Question about Cars & Trucks

1 Answer

What makes the rear wheel lean inward on a '93 Buick regal?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 139 Answers

Well could be worn wheel bearings. if it is independent suspension, you may have bent an arm or beam on that wheel. Usually you can see by jacking your car up and going under there with a flash light. Hope that help a little God Bless :O)

Posted on Mar 21, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
StormStrikes
  • 104 Answers

SOURCE: how to replace a crank sensor on a 93 buick regal 3.8L engine

Im assuming this is the Series I 3800? If so, if you can email me I can send you some directions on the process. Its for a Series II 3800 but it should be similar. If you cant email me, post up and I'll see what I can do.

Posted on Dec 30, 2008

  • 1596 Answers

SOURCE: wHEEL ALIGNMENT 1999 BUICK REGAL LS

Easy Way to check and KNOW for yourself --- Look Under rear at Where wheels Connect see if it has a TIE ROD and See If it has struts of Shocks TIE RODS & OR Struts Take Alighnment Shocks do not


---------------Need more Info Hollar at me rejakwilson

Posted on Jan 16, 2009

salvidordali
  • 103 Answers

SOURCE: replace rear struts 1996 buick regal

Here is a link describing your strut replacement. Autozone also has free tool rental for the strut spring compressor if you need it. Thank you, and don't forget to vote. http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152800681ba

Posted on Jan 29, 2009

  • 232 Answers

SOURCE: 1996 buick regal 3.8L. Rear brakes loud thumping

Check for leaks in the brake lines and calipers or brake cylinders. If leaking have it repaired right away its not safe. Change the brake fluid, take the old fluid out add new fluid or have it professionally done.

Posted on May 13, 2009

  • 44 Answers

SOURCE: how to change the rear 3 spark plugs on a Buick regal LS 2002

You can try rotating the spark plug boot a little bit-not even a 1/4 turn-to break the seal between the plugand the boot. Then pull the boot wire off with a pliers on the metal boot shield. Once the boot has beet rotated on the plug, the shield helps to remove it.

Posted on Oct 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What makes the rear wheel lean inward on a 93 Buick regal?


Your rear springs are probably the cause. Over time the springs get weak and cause the rear to sag. If you have independent suspension, which the 93 does, it will cause the tires to lean in a little. This will also cause the tires to prematurely wear on the inside. I think that car has leaf springs not coil springs. Your shocks are probably shot also, but that would not make it sag, that would just make the car very bouncy.

Feb 10, 2014 | Cars & Trucks

1 Answer

I have a 93 buick regal but my front doors & rear


Well, the mirrors would be on the circuit with the courtesy lights. The door locks and windows would be on different circuits.
Why can't you unlock the driver's or passenger door with the key and open it with the door handle ?

Jan 22, 2013 | Cars & Trucks

1 Answer

How do you remove a 93 buick regal steering wheel to fix a turn indicator that wont turn off when the wheel returns to center?


REMOVE HORN PAD,TAKE OFF NUT.USE STERRING WHEEL PULLER,PULL WHEEL,MAKE SURE TO PUT BACK IN SAME POSITION!REMOVE WIRE PLUG,I TIGH AWIRE TO PLUG TO PULL NEW WIRE PLUG BACK DOWN COLEM WHEN PULL OLD ONE OUT.

Feb 16, 2011 | 1993 Buick Regal

1 Answer

CHANGE RT FRT WHEEL BEARING 1994 BUICK REGAL ...3.8.....FRT WHEEL DRIVE


You will have to remove the wheel,of course,remove the brake caliper,pads,and the brake caliper bracket,then the rotor,and any brackets holding the brake hose to get it out of the way.Then remove the large nut on the axle,and remove all the bolts holing the bearing assembly on the spindle,and tap it out ward,and make sure the axle stays put,do not let the axle come outward with the bearing,using a two by four to tap the axle inward toward the axle while removing the bearing assembly.If this was at all helpful,please rate,thank you.

Aug 20, 2010 | Buick Regal Cars & Trucks

2 Answers

Will 93 Grand Am wheels fit 93 Buick?


what model buick? if it is a front-wheel drive buick, yes it will fit.
If it is a rear-drive buick, then no t=it will not fir.

Aug 09, 2010 | 1993 Buick Century

1 Answer

93' Buick Regal, ''Anti lock brake light is on'', help plz!


need to know if 4 wheel disk brake or if rear is durm break

Mar 14, 2010 | 1993 Buick Regal

4 Answers

Is a '94 Buick Regal GS front or rear-wheel drive?


Better still find a peugeot 307 or a ford focus all with manual transmission,and a high fuel economy so the rag heads can drink crude and live in the desert and ride camels

Oct 25, 2009 | 1994 Buick Regal Gran Sport

1 Answer

WHEEL ALIGNMENT 1999 BUICK REGAL LS


Easy Way to check and KNOW for yourself --- Look Under rear at Where wheels Connect see if it has a TIE ROD and See If it has struts of Shocks TIE RODS & OR Struts Take Alighnment Shocks do not


---------------Need more Info Hollar at me rejakwilson

Jan 13, 2009 | 1999 Buick Regal

2 Answers

How to replace a crank sensor on a 93 buick regal 3.8L engine


Im assuming this is the Series I 3800? If so, if you can email me I can send you some directions on the process. Its for a Series II 3800 but it should be similar. If you cant email me, post up and I'll see what I can do.

Dec 29, 2008 | 1993 Buick Regal

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...