the oil they need to perform their "power stroke"...

May 04, 2009 | 2005 Ford F 350 Super Duty

2 Answers

F350 Super Duty Diesel 2005 suddenly died while driving.Cranks fine but wont start.Help


that's good but it still doesn't rule out a leak in the high pressure oil system. When you turn on the key do the injectors buzz like normal? Usually 5-10 secs

Jan 09, 2009 | 2005 Ford F 350 Super Duty

Not finding what you are looking for?
2000 Ford F350 Super Duty Super Cab Logo

Related Topics:

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5522 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...