Question about 1999 Chevrolet S-10 Pickup

Open Question

1999 chevy s 10 how do i reset the security - 1999 Chevrolet S-10 Pickup

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How could i reset the security lock on a 1999 chevy corvette


I can't find a reset for that year of Corvette. It is a Passlock system. So maybe the normal 30 minute procedure will work.

Perform the re-learning procedure

  1. Turn ON the ignition, with the engine OFF.
  2. Attempt to start the engine, then release the key to ON (vehicle will not start).
  3. Observe the SECURITY light, after approximately 11 minutes the light will turn OFF.
  4. Turn OFF the ignition, and wait 10 seconds.
  5. Repeat steps 1 through 4 two more times for a total of 3 cycles/30 minutes ( the vehicle is now ready to relearn the Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK).

If not, this site may help. http://diy-gm-security.com/

Jan 28, 2015 | 1999 Chevrolet Corvette

4 Answers

How to reset security ignition on a 1999 chevy silverado?


There is a lot of info on this site that you can read up on. http://vatspasslockpasskeysecurityhelp.yolasite.com/

Sep 07, 2014 | 1999 Chevrolet Silverado 1500

1 Answer

1999 CHEVY LUNINA WON'T START BATTERY AND


Check the dash once you turn the key to the run position the passlock runs a security check using a set resistance value through the chip in the key. If the security light begins to flash the reading it received was incorrect or it didn't get a reading at all. You can try reseting the value it is looking for by turning the key to start then releasing it. After 10 minutes turn it off then cycle it start again leaving it in on for 10 minutes then back to off then one more time. After the third cycle has completed for a total of 30 minutes. You should be able to turn the key on and start the vehicle. If the light continues to flash their is a problem with the chip in the key or the connections within the ignition its self. Both are common but a Pass Lock Relearn as described above will usually adapt to the poor connection values. Hope this helps.

Aug 28, 2011 | 1999 Chevrolet Lumina

1 Answer

MY 1999 CHEVY S10 WILL NOT START INTRUSION SECURITY NEED TO BE RESET ?


The security light only comes on when something is broken or failing. It could be your key, the ignition, or the security computer itself, Read this link for some "Do it Yourself" options. http://vatspasslockpasskeysecurityhelp.yolasite.com/

Apr 15, 2011 | 1999 Chevrolet S-10 Pickup

1 Answer

My chevy tahoe will not start and the security system light is on on the dashboard


If the light is flashing it may be an issue with the passlock sensor.Here is a process you can try to reset the passlock. If this process does not work you may need to replace the ignition tumbler and passlock.
PASSKEY LOCKOUT RESET ALL GM CARS 1999 AND UP
1) Put the key in the ignition and turn to the "ON" position. Leave it that way for 10 minutes. After 10 minutes turn the key and take it out. Repeat this process (2) more times (3 times, 30 minutes total) This should reset the PASSKEY system to recognize your key
.

Mar 08, 2011 | 2001 Chevrolet Tahoe

1 Answer

I put an ignition switch in a 1999 chevy malibu and now it wont start


Currently is the security light flashing when you try and start it? Is so try this procedure it will take 30 minutes total to complete
PASSKEY LOCKOUT RESET ALL GM CARS 1999 AND UP
1) Put the key in the ignition and turn to the "ON" position. Leave it that way for 10 minutes. After 10 minutes turn the key and take it out. Repeat this process (2) more times (3 times, 30 minutes total) This should reset the PASSKEY system to recognize your key
.

Dec 01, 2010 | 1999 Chevrolet Malibu

1 Answer

1999 chevy s10 won't run have good fuel pressure have good spark .have good compression. redid computer. starts but dies out .been at shop for moth they have no clue


Does this truck have the chip in the key it sounds like the anti theft has been tripped if so the security light should be on steady,if so you will have to go through the reset procedure. hope this helps .please let us know thank you..

Mar 30, 2010 | 1999 Chevrolet S-10 Pickup

1 Answer

1999 chevy s-10 wilot start


if you have the chip in the key, then this will surely help you: http://newrockies.com/vatsbypass . It was the only thing that saved my car.

Nov 22, 2009 | 1999 Chevrolet S-10 Pickup

1 Answer

Reset security system on 2003 chevy malibu


PASSKEY LOCKOUT RESET GM CARS 1999 UP
1) Put the key in the ignition and turn to the "ON" position. Leave it that way for 10 minutes. After 10 minutes turn the key and take it out. Repeat this process (2) more times (3 times, 30 minutes total) This should reset the PASSKEY system to recognize your key.
If this doesn't do it u have a part failure and need to have the dealer test the system.

Nov 17, 2009 | 2003 Chevrolet Malibu

Not finding what you are looking for?
1999 Chevrolet S-10 Pickup Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...