Question about Cars & Trucks

Open Question

Pt cruiser power outlet fuse keeps blowing. - Cars & Trucks

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: power outlet fuses keep blowing

the power wire to the outlet may be grounding out.

Posted on Aug 25, 2008

Ad
justuscc
  • 360 Answers

SOURCE: power steering fluid PT Cruiser

power steering fluid or dextron 3 trans fluid

Posted on Oct 10, 2008

  • 82 Answers

SOURCE: power windows

First off does the window switch on the passenger side? if it does then you may just need the drivers side window switch. The front and the back windows work seperate from each other.

Posted on Jan 03, 2009

  • 4 Answers

SOURCE: 2001 pt cruiser no heat

did you check the fluid level by removing the rad. cap? Radiator should be full to top. If Chryslers are low on coolant, the heater will not blow warm air.

Posted on Jan 04, 2009

  • 60 Answers

SOURCE: my 2002 pt cruiser lost power steering suddenly

check to see if the serpantine belt is still there. It sounds like like it broke. this belt runs all of the accesories on the vehicle including the water pump. So if this happened it probably starting running hot too

Posted on Jun 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 pt cruiser keeps blowing fuel pump fuse,replaced fuel pump, no change.runs rough at idle and stalls,blows fp fuse,also replaced ign.coil,plug wires and plugs also changed relays


There are two fuses for the fuel pump relay. One fuse is load side of relay, that fuse also sends voltage to load side of asd relay, the asd relay sends voltage to several systems, two of which are the fuel injectors and ignition coil. I'm not telling you to replace, anything, but, you need to do some testing.
The other fuse goes to control side of relay, smaller amp fuse. I don't know the amp rating of the fuse that keeps blowing.
See that fuse, it supplies voltage to load side of fuel pump relay and also to asd relay.
26322929-c15bjyrfwzlf33vqjpu1ik1c-2-0.jpg

Oct 22, 2016 | 2004 Chrysler PT Cruiser

1 Answer

2001 Chrysler PT Cruiser power outlets does not work?


if you have the owners manual look in it. it will show where the fuse panel is and what each fuse does. if not buy a test light and check each fuse at both ends with the circuits powered up.

Sep 05, 2015 | 2001 Chrysler PT Cruiser

3 Answers

My 2005 PT Cruiser keeps blowing fuse 13, what is the problem


Fuse number 13 is a 20amp fuse that powers the ASD relay and the computer among other things.
Someone will have to pull the relay and check the circuits one by one to find the short. It could be any one of a dozen or more components.

Aug 09, 2012 | 2005 Chrysler PT Cruiser

1 Answer

2002 pt cruiser fuse #11 blown


According to my diagram, number 11 is a 10amp fuse that powers the ac clutch relay. I don't see how it would keep the engine from starting.
Is the fuse you are talking about in the engine compartment box and is it a 10amp ?

Aug 06, 2012 | 2003 Chrysler PT Cruiser

1 Answer

I'm fues to my fan keeps going out on my 2006 P.T


More than likely you have an internal fault either in the fan itself or the thermostat that activates it.

For a fuse to blow it has to have a lot higher than normal current draw through it, which is normally refered to as a short. If the fuse blows almost immediately then I would suggest you unplug the fan, and see if the fuse blows with just the thermostat in the circuit. If it blows - replace the thermostat control. If it doesn't blow, plug in the fan and watch it. If it trys to start and then blows the fuse, replace the fan motor.

Jun 30, 2011 | 2006 Chrysler PT Cruiser

1 Answer

2006 pt cruiser ignition fuse blown, keeps blowing fuse


you have a short circuit you will need to eliminate that & your fuse wont keep blowing

May 31, 2011 | 2006 Chrysler PT Cruiser

1 Answer

Ingition fuse keeps blowing 2004 pt crusier


Too much combination of voltage/current. Fuses are to keep things from over-heating/catching fire. If you replace that fuse with a larger one, it won't blow as often, but it defeats the purpose of the original fuse, which is to limit your voltage/current.

hope it works

Jan 10, 2010 | 2004 Chrysler PT Cruiser

1 Answer

How will not blow on 2006 pt cruiser


1st check fuse. Then see if power is coming to horn. A simple power checker can be found at most auto parts store. It may also have a horn relay. Look up your wiring at cargrus. If you still have problems contact me back.

May 25, 2009 | 2006 Chrysler PT Cruiser

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...