Question about 1990 Toyota Pickup
If stock its in the fsm
if not ,it not.
look there. if stock and in usa.
Posted on Feb 19, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 1994 Toyota Truck 22R Engine
Saw your post on another thread. I have the same truck. The fuel filter is located on the rail just below the passenger door. Its an easy one to remove,...couple bolts, but access to it is a pain.
Posted on Aug 11, 2008
I found that it is embarrassingly obvious once you get the parts and place them in position. Each belt only fits the appropriate pulley in width and length. When the belt breaks there's no visual reference (as one would have if he replaced the belts before they broke!) if the belt diagram is worn off the hood. Lesson learned; replace belts- a simple task- before they break!
Posted on Nov 19, 2008
SOURCE: 22R Carb at high altitude
Yes, Colorado is much higher in altitude. Do to higher altitude the barometric pressure is less than sea level by a long shot. Lower barometric pressure mean that less air is entering your engine. Which in turns mean that your engine is now running richer than it was at a a lower altitude. So I recommend checking you engine timing, and adjusting your carbs air/fuel mixture. yes this means that you may need to rejet. but first there is a screw on your 22r's carb that you must adjust to lean the air mixture just right. I have had a stock 22r carbortor before and never had to rejet it. i probibly should have but it ran fine at sea level and all the way to about 10000 ft. after 10000 feet i had to lean the fuel mixture to even alow the engine to run. This screw that you must turn is hidden due to toyota not wanting you to tamper with it and burn your engine to the ground by running your engine to lean. it has a metal plug on the passenger side of the carb about the size of a pencil eraser. you must drill that out and then you can adjust the air fuel mixture. Clock wise is to lean the air fuel. and Counter clock wise is to richen the air fuel mixture.A good rule of thumb is to turn the air/fuel screw all the way clock wise and then back out about 2 and 1/2 turns. That is the factory adjustment. you may only need 2 turns out. Best of luck i hope you get it running perfect. Try this adjustment first then if it still runs rich then think about rejetting.
Here is a picture of what i am talking about.
#1 is the air/fuel mixture, #2 and #3 are cold and warm idle screws.
#4 is a A/c idle adjustment.
Posted on May 06, 2009
Tips for a great answer:
Jan 01, 2016 | Toyota Pickup Cars & Trucks
Jun 11, 2014 | 1987 Toyota Pickup
May 16, 2012 | 1983 Toyota Pickup
Sep 08, 2009 | 1983 Toyota Pickup
Jun 17, 2009 | 1988 Toyota Pickup
Apr 03, 2009 | 1988 Toyota Pickup
Feb 21, 2009 | 1988 Toyota Pickup
Jan 13, 2009 | 1984 Toyota Xtracab
Jul 27, 2008 | Toyota Pickup Cars & Trucks
287 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: