Question about 2000 Isuzu Rodeo

Open Question

Duralast/Canister Purge Valve location on 2000 isuzu rodeo

Location

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 393 Answers

SOURCE: 2000 isuzu rodeo brake problems

your master cylinder is gone. when stopped apply pedal and hold let up slightly then reapply if pedal sinks to floor master is bad.

Posted on Nov 16, 2008

djicenova
  • 319 Answers

SOURCE: where is air cabin filter located on 99 isuzu rodeo?

its usually behind the glove compartment in the blower box. you will have to pull the GB door down all the way to access it

Posted on Mar 19, 2009

ourhowse
  • 2007 Answers

SOURCE: 2000 isuzu Rodeo wont start

Could be your neutral safety switch, or it's not all the way in park. Broken or loose wires in the starting circuit. Inspect all wires and connectors at the battery, starter solenoid, and ignition switch. Or your starter pinion is jammed in the ring gear. Remove starter and inspect. Last but not least, your engine is seized. You don't want that one. Good luck.

Posted on May 22, 2009

  • 6 Answers

SOURCE: Were is my ABS sensor located on my 2000 Isuzu Rodeo

there should be a sensor at all 4 wheels so make sure there all pluged in 

Posted on Jul 04, 2009

brandyspoile
  • 61 Answers

SOURCE: Crank Sensor in 94 Isuzu Rodeo

it's on the bottom of the motor, towards the back on the passenger side. It has a small clip of wires and one screw holding it on. You may want to pull it up on ramps- if it'll run- otherwise, get under the Rodeo, it's up a little higher than the oil pan, and to the passenger side. (it's right on top of the two lines that run to the bottom of the radiator.) You will need a 10mm socket to remove it. I have added a few pics showing the location (i just completed this task myself)
bfcf016.jpg61ae995.jpgdeffbd6.jpgdd2e415.jpg

Posted on Jul 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2001 Is. Rodeo, name,and purpose, of part directly between the fuel pump, and the fuel inlet tube, in gas tank?


SOUND LIKE A PURGE VALVE THAT PULLS GAS VAPORS FROM TANK BACK TO ENGINE TO BURN IT; IS PARTOF EMISSION SYSTEM

Jun 06, 2015 | 2001 Isuzu Rodeo

1 Answer

I am unable to locate the Vapor Canister Purge Valve on my 2006 Isuzu Ascender LS 6 Cyl. I have a hard code with the check engine light on and I am unable to reset the check engine light. I purchased the...


Hello had the same problem in my 2006 Isuzu I-280 I needed to
replace at this moment the Evaporative Valve Soleniod which is instaled next to the Vapor Canister. It is mounted on the frame behind the gas tank you will have to move the spare tire out of the way one bolt holds it in place this is where the canister is and the valve is mounted on the canister this is where it is mounted on my 2006 I-280. If you need to replace the solenoid and you can't find the original Isuzu part, you can ask for the 2006 Chevy Impala V-6 3.5 Purge Valve Solenoid. It is the same piece. The old Evaporative Vent Valve Solenoid has a number part PA-GF30, and it is the same part number I found in the new Chevy Impala Evaporative Vent Valve Solenoid.

Aug 08, 2013 | Cars & Trucks

2 Answers

I have a 2006 Isuzu Ascender with a 6 Cyl. 4.2L Engine and I need to locate the Vapor Canister Purge Valve. Any ideas where it is located. I have looked but am unable to locate it. Is it under a plastic...


Hello have a 2006 Isuzu I-280 and I needed to replace, at this moment, the Evaporative Valve Soleniod which is instaled next to the Vapor Canister. In my case, It is mounted on the frame behind the gas tank you will have to move the spare tire out of the way one bolt holds it in place, this is where the canister is and the valve is mounted on the canister this is where it is mounted on my 2006 I-280. If you need to replace the solenoid and you can't find the original Isuzu part, you can ask for the 2006 Chevy Impala V-6 3.5 Purge Valve Solenoid. It is the same piece. The old Evaporative Vent Valve Solenoid has a number part PA-GF30, and it is the same part number I found in the new Chevy Impala Evaporative Vent Valve Solenoid. Good luck.

Aug 08, 2013 | Cars & Trucks

1 Answer

Check engine po441


this obd2 trouble code can help you understand the meaning of code...
for p0441, you can try:

common Chrysler fix - Replace Leak Detection Pump / LDP

Repair damaged EVAP lines or canister

Repair open or short in voltage feed circuit to Purge Solenoid

Repair open in PCM purge command circuit

Replace purge Solenoid

Replace vacuum switch

Repair restriction in Evap line or canister or soleniod

Repair resistance in purge connector

Replace PCM

Sep 01, 2011 | 1995 Isuzu Rodeo

1 Answer

On my 2001 rodeo the check engine lite came on and the only code that came up is po440, can you tell me what this is


This alarm concerns the function of the EVAP SYSTEM. This system monitors vacuum correctness. If a sufficient vacuum level cannot be achieved, a large leak or a faulty EVAP canister purge solenoid is indicated. It can be caused for the following reasons:
1) Disconnected or faulty fuel tank pressure sensor
2) Missing or faulty fuel cap
3) Disconnected, damaged, pinched, or blocked EVAP purge line.
4) Disconnected or damaged EVAP vent hose.
5) Disconnected, damaged, pinched, or blocked fuel tank vapor line.
6) Disconnected or faulty EVAP canister purge solenoid.
7) Disconnected or faulty EVAP canister vent solenoid.
8) Damaged EVAP canister.
9) Leaking fuel sender O-ring.
10) Leaking fuel tank or fuel filler neck.

Apr 13, 2011 | 2001 Isuzu Rodeo

1 Answer

2001 Rodeo smells like gas constantly and the gas mileage has went to ****, can't locate any leak what so ever? Just started a couple months ago and slowly noticed the gas mileage. Someone told me after...


CHECK EVAP SYSTEM CHECK EVAP CHARCOAL CANISTER COULD BE GAS SOAKED. OR THE PURGE CONTROL SOLENOID NOT WORKING.ITS NOT CONTROLING FUEL VAPORS FROM CANISTER TO INTAKE MANIFOLD.

Jan 24, 2011 | 2001 Isuzu Rodeo

1 Answer

2000 rodeo has code #0440 which is the (evap) what should i be looking for.


Make sure everyone will fuel up your Rodeo DO NOT TOP OFF the tank.

The few ounze of gasoline can soak the charcoal canister and damage the vapor purge relay/vent.

THE FIX

Park the truck outdoor

Locate the charcoal canister and disconnect the hose.

Let it vent for 3-5 hours.

Reconnect the EVAP line.


Please rate me answer if it's useful to you.

Cheers.


MUSTGO.

Dec 13, 2009 | Isuzu Rodeo Cars & Trucks

2 Answers

Locate canister purge solenoid for 2000 Buick lesebra


The evaporative canister purge valve is found between the upper intake manifold and the rear valve cover.

Nov 01, 2009 | 2000 Buick LeSabre

Not finding what you are looking for?
2000 Isuzu Rodeo Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...