Question about Peugeot 307

1 Answer

Hi my ignition light comes on an the steering gose stiff air bag light came on abs light came then when i stopped the car it would not start again but it did not effect my light

I stopped the car a couple of times amd dashboard warning lights went off and came on again after a couple of minutes

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Peugeot Master
  • 40,738 Answers

Have a load test done on the battery . Check battery posts and terminals are shiny clean and tight.. Check the alternator drive belt condition and tension because if it drives both the alternator and the power steering pump it indicates a belt problem.

Posted on Feb 11, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: Air Bag Light, Brake Light, & ABS Light came on in the dashboard.

Check and see if your alternator is charging
Low voltage will cause those lights to come on, as the computer is shutting down.

To check your alternator you will need a volt meter... WITH the engine running you should have about 14 volts coming out. IF NOT you need to replace the Alternator!

Posted on Apr 19, 2009

  • 401 Answers

SOURCE: ABS and Trac off light coming on during drive

hi chances are u have a wheel speed sensor problem u will need to get it scanned for a fault code

Posted on Jul 13, 2009

  • 140 Answers

SOURCE: air bag warning light is on

Hi,
BMWs usually have a peculiar problem with unnecessary warning lights especially as they get older in use. I don't think this is of any hazard except that you need to check the fuse box in the bonnet that has to do with electrical connections.

Cheers

Posted on Oct 16, 2009

  • 76 Answers

SOURCE: i have a vauhall meriva 1.6 enjoy 2004 model.

vauxhall charge 47 pound to look at the car for you sounds like the steering rack but i cant be sure, i would take it to vauxhall cause a backstreet could get it wrong and it would cost you more

Posted on Feb 08, 2010

ajarema
  • 404 Answers

SOURCE: air bag light showing at the dashboard. It's intermittent happening. The air bag light dissapeared for a month then iy\t's back again. It usually appears for a couple of days. What could be causing t

The airbag light on the dashboard comes for few reasons, either there is a bad connection or connection came loose but than the light would stay on at all times, if it comes periodically than I would look up to the owner's manual and also find the airbag check label inside the car as it might be faulty or in need of replacement. The danger is that if it is faulty it can blow up by itself or in case of accident (hope none happens) it will malfunction.

Posted on Oct 19, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Power distribution issue?


Bad fuse box or power center. The reason you have difficulty steering is power steering pump is not coming on. The abs and air bag light are on because of a fault in system. Windows don't work because of no power going to system with all this happened at one time a bad fuse box is most likely the cause

Apr 12, 2016 | 1995 Chrysler New Yorker

2 Answers

ABS and power steering light is constantly on


Hi. The only link between abs and power steering that springs to mind is the steering wheel angle sensor but you really need at least a code read of the systems as the faults may be unrelated. I think spending a few quid at the local garage and getting a proper insite into what is going on will be money well spent. The pedal vibration will probably turn out to be the abs activating on low speed braking as it is seeing a low speed signal from one wheel sensor. This can be caused by an abs speed sensor being improperly gapped or a damaged sensor pick up ring among other things, Again without some real details or codes from the ecu its hard to give a real diagnosis. A visual inspection of the wheel sensors and pick up rings may reveal something - you don't need to know exactly what your looking at just that they all look the same and clean, no missing teeth on the pick up rings or cracks. If you get at least a code read and post the results we might be able to delve a little deeper.

Dec 13, 2013 | 2006 Volkswagen Polo 1.6

1 Answer

Wont start, clicking and all dash lights on. relpaced starter no go.


check the starter and ignition fuse. starter fuse is located in the fuse box in your engine bay, ignition fuse is located in the kick panel which is right under your steering wheel.

May 17, 2012 | 2006 Dodge Durango

1 Answer

Warning licht comes on and steering is stiff vw polo 2005


Hi if the warning light is coming on and steering is stiff, then the car has logged a fault in its ECU either in the steering control ECU or the ABS ECU, these can be read with a diag machine, from there this will give you a better idea of what is causing this problem

hope this helps Chris

Jul 27, 2011 | Volkswagen Polo Cars & Trucks

1 Answer

My 96 blazer was running fine then battery light came on and abs light and air bag lights came on and then engine started missing.


Blazers aren't necessarily known for bad ignition switches (which it sounds like), but I would suggest a battery problem ( known more for this). Check the battery connections, especially the positive post. Make sure the connections are tight and no corrosion. If the battery checks out good then I'd suspect the ignition switch failing. The ABS and AIR BAG lights will come on when the battery gets low.

Apr 11, 2011 | 1996 Chevrolet Blazer

1 Answer

Fuses panel described in English


Hope this helps your out. I know the diagram and locator is a bit blurry but hopefully it gets what you need.
Drivers kick panel:
Front wiper 20A - Front wiper system Cigar 15A- Cigarette lighter Audio 10A- Audio, remote control mirror Air Bag 10A -Air bag diagnostics Stop lights- 15A -Rear brake light, high mounted stop light ECU B+ 10A - Shift lock actuator, transaxle controle module, radio, engine control module Room 10A - Interior light, clock, ignition key reminder, rear cargo area light switch ABS 10A- Anti lock brake system control unit ECU IG1 10A - Transaxle control module, shift lock actuator, ABS control unit, DRL unit Meter 10A - Instrument panel, back-up switch, electronics time control module, inhibit switch Turn signal 10A- Hazard switch ,front and rear turn lights, turn indicator IGN1 20A - Ignition switch ABS 30A- ABS pump motor TNS 30A- Tail light, license plate light COOL/FAN 30A- Cooling fan Cond/Fan 20A- A/C condenser fan Starter 15A- Start signal , Fuel pump Blower 25A- Blower Motor SR/ACC 10A - Ignition switch Hazard 15A - Hazard and turn signal light D/Lock 25A- Door locks ABS 30A - Anti lock brake system control P/W RH 20A- Power window motor right hand P/W LH 20A- Power window motor left hand IGN2 25A- Ignition Switch
Engine compartment :
Head 25A- headlights IG 2 30A- Ignition switch IG coil 15A -Ignition coil, condenser,generator IC regulator, diagnostic connector. O2 down 10A- Rear O2 sensor O2 up 10A- Front O2 sensor Fuel pump 10A -Fuel pump unit Injector 10A -Fuel injector ,camshaft positioning sensor, purge solenoid valve, EVAP, IAC actuator, Mass Airflow sensor, EGR stepper motor. fuel pump relay coil, vehicle speed sensor. A/Con 10A - A/C compressor controls, cooling fan BTN 30A- Brake light , high mounted stop light. Tail light LH 10A- License plate light, tail light , rear combo light, instrument panel illumination Tail light RH 10A-License plate light, tail light , rear combo light, instrument panel illumination Head low 15A- Headlight Head Hi 15A-Headlight Horn 15A- Horn jlmacman.png jlmacman_0.png

Inside kick panel jlmacman_1.png

Mar 07, 2011 | 1995 Kia Sephia

5 Answers

I have a 1996 Miata where the alarm system goes off no matter what I do to the secuirty switch on the steering column. It can be in the off position or on and open a door and the alarm contiues to go off....


Check wires connections in ALARM WIRING DIAGRAM

Also, its possible that this info helpfull:
- Power Lock - TO DRIVERS DOOR ONLY, See DIAGRAM
- Power Unlock - TO DRIVERS DOOR ONLY, See DIAGRAM

Keepo us updated and send comments.

Oct 17, 2010 | 1996 Mazda MX-5 Miata

1 Answer

I have nissan altima 2007 the air bags light is flashing i need turn off how ican do


If the air bag light is flashing- that means there is problem with your SRS air bag system. It stored a code in the computer and wont turn off untill the problem is fixed or cleared manualy with a scan tool- note if you choose to clear the code and turn off the light with a scan tool- if the problem with the system is still there the computer in your car will notice it and store another code and the light will come right back on. also Note that if the air bag light or SRS light is on while driving that system is shut down and your air bags WILL NOT go off if you get into an accident. (the same rules apply if your ABS- anti lock brake light is on- the ABS system will not work) the most common problem with the Altimas and air bag codes are the clock spring assembly located behind your steering wheel- (not the air bag itself on the steering wheel) but there is a round thing that turns with a wire connected to it. you have to remove the steering wheel to service. Best bet - go somewhere that has a scan tool and read what code the computer stored. It will tell you what part of the system has the problem.

Nov 28, 2009 | 2007 Nissan Altima 3.5 Sedan

2 Answers

Power steering is stiff in idle but ok when driving


Hello there:
when you installed the line did you fully bleed the system, and are the lines all tight bleeding can take some time to occomplish but once done properly it should have no more problems
you want to very slowly turn the wheel while the bleeder valve is cracked untill all of the air is completly out of the system or i would suggest taking it to a repaitr shop and have it done by a certified repairman ok best regards mike

Aug 12, 2009 | 2001 Oldsmobile Aurora

2 Answers

2002 concord abs-brake airbag light stay on untill bang steering


sounds like you have a faulty ignition switch..have seen this before

May 26, 2009 | 2002 Chrysler Concorde

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

115 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Wahs Team

Level 2 Expert

205 Answers

yadayada
yadayada

Level 3 Expert

75051 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...