Question about 2006 Chevrolet Trailblazer Ext

Open Question

2006 chevy trailblazer front end - 2006 Chevrolet Trailblazer Ext

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

wavoconqueso
  • 57 Answers

SOURCE: metal noise when reversing front driver side tire chevy trailblazer 2006/

One common reason is a loose heat shield. Weld may have broken. You may be able to bend it enough to stop it rattling against whatever it's coming in contact with.

Posted on May 06, 2009

countrysi248
  • 443 Answers

SOURCE: grinding noise front end

its either your front brake pads or your CV joint is going bad .. Jerry

Posted on May 13, 2009

  • 462 Answers

SOURCE: whats the torque on a wheel bearing

103 lb feet

Posted on Aug 09, 2009

  • 246 Answers

SOURCE: 2006 chevy trailblazer replace 4wheel drive selector

i've got a 2003, and i believe the parts and procedures are the same for the years. there are screws in the dash trim by the ciggarette lighter, and more on the underneath of the dash pad where the gauge cluster is. then carefully pop the dash trim out. there are retaining clips that hold it in besides the screws. they should pop out without too much effort. i'd start near the radio and be careful. there also may be two more screws near the bottom of the steering wheel that you'll have to remove the trim below it to get at.

Posted on Feb 17, 2010

Molson02536
  • 3854 Answers

SOURCE: 2006 Chevy Trailblazer makes THUD when accelerating

Check your coolant level, low coolant or air in your cooling system will make a "thud"noise in your heater core when the engine is under load from acceleration. The coolant rushes in to the heater core where the air pocket is trapped and then your hear the noise.
Start with the simple and make sure your coolant level is correct and then try to purge the system to remove the air out for your coolant system.
Thank you for using fixya and good luck

Posted on Jun 15, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The air in my 2006 chevy trailblazer only works on the front sides but not on the front facing or on the ceiling back only on the floor back


The system that control the doors in dash for where the air goes is not working correctly either do to the control unit or one or more of the actuator motor

Jun 26, 2016 | 2006 Chevrolet Chevrolet TrailBlazer LS

1 Answer

Roaring in the front end of my 2004 Chevy Trailblazer 4x4


A jet engine type of noise from the engine area usually means the fan clutch is going bad. I don't think the tach is related to this, that could be the stepper motor for the tach going bad.

Dec 29, 2012 | 2004 Chevrolet TrailBlazer

1 Answer

My 2006 chevy trailblazer fuse to the accessory plugin blew out and I can't figure out which fuse it is.


Can't find an LS listed for 2006, so looked up an LT. 20A AUX PWR 1 fuse 48 in the rear fuse block protects the front auxiliary power outlet

Oct 04, 2012 | 2006 Chevrolet TrailBlazer LS

1 Answer

I need to change wiper blades on 2006 trailblazer. i can't get the wipers off.


The 2006 Chevrolet Trailblazer has the most common hook-end wiper arms. Purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.

2006 Chevy Trailblazer Wiper Blade Installation Videos (hook end arms)

2006 Chevrolet Trailblazer Wiper Blade Size Options w/Correct Lengths & Attachments

Aug 16, 2011 | 2006 Chevrolet Trailblazer Ext

1 Answer

How do I get to my thermostat in a 2006 chevy trailblazer I6


Must remove the alternator and alternator bracket to get to it. There are 2 bolts that are a bugger to get to. Bottom bolt on the alternator bracket, use a wracheting closed end wrench. Same with the bottom thermostat bolt.

May 05, 2011 | 2006 Chevrolet Trailblazer

1 Answer

Need 3 point front seat, sensored seatbelts for '06 Trailblazer


for starters seatbelts do not have abs,you just need to get seatbelts that fit the anchorages so if chevy also make a trailblazer for another badge chances it will also fit(chevrolet in the uk sourced from korea)

Mar 20, 2010 | 2006 Chevrolet Trailblazer

1 Answer

Where is the oil filter - how do you get to it ?


very very easy!! goto the front of the bottom of the suv look in the very front you will see a panal that saids oil filter. you need a screwdriver to open it.

May 08, 2009 | 2006 Chevrolet Trailblazer

1 Answer

Metal noise when reversing front driver side tire chevy trailblazer 2006/


One common reason is a loose heat shield. Weld may have broken. You may be able to bend it enough to stop it rattling against whatever it's coming in contact with.

May 06, 2009 | 2006 Chevrolet Trailblazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...