Question about Jeep Grand Cherokee
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
If you have the same pulley arrangement that most 4.0 engines have that pulley is an idler not a tensioner. Your power steering pump has a pivot bolt, and a slide under the pump. You adjust belt tension using the pump.
Posted on Apr 05, 2009
SOURCE: How to Replace Thermostat
Drain the cooling system down a little bit. Remove the upper radiator hose and heater hose from the thermostat housing. Remove the two bolts holding the housing to the head. Remove the thermostat and clean off the old gasket. Install the new thermostat and gasket and reassemble. Top off the cooling system. Run the engine and check for leaks.
Posted on May 04, 2009
first, check that your oil level is full. Though it should not cause an overheat, oil does serve as part of the cooling system... Changing the oil should not have much to do with an overheating problem unless inadvertently the radiator, a hose or the cooling fans got damaged. Carefully check everything for leaks, make sure the cooling fans come on when hot.
After checking those things you will need to check the thermostat and the radiator for proper operation. If you do not have a blown head gasket one of these items are causing your problem. Before you ask...the water pump will work even when the seals are leaking or the shaft bearings are bad. If either of those two conditions exist the pump should be changed, otherwise it is not causing your problem.
Posted on Jul 15, 2009
Hello, I hope this info helps...(subytech1)...REMOVAL
In this engine, each individual spark plug is located under each ignition coil.
Theplugs may be cleaned using commercially available spark plug cleaningequipment. After cleaning, file center electrode flat with a smallpoint file or jewelers file before adjusting gap.
CAUTION: Never use a motorized wire wheel brush to clean sparkplugs. Metallic deposits will remain on spark plug insulator and willcause plug misfire.
Setting Spark Plug Gap - Typical
Check spark plug gap with a gap gauge tool. If the gap is not correct,adjust it by bending ground electrode. Never attempt to adjust gap bybending center electrode.
CAUTION: This engine is equipped with copper core groundelectrode spark plugs. They must be replaced with the same type/numberspark plug as the original. If another spark plug is substituted,pre-ignition will result.
Special care should be taken when installing spark plugs into cylinderhead spark plug wells. Be sure plugs do not drop into plug wells asground straps may be bent resulting in a change in plug gap, orelectrodes can be damaged.
Always tighten spark plugs to specified torque. Over tightening cancause distortion resulting in a change in spark plug gap or a crackedporcelain insulator.
Posted on Aug 07, 2009
Tips for a great answer:
Oct 06, 2012 | 1995 Jeep Grand Cherokee
Jan 08, 2011 | 2000 Jeep Grand Cherokee
Dec 14, 2010 | 2000 Jeep Grand Cherokee
May 17, 2010 | 2000 Jeep Grand Cherokee
Sep 30, 2009 | 2000 Jeep Grand Cherokee
Aug 18, 2009 | 2000 Jeep Grand Cherokee
Apr 22, 2009 | 2000 Jeep Grand Cherokee
Jun 20, 2008 | 2000 Jeep Grand Cherokee
12 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: