Instrument lights do not work
Try checking fuses first and if this is good, check harness to switch that turns them on. If you have power, might be a bad switch. If you have a wiring diagram for the switch and dashboard, try to fun power directly to the circuit that the lights are on. If they come on, your switch is bad or you have an open wire in the circuit.
SOURCE: 1996 geo prizm
you'll have to pull off the interior panel. window in the up position. on the lock cylinder there is a clip that you have to pull off and an arm that actuates the lock. pop the lock out. reverse to install.
SOURCE: geo prizm 95' engine light on - code 24 - air intake temp. sensor has no power
use an electrical tester with a sharp point tip, and poke through the coating into the wire at every 5".
this is the best wat to test the wiring.
SOURCE: 1994 GEO Prizm Fuel Guage
You need to replace your fuel sending unit. It is located inside of the gas tank.
Please remember to rate this solution.
SOURCE: Geo Prizm brake lights
I had the same problem, what I did to fix it was as follows:
74 views
Usually answered in minutes!
×