Question about 1995 Chevrolet Monte Carlo

1 Answer

Trasmission won't shift out of first,motor rpm increases car dont move

Transmission slips when shifting to 2

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

U may have a cloged fillter

Posted on Feb 18, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
junkman1249
  • 552 Answers

SOURCE: Engine RPM too high when transmission shifts. Bangs into gear.

check your fluid level when the car is warmed up

Posted on Dec 05, 2008

mrgreenz
  • 962 Answers

SOURCE: slight miss in engine, hard shift from 1st to 2nd long 2nd gear

Check both O2 sensor(s) and catalytic coverter.. P0420 means catalyst below threshold. Also check the sensor at the transmission and solenoid.

Posted on Feb 06, 2009

  • 1 Answer

SOURCE: 2001 impala will not shift into overdrive

your overdrive clutch hub has gone out/worn out.
It can be replaced or you could have the whole transmission re-built or replaced with a low mileage one from the salvage yard , etc at a lower cost..(which is what I did)
This is common on these trannys.

Posted on Jul 02, 2009

  • 179 Answers

SOURCE: Auto Transmission in 94 Chevy K1500 will not shift into 2nd gear

Hi, yes I just had the same problem and the clutch packs inside the transmission are slipping. I had to replace all the clutch packs as well as the bands. The parts for this job really aren't that expensive. you could get everything you need for less than 300 bucks. however labor is where they kill you. It's about a 10 hour job or maybe 12 depending on application. average shop rate 80 an hour you looking at 900 dollars labor plus parts. if your mechanically inclined and have tools you could take your time and do it yourself. you can buy a step by step DVD for your specific application. other wise I would call around to transmission shops. their is a slight chance it may also be your solenoid pack. the best way to confirm is to have a transmission line pressure test done. I hope this helps!

Posted on Jul 16, 2009

emissionwiz
  • 76846 Answers

SOURCE: my transmission wont shift properly rpm goes up too high

your trans is slipping from your discription or staying in a low gear, is the fluid burnt? have you tested the system control computer for transmission trouble codes?

Posted on Aug 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the transmission relay for a suzuki xl7 2002


my guess is car has transmission issues
not stated.
please dont ask for parts that don't exist.
post full symptoms for rational answers. or tests.
no power means???????????????????
1: TRANS SLIPS, means rpm rises but not road speed.
or dont shift
2: RPM does not rise, means weak engine,.
so that is first
3: or transmission does not up shift? period or name gears not attained or skipped.

Dec 29, 2015 | Suzuki Cars & Trucks

1 Answer

Why does my 1999 Chevy Blazer shift really hard into second gear without the RPM's increasing like the tranny's slipping?


Shifting hard broken modulator valve on the trany itself normally there a vacuum line connected to it

Mar 13, 2015 | 1999 Chevrolet Blazer

1 Answer

I just got a 2004 tiburon 6 speed 4 cyl why is it when i shift when pressing on the gas the rmps go up but dont pick up speed ??? help


This is bad news either way, whether you have a manual or automatic transmission. The transmission is slipping if it an automatic or your clutch is worn out if it is a manual transmission.
Assuming you have an automatic, is may be the transmission is slipping because the transmission is not quickly shifting gears.

If you transmission shifts using hydraulic valves, there may be hope. You can add a can of SeaFoam transmission oil or similar product that helps stuck valves move. If you have solenoids used to shift the transmission based on motor RPM and pressure sensors, you need to go to a transmission shop to run more complicated tests. In that case, go to someone who is familiar with your vehicle model.

Feb 12, 2015 | 2004 Hyundai Tiburon

1 Answer

2008 Jeep Commander running fine then slows. Then its won't shift or move over 30 mph. Engine light comes on. Code says chip in transmission needs replaced. Need a good & honest Transmission Shop


there is no chip in the trans. sorry.
check fuses.
then this time scan it and write down the DTCs errors numbers.
and post those, we cant guess these critical facts.

find any ASE shop, and get it checked.
they dont need to cheat you,there work load is near infinite.
no reasons at all.


no over 30mph, did the transmission up shift.?
is it stuck in 1gear. surely you can count the gears shifted?
if not , get a real mech.
if the transmission file the FSM stall test. then this it.
1: tranny RPM goes too high RPM (engine RPM) this is transmission slip.
2: RPM in drive, 1,2, or R, is too low below 1500rpm. STALLED.
this is weak engine. not trans.
see?

google stall test transmission. and read.
or read the FSM
or read same on alldata.com

Sep 16, 2014 | 2008 Jeep Commander

2 Answers

What causes 1996 Dodge Neon SOHC automatic transmission to delay or slip shifts?


that is a hum dinger, largest ever posted, in one shot.
very good.!
one word , the transmission slips. (never drive a slipping tranny)
overheat indicator.! that is key.
many newer cars will change the transmission shifting any time
the engine over heats.
and overheat wins over transmission , every time.
if the engine burns up, what good is any transmission.? nada.

solve overheat first.

slip or flare.
is when the engine RPM rises fast and the car dont go faster.
SLIPS.
and slipping burns up trannyclutchs and increases the damage. inside the transmission, dont do that. dont allow it,
park it and fix it.

on some tranny there is a temperature sensor that the TCM
watches and changes shift patterns based on AFT fluid temps.
and if the ATF fluid gets too hot , it takes actions. to keep the tranny from harm.

why not get a scan too and see what DTC errors there are..
DTC, engine overheate.
DTC< tranny overheat (caused by above)

Jun 14, 2014 | 1996 Dodge Neon

1 Answer

Saturn vue clutch


sounds like the clutch is slipping

Aug 25, 2017 | 2003 Saturn VUE

1 Answer

Define transmission slipping


The RPM of the engine goes up between shifts or more than the road speed when in a gear.
If the engine RPM is increasing but the road speed is not, the transmission may be slipping.

Jul 28, 2013 | 1999 Honda Passport

1 Answer

Rmp gage is not automatically shifting into next gear its just increasing to 3 & 4K RPM what could cause this?


it sounds like it is in safe mode it will start in 2 nd when it dose
you need to have it scaned

Jun 03, 2013 | 1998 Chevrolet Blazer

2 Answers

RPM issue when accelerating


Most chances that the clutch is weak

Nov 09, 2011 | 1997 Toyota RAV4

1 Answer

Hi, I have a 1999 Mercury Villager with the 3.3 Litre Nissan motor. Just recently my cousin replaced the timing belt, and distributor. When we got the van back it was having transmission problems. When you...


I would start by making sure the Trans Fluid level is correct. If the level is good, it sounds like your internal pressures are leaking down, and that is why it slips out of gear. Which means you have internal trans issue which would require the trans to be most likely removed and repaired.

Thanks Jay!

Jul 09, 2011 | 1999 Nissan Quest

Not finding what you are looking for?
1995 Chevrolet Monte Carlo Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...