Question about 1995 Suzuki Sidekick
Is it controlled by a fuse? If it is where is located and what amp is it? thanks.
If it dont blow on high , it can only be 3 things. (wires are always suspect and conn.. in all electrics.)
1: blown fuse.
2: bad switch (see link, below for how to fix THIS switch.)
3: bad blower motor.
there are 2 ways to find it, not guessing...
A: use a voltmeter, Got 12vdc to motor on fan?
no ? then got 12vdc into switch? yes, then switch is blown
B: hot wire fan, work now, yes, motor good.
see no heat page'
see it here. the 25amp fuse, fan draws about 15amps
most cars call this blower. (new cars have up to 5 fans)
these Suz, dont have spare switches now, for many older year cars.
see list above for p/n of the ones they do, this is one of the hardest
parts to source on zuk and some have CAMI switches and others have Japan real . (production options..)
Posted on Feb 11, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I would have taken it back immediatly and told them that it worked before and oesnt now since they worked on it and you would appreciate it if they at least looked at it.
If they refuse, then never go back and you will have to trace the problem using a voltemeter.
Make sure the fuse is the right Amperage.
Buy a repair manual from a auto parts saled store and see what else connects to that fuse, you could have a bad blower motor, or some other wire that got damaged durring the clutch install.
Posted on Dec 01, 2008
steering wheel off ,airbag removed first to get to retaining nut.best advice unless you have a mechanics toolkit to hand is to entrust it to agent ,as they will know quickest way to do it.
Posted on Dec 25, 2008
I maybe able to help. Did it make any noise when you tried (grinding or groan hum exe..) or just not work. If so the first thing I would do is to change the transfer case oil, check for metal in the oil, if there is that's really not good, take to shop. If no shinny metal replace with good quality oil, if it's red use atf if black or brown use 75W 90 and some. Auto trans fluid is recommended in cold climates or adding torque modifier check with parts store or dealer prefferably for what to use unless comfortable with choice then change front differentail fluid, with recommended fluid and torque modifier for limited slip differentails 2oz or alittle more. both holes fill till you can stick your finger in an just bairly bend it 1/8 or so inches and touch fluid. don't try to fill all the way if it comes out of the whole your filling clean up mess and allow as much to drain out as possible. If that happens you may have it vent through the vent and may see/ smell what every you put in it. If your comfortable with taking the diff cover off and replacing the gasket if needed (usually is) make sure its clean, don't use water or anything water based brake clean is good but check for metal and brownish or simial colored stuff in bottom of housing and of course metal. The teeth on the ring gear and pinion( ring gear is the small one in the back, ring gear is big and will be closest to you. if you have hunks of metal in there its smoked and replacement of ring gear and pinion is required (not cheap) there is alot more to look for but that should start you off in the right direction.
Posted on Dec 30, 2008
it can b fuse or relays or the starter motor if all d light comes on on d dash..these fuse and relays are mostly located in the engine compartment
Posted on Aug 26, 2009
Tips for a great answer:
Nov 05, 2015 | 1993 Suzuki Swift
Dec 27, 2012 | 1998 Suzuki Sidekick
Jan 14, 2011 | 1989 Suzuki Sidekick
Jan 08, 2011 | 2001 Jeep Cherokee
May 07, 2010 | 1995 Jeep Cherokee
Apr 19, 2010 | 1992 Honda Civic
Feb 20, 2010 | 1995 Ford Taurus
Jul 24, 2009 | 1994 Honda Accord
163 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: